Question about 1996 Toyota Corolla

Open Question

How to clean suzuki celerio 2010 airconditioning system?

But if you disconnect the connector to the water temperature sensor radiator fan is working.

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Wolfman304
  • 720 Answers

SOURCE: 1995 Toyota Camry 4 cylinder runs hot

Hi,

Firstly, ensure you have the required 'mixture' of coolant/water (must have required coolant).

Second, I would recommend you re-test all the cooling system sensors again (make sure they're within specifications), in case a new one is faulty.

Third, ensure the new thermostat was of the correct temp setting (they all differ), so that it opens at the required time. Most cooling systems operate within 90 - 100degC.

Fourth, make sure the radiator (and associated hoses) aren't blocked.

If your temp gauge is reading higher than normal, but NOT in the danger zone...then this can be considered normal (especially if you've replaced with new components) and nothing to be concerned about.

However, if the temp gauge IS in the danger zone....then this suggests the coolant is not flowing through the cooling system properly.

If all above components test ok, then it's possible your water pump may not be pumping enough volume.

Cheers,

Posted on Aug 16, 2009

Testimonial: "I appreciate your help...Maybe I should just relace the water pump, that would be the last thing that I would need to replace."

  • 1565 Answers

SOURCE: Toyota Tazz 1300 2004 overheating - Have replaced

have you replaced the thermostat? This controls the engine temp

Posted on Oct 24, 2010

  • 184 Answers

SOURCE: The radiator fan comes on

No,there is usually another on the head or the lower edge of the radiator.Depends on the engine model it may not be in this cluster area but at the other end of head,and may be only single terminal head or 2 wire plug.Hope this helps or post engine and vehicle model numbers and I may be able to supply more precise location for you.I assume that the air conditioning is off as this will actuate fan also.

Posted on Mar 31, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 Toyota Celica - coolant spraying out of overflow, fan didnt seem to be going on. Smells like coolant, so dont think that it is the head gasket. Temperature gauge going up now, but not at first....


There is a fan coolant temperature sensor on the bottom of the radiator, it has an electrical connector on it, with the key on disconnect the connector, if the fans run constantly with the connector off replace this sensor.

Aug 19, 2011 | Toyota Celica Cars & Trucks

1 Answer

Radiator fans won't shut down


The fans are controlled by the Engine Coolant Temperature sensor mounted in the coolant hose at the top front of the engine. Disconnect the electrical connector and see what happens. Fans should not run. If that cut the fans off replace the ECT sensor.

The ECT sensor provides input to the Engine Control Module which controls the radiator fan ...Its usually the center sensor connector thats Grey..

Aug 06, 2011 | 1996 Jaguar Xj Series

1 Answer

97 transport 3.4 engine- New radiator, thermostat,temperature sensor, water pump and new low coolant level sensor. Temperature guage goes to 260 degrees but engine does not over heat. Bled air from cooling...


Check the operation of the cooling fans at the radiator. While idling disconnect the coolant temp sensor at the top left (drivers side) of the engine. It will be a 2 wire connector near the thermostat housing. When disconnected the coolant fans should come on immediately, if not you have an electrical issue with the relays or blown fuse. Check the fuses first in the underhood electrical panel. Next swap the cooling fan relay with an identical one next to it, if the fan works the relay is open.

Mar 30, 2011 | 1997 Pontiac Trans Sport

1 Answer

1993 Mercury Sable has a problem with engine fan not coming on sometimes when the temperature goes up. We have replaced the sensor for temp, water pump, radiator, and relay system($159). All of the above...


clean all connectors and take jumper wires from battery and connect to diconnected fan while moving the wires to determine which wire may be bad. Sensor may be higher temperature trigger or the cars temp sending unit may be misreading..

Aug 10, 2010 | 1993 Mercury Sable

1 Answer

I have a suzuki swift 993cc, have just put new thermostat in it but fan stays on most of the time and bottom radiator hose is cold.


