Question about 2003 Nissan Altima

Open Question

Where is the idle control valve on a 2003 nissan altima

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2003 Nissan Altima?

Where is the sensor placed on the car?

Posted on Oct 07, 2008

  • 1 Answer

SOURCE: 2003 Nissan altima alternator

how do yow remuve alternaotor on a 2003 nissan altima

Posted on Jan 05, 2009

  • 1 Answer

SOURCE: 2003 nissan altima heater blowing cold air

Replace your thermostat

Posted on Jan 23, 2009

  • 15 Answers

SOURCE: 1995 Nissan Altima Heater contorl valve location

HELLO THE HEATER CONTROL VALVE IS LOCATED AT THE REAR CENTER OF THE ENGINE COMPARTMENT BY THE FIREWALL

Posted on Mar 02, 2009

  • 242 Answers

SOURCE: the idle is too high at 1500 rpm on my 2003 nissan altima 2.5

yes turn down too around 900

Posted on Dec 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan altima SE 1999 2.4L my RPM it's always on 0.


ok so when its at o. do it run rough i think you should clean up your throttle body and your idle control valve the valve may be stuck and clean out your egr valve and the passage way in the pipe

Dec 12, 2015 | 1999 Nissan Altima

1 Answer

My 96 nissan altima dies at idle


Could be a dirty throttle body, vac leak, or a defective idle air control valve. The computer adjusts idle speed by controlling the amount of air entering the throttle body via the control valve.
Is the check engine light on ?

Dec 24, 2012 | 1996 Nissan Altima

1 Answer

94 nissan altima won't start and iddle after cleaning IACV valve


An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body. The cars computer or PCM (powertrain control module) receives information from various sensors and will output signals to adjust the idle air control motor in or out to adjust engine idle speed by controlling engine idle air. An idle air control motor can fail one of two ways, either the motor short circuits and stops working or the motor will develop high resistance and cause the idle air control motor to react slowly, either failure can cause the engine to stall at idle. When a trouble code scan is performed it sometimes won't always detect a failed or weak idle air control motor.

Oct 08, 2012 | Nissan Altima Cars & Trucks

1 Answer

I have a 2005 nissan altima, the service engine light came on, the tach ometer goes up and down, when pressing on the excelerator the car will jump, the service engin light came on, the code read speed...


Is the car idling high? It sounds like air control valve has gone bad..just a though. I know when a car isn't idling right, its usually that idle air control valve or a vacuum leak

Jun 17, 2011 | 2005 Nissan Altima

1 Answer

I have intermittent rough idle on my 2003 nissan altima. car shakes in gear at stop, mostly fine in neutral.


Replace the spark plugs, spark plug wires, distributor cap, and rotor. Next, check the idle air control valve and replace it if found faulty. If it still shakes, have the timing checked out

Jul 01, 2010 | Nissan Altima Cars & Trucks

2 Answers

2005 altima with 2.5 engine idles up and down in park put in gear it idles about 1100 what could be the problem


Is the check engine light on? Could be several things. TPS