Question about 1996 Toyota Corolla

Open Question

My toyota corolla gli 95 model radiator fan won't function automatically

But if you disconnect the connector to the water temperature sensor radiator fan is working.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
mastatech
  • 478 Answers

SOURCE: How difficult to replace Toyota Corolla '95

Its under where the top hose goes into engine, It is pretty easymake sure to get some forma gasket when putting back together

Posted on Mar 14, 2009

Ad
c17hydro
  • 2984 Answers

SOURCE: How difficult to replace 1995 Toyota Corolla radiator/thermostat

You can replace the radiator yourself, but why do you need to? The thermostat is on the engine. Follow the large hose that goes to the engine block....not the water pump. The thermostat is under that or sits on the top of the engine....looking for a pic for you!

Posted on Mar 14, 2009

Wolfman304
  • 720 Answers

SOURCE: 1995 Toyota Camry 4 cylinder runs hot

Hi,

Firstly, ensure you have the required 'mixture' of coolant/water (must have required coolant).

Second, I would recommend you re-test all the cooling system sensors again (make sure they're within specifications), in case a new one is faulty.

Third, ensure the new thermostat was of the correct temp setting (they all differ), so that it opens at the required time. Most cooling systems operate within 90 - 100degC.

Fourth, make sure the radiator (and associated hoses) aren't blocked.

If your temp gauge is reading higher than normal, but NOT in the danger zone...then this can be considered normal (especially if you've replaced with new components) and nothing to be concerned about.

However, if the temp gauge IS in the danger zone....then this suggests the coolant is not flowing through the cooling system properly.

If all above components test ok, then it's possible your water pump may not be pumping enough volume.

Cheers,

Posted on Aug 16, 2009

Testimonial: "I appreciate your help...Maybe I should just relace the water pump, that would be the last thing that I would need to replace."

  • 1752 Answers

SOURCE: 1990 Toyota Corolla - engine overheating, maybe

Blown head gasket, get it replaced.

Posted on Dec 23, 2009

  • 1565 Answers

SOURCE: 2004 toyota corolla no power to radiator fan

If the fuse is ok....try replacing the fan relay. under $6 at rockauto.com

Posted on Jul 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need the list of codes for a 1994 corolla


1.6 GLi COROLLA

DTC NUMBER TROUBLE AREA 12 clip_image001.gifRPM signal 13 clip_image002.gifclip_image002.gifRPM signal 14 IGN signal 16 ECT Signal 21 Oxygen sensor signal 22 Water temperature signal 24 Intake air temperature sensor 25 Air / Fuel ratio lean 31 Vacuum sensor signal 41 Throttle sensor 42 Vehicle speed sensor 43 Starter signal 52 Knock sensor 51 Switch COND

Sep 29, 2014 | 1994 Toyota Corolla

1 Answer

Where is the radiator fan relay switch for a 1997 toyota corolla


The temperature switch that turns the fan off and on is located at the bottom of the radiator and has an electrical connector on it.

Mar 13, 2012 | 1997 Toyota Corolla

1 Answer

Toyota Corolla 1995. Quality of air conditioner reduced when stopped (traffic light) or moving at slow speed (condenced city traffic) No problem on the highway. Checked freon gas and fan. Understand that...


Normal, the ac heat exchanger condenser need air moving across the fins to remove the heat. While moving in town the condenser isn't remove the meat that is building up the it's aluminum fins. Even though the vehicle uses an electric fan. The fan is used to cool the engine temperature. If you Toyota is equip-ed with automatic transmission. The electric fan will need to pull enough air to cool the engine temperature, automatic transmission fluid, air conditioner condenser, and maybe power steering condenser to cool the power steering fluid. Later model of vehicles/trucks are using different refrigerants instead R134A in which you Toyota uses.