There could be a block in the water drain ports. The place of the thermostat should warm up and if this is not happening then you must check on the water cooling system. The radiator, the water flow lines to the engine blocks and back to the radiator is needed. Once the engine is running the temp must develop on the engine and radiate . You can disconnect the tan for a while to see if the temperature builds up. Then reconnect to see if the fan works and cuts off when the radiator cools. If not check the water pump and for blocking in the radiator/engine water jackets. Chect this out. Good day

Aug 10, 2010 | Suzuki Swift Cars & Trucks

1 Answer

How to change the radiator fan?


Electric Engine Fan - Fan Switch

Removal & Installation
2.7L Engine
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Disconnect the electrical connector .
  4. Remove engine coolant sensor from coolant outlet tube .
To install:
  1. Apply thread sealant to sensor threads.
  2. Install engine coolant temperature sensor into coolant outlet tube.
  3. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  4. Connect electrical connector to engine coolant temperature sensor .

3.2L And 3.5L Engines
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. With the engine cold, disconnect coolant sensor electrical connector.
  4. Remove sensor.
To install:
  1. Install engine coolant temperature sensor.
  2. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  3. Attach electrical connector to sensor.
  4. Connect negative battery cable.
Removal & Installation
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Remove upper radiator hose.
  4. Disconnect cooling fan electrical connector.
  5. Remove cooling fan mounting bolts.
  6. Remove radiator cooling fan assembly from vehicle.

    f9d971c.jpg
    Fig. Removal and installation of the radiator fan-2.7L Engine shown
To install:
  1. Position radiator cooling fan assembly in vehicle.
  2. Install cooling fan mounting bolts. Tighten to 50 inch lbs. (6 Nm)
  3. Connect cooling fan electrical connector.
  4. Install upper radiator hose .
  5. Fill cooling system.
  6. Operate engine until it reaches normal operating temperature.
  7. Check cooling system and automatic transmission for correct fluid levels.

Hope helps (remember comment and rated this).

Jul 13, 2010 | 2001 Dodge Intrepid

1 Answer

One of my fan is not working 1999 Honda Accord


Which fan is not working, A/C or Radiator? Check fuses, if good disconnect fan plug, direct wires from battery to fan to check fan, if fan does not work change. If fan works check water temp sensor for radiator. A/C fan only comes on when A/C is switch on. Like wise radiator fan only comes on when water reaches a certain temperature.

Jul 05, 2010 | 1999 Honda Accord

2 Answers

MY '07 Saturn Aura is not blowing cold air, nor is the temperature gauge functioning... Not sure what to do..


Does the clutch on the AC compressor operate the compressor when AC is called for? If no, check the fuse and relay for AC operation. If it does operate the compressor, then the system probably has a freon leak which must be repaired and the system recharged with freon. Replace the water temperature sensor if the radiator fan(s) do not come on when the engine is hot. The fan(s) should also come on immediately when AC is selected. Hope this helps!

Jun 04, 2010 | 2007 Saturn Aura XR Sedan

2 Answers

94 cutlass supreme is overheating,all fluids are fine. I did have someone tell me i need 3 motor mounts replaced. could this be an issue of the car overheating?


Over heating can be caused by a faulty thermostat and or weak water pump and dirty radiator and old antifreeze or the radiator fan now working when at idle but should not over heat when driving. Service the cooling system if it has never been serviced before. Replace the thermostat, buy some radiator flush to clean out the radiator and heater core. Just follow the instruction and replace the antifreeze and make sure it's a 50/50 mix water/antifreeze. If you not sure how to mix it 50/50 you can buy them 50/50 premixed. Water boils at 100'C so you need antifreeze mixed with it but antifreeze does not have the same heat transfer as water so you cannot run 100% antifreeze cause it does not transfer heat fast enough and you over heat. Good luck and hope this helps. Keep me posted, Be glad to help, once you service the cooling system and your still over heating, then we look at the water pump.

Jun 16, 2009 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1996 Toyota Corolla Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...