Question about Cars & Trucks

Open Question

2008 nissan sentra radio button broke

The ABC Preset plastic radio button broke the plastic clip fell into an unknown location and I cant fix it is there anywhere I can order something like this.

Posted by on

  • Matthew Steele
    Matthew Steele Nov 07, 2013

    I have the same problem. A clip broke off of a plastic radio button, and I am trying to find(without any luck) a replacement.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnjohn2
  • 5763 Answers

SOURCE: i need a fuse diagram for a 2002 nissan sentra

this is all i could find,the fusebox locations and fuse location #, but nothing about which fuse is which, i hope this will help,9064463.gifb2bc6d0.gif4587b25.giffac1af0.gifb6b500c.gif

Posted on Feb 17, 2010

chiquititas
  • 1010 Answers

SOURCE: 1996 nissan sentra

Find the big hose that comes out of the top of the radiator and follow it to the engine and that is where the thermostat is located. My advice is to be sure to get a factory thermostat and rubber gasket as it makes installation much easier. I have done it both ways and the factory one is easier to install.

Posted on Jun 29, 2008

  • 2 Answers

SOURCE: power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

Posted on Feb 28, 2009

  • 770 Answers

SOURCE: brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Posted on Jun 21, 2009

A3sthetix
  • 41 Answers

SOURCE: How do I change brake light bulb of Nissan Sentra 2008

Was able to complete this job successfully:
It's a little tricky to do without pictures, but I don't have any available right now.

  1. Access the trunk
  2. Remove the material covering the light. You'll need to remove the black pegs by lifting the centre part. A flathead screw-driver will help. There are 2 to remove -- one directly behind the brake light and another at the top of the trunk.
  3. Pull back the material to expose the brake light wiring and the metal frame of the car.
  4. There are 2 nuts / screws to remove near the entrance of the trunk. Both are about 4 inches apart and hold the tail light's cover in place. Remove both.
  5. Using a bit of force, you will be able to pull off the entire tail light from the frame of the car. This is done on the exterior of the car.
  6. Rotate the problematic light from it's housing (it should come off with ease) and pull it out of the socket. Brake light and indicator are a 3057K bulb.

Posted on Jun 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Oil dipstick broke and fell into tube. How do I remove it from the tube?


tubes are either held in place with a retaining bolt or are just pressed in the block
use a pair of multi-grips and a hammer to knock it out of the block or remove the retainer bolt

May 22, 2016 | 2004 Nissan Sentra

1 Answer

Radio nissan sentra


Check it for a good ground make sure they haven't tried grounding to the plastic somewhere

Mar 03, 2014 | Cars & Trucks

1 Answer

Radio preset button broke


I did some searching and came up "empty handed" also. It looks like you have 3 options; 1. Call a junk yard. 2. Go to a dealer and 3. If you are not set on keeping the original, install an aftermarket radio. Good luck!

Nov 07, 2013 | 2008 Nissan Sentra

1 Answer

I have a 2002 Nissan Sentra, and the ac works, the hot air works, just not when i turn it to defrost. I noticed that the light wont turn on for it lie it does for the temperature and the levels when I turn...


You may have a clip broken on the underside of the vent dial. Take the control unit out or at least get it in position to drill two very small holes and insert two very small screws into the metal clip where it fits over the cable in the back of the control unit. What has happened is the plastic broke at one end where the metal clip fits under the plastic.

Oct 29, 2013 | Nissan Sentra Cars & Trucks

2 Answers

WHERE IS THE CABIN AIR FILTER LOCATED AT IN A 2008 NISSAN SENTRA


Its usually behind the glovebox. take everything out of box, it should be easy to release the holds from the box so it hinges down. you'll see a cover with clip locks. release and remove.

Mar 02, 2011 | Nissan Sentra Cars & Trucks

1 Answer

I have a 2008 Nissan Sentra and want to change


Carefully remove the plastic panel from the left side of the center console next to the accelerator pedal. That will expose the heater coil and lower duct. Next to the accelerator pedal there is a long, slender cover that is removable. Pull down gently on the bottom to unsnap, rotate out, and remove from top hinge. The filter is there. Reverse operation to restore console.

Nov 21, 2009 | 2002 Nissan Sentra

1 Answer

After replacing a faulty battery in my Nissan Micra, the radio needs a code, which I have. I, however, need advice on how to register the code on the radio.


usually..... just make sure the radio is on and using the buttons for the preset stations punch in the code, after the right code is put in the radio will begin playing.

Sep 07, 2009 | 2005 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

696 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...