Question about 2002 GMC Envoy XL

Open Question

Pulled p0452 code and my 98 savana 2500 series 3/4 ton 5.7 litre van stalls

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 130 Answers

SOURCE: front wheel bearings loose on my 2005 gmc savana 2500 van

you can snug them tighten them by turning the tire as you turn tighten until it feel like you have drag then back off one turn then turn tighten till nut touches then 1/6 tunr put castle nut and cotter pin back on good luck

Posted on Feb 10, 2009

Ad
  • 290 Answers

SOURCE: my 1999 gmc savana van turns over but does not

could be a bad fuel pump, or fuel pump relay. they are having problems(a lot) with the ethanol in the gas on GM products.Fuel pumps sales are through the roof at parts house on GM's. Have a pressure check on your fuel system. That is probably it. Add a can of Seafoam to your fuel every 3000 miles to alleviate this problem.

Posted on Aug 28, 2009

  • 15371 Answers

SOURCE: spark plug gap

0.060

Posted on Feb 12, 2010

jturcotte
  • 8841 Answers

SOURCE: I had to replace the intake gasket on my 2002 5.7L

you will have to bring the #1 piston to TDC on it's compression stroke (use timing mark if there is one or probe the plug hole to see when it's all the way up). To do this, you have to either pull the timing cover to check the cam sprocket marks or pull the valve cover to watch the intake valve close ahead of the compression stroke. Then, with the piston at TDC, you get the distributor rotor to align with #1 on the cap when fully seated. OK?

Posted on Nov 06, 2010

  • 30 Answers

SOURCE: 1999 GMC Savana 2500 fuel

there is 2 one is for the evap fuel tank pressure sensor...and the other is the pump module...the module one should be 4 wires purple gray white and pink i think..just 2 of them are for the actual pump...run a test lamp on them...you should have power to it for 5 seconds ..when the key is 1st turned to the run position..thats the prime siglal to the pump..

Posted on Apr 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Identifying engine emissions parts for a 1977 gmc 1/2 ton California pickup


LIGHT DUTY. TRUCK. (SERIES 10-35). CHASSIS SERVICE. MANUAL. CAUTION. This vehicle contains some parts dimensioned in the metric system as well .... 3-Cab-Chassis. 4- Pickup and Van. 5-Panel. 6-Suburban. 7-Motor Home. 8 -U tility. SERIES. 1 44 TON. 2 %. 3 1. - MODEL YEAR. 7 = 1977for all. Series.
https://babasupport.org/routers/tp-link-customer-service/778

Feb 09, 2018 | GMC Cars & Trucks

1 Answer

How to fine the signal lights flasher on a 2000 GMC 3500 van


FLASHER

2000 GMC Truck Savana 3/4 ton Van 4.3L FI OHV 6cyl

The Flasheris located: Front seating area, driver side, under dash, below steering column, mounted in relay block

Aug 12, 2017 | GMC Cars & Trucks

1 Answer

How do I set timing 2002 savana 2500 5 litre


You cannot. That is all computer controlled.

Aug 31, 2013 | Cars & Trucks

1 Answer

Setting timing 5 litre 2002 savana van


Computer controls it, there is no setting you can change.

Aug 31, 2013 | Cars & Trucks

1 Answer

My 2006 gmc savana 2500 is losing oil pressure


Unless you have run it out of oil a few times. replace the oil pressure sending unit. I am assuming you have an eight cylinder in the van, so the sending unit is on the back, top of the engine. About 3" long and 1 1/4 " in diameter

Apr 24, 2011 | 2006 GMC Savana

1 Answer

1999 GMC Savana 2500 fuel pump wiring diagram the pump has 2 elect. connections (1- 4 wire and 1- 3 wire). 5.7 litre vortec auto trans


there is 2 one is for the evap fuel tank pressure sensor...and the other is the pump module...the module one should be 4 wires purple gray white and pink i think..just 2 of them are for the actual pump...run a test lamp on them...you should have power to it for 5 seconds ..when the key is 1st turned to the run position..thats the prime siglal to the pump..

Apr 22, 2011 | GMC Savanna Cars & Trucks

1 Answer

Sprak plug Wires Need To Be Installed Correctly


You have several RAM sub-models in here:
Normal 0 21 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Tabla normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} B1500 RAM Van
B2500 RAM Van
B3500 RAM Van
RAM 1500 1/2 ton 2WD
RAM 1500 1/2 ton 4WD
RAM 2500 3/4 ton 2WD
RAM 2500 3/4 ton 4WD
RAM 3500 1 ton 2WD
RAM 3500 1 ton 4WD

Chrysler Full-Size Trucks 1989-1996 Repair Guide
To avoid confusion, remove and tag the wires one at a time for replacement.


f160dd3.jpg


Fig. 1: 2.5L 4-cylinder Engine. Engine Firing Order: 1-3-4-2. Distributor Rotation: Clockwise


a1a8242.jpg

Fig. 2: 3.9L V6 Engine. Engine Firing Order: 1-6-5-4-3-2. Distributor Rotation: Clockwise


dc6748e.jpg

Fig. 3: 5.2L and 5.9L V8 Engines. Engine Firing Order: 1-8-4-3-6-5-7-2. Distributor Rotation: Clockwise


832c92e.jpg

Fig. 4: 8.0L V10 Engine. Engine Firing Order: 1-10-9-4-3-6-5-8-7-2. Distributorless Ignition


Hope helped with this (remember rated this help) Good luck.

Nov 06, 2009 | 1996 Dodge Ram

4 Answers

98 Saturn SL2 - Stalling issues


I had a problem with starts on my 98 sc2, did it twice only, but it would start up, shake a bit then shut down like it wasn't getting fuel, or a wrong mixture. Replaced the coolant temperature sensor and starts / idles like new now... goodluck

Jun 22, 2009 | 1998 Saturn SL

Not finding what you are looking for?
2002 GMC Envoy XL Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...