The simples way to explain is the ac remove heat from inside your Toyota and this heat is removed by the refrigerants inside your ac in the car. To cool the refrigerant this coolant is removed to the heat exchanger condenser located in front of the engine radiator. So, while moving at 60mph there is enough air flow through the radiator, ac head condenser, and other aluminum heat exchangers. GB...stewbison

Sep 12, 2011 | 1995 Toyota Corolla

1 Answer

Radiator fans won't shut down


The fans are controlled by the Engine Coolant Temperature sensor mounted in the coolant hose at the top front of the engine. Disconnect the electrical connector and see what happens. Fans should not run. If that cut the fans off replace the ECT sensor.

The ECT sensor provides input to the Engine Control Module which controls the radiator fan ...Its usually the center sensor connector thats Grey..

Aug 06, 2011 | 1996 Jaguar Xj Series

1 Answer

Where can i find the thermostat, temperature sensor, relay of my 1.6 gli toyota corolla?


follow your top radiator hose all the way to the engine under the bell housing that hose connect to is where your thermostat is

Jan 24, 2011 | 1998 Toyota Corolla

1 Answer

95 toyota corolla 1.8 engine, cooling fan works but only when you disconnect the fan switch, or by pass the fan relay, it's not overheating, but it's causing the coolant to overflow the resivor. Replaced...


Check the engine main relay, the radiator fan relay no. 1, 30A CDS and FAN fuses, and the ECT (engine coolant temperature) sensor for proper function. For the ECT, there should be continuity when the engine is cold (200F).

Jan 12, 2011 | Toyota Corolla Cars & Trucks

1 Answer

How to change the radiator fan?


Electric Engine Fan - Fan Switch

Removal & Installation
2.7L Engine
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Disconnect the electrical connector .
  4. Remove engine coolant sensor from coolant outlet tube .
To install:
  1. Apply thread sealant to sensor threads.
  2. Install engine coolant temperature sensor into coolant outlet tube.
  3. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  4. Connect electrical connector to engine coolant temperature sensor .

3.2L And 3.5L Engines
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. With the engine cold, disconnect coolant sensor electrical connector.
  4. Remove sensor.
To install:
  1. Install engine coolant temperature sensor.
  2. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  3. Attach electrical connector to sensor.
  4. Connect negative battery cable.
Removal & Installation
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Remove upper radiator hose.
  4. Disconnect cooling fan electrical connector.
  5. Remove cooling fan mounting bolts.
  6. Remove radiator cooling fan assembly from vehicle.

    f9d971c.jpg
    Fig. Removal and installation of the radiator fan-2.7L Engine shown
To install:
  1. Position radiator cooling fan assembly in vehicle.
  2. Install cooling fan mounting bolts. Tighten to 50 inch lbs. (6 Nm)
  3. Connect cooling fan electrical connector.
  4. Install upper radiator hose .
  5. Fill cooling system.
  6. Operate engine until it reaches normal operating temperature.
  7. Check cooling system and automatic transmission for correct fluid levels.

Hope helps (remember comment and rated this).

Jul 13, 2010 | 2001 Dodge Intrepid

2 Answers

Fan not working on radiator its a 1991 toyota corolla.


Check for power to fan. it could be the sensor on the engine or if you have power, it could be the fan motor is bad.

Mar 06, 2010 | 1991 Toyota Corolla

1 Answer

Overheating in 1987 Corolla AE82 4 door sedan


Sounds like you need to bleed the air out of the radiator. If you already did that, there next thing might be a faulty coolant temperature sensor on the radiator or a loose connection from the coolant sensor to the radiator fan. The coolant temperature sensor turns on the radiator fan when it reaches a certain temperature.

1. Bleed the air out of the radiator.
2. Make sure the radiator fan is turning on.
3. Check for a faulty coolant sensor.

Good Luck.

Dec 27, 2008 | 1987 Toyota Corolla 2 Door

1 Answer

Radiator fan


it seems to be a relay or fuse. or the temperature sensor. it is usually on the radiator or the engine block.

Nov 20, 2008 | 1992 Toyota Corolla

Not finding what you are looking for?
1996 Toyota Corolla Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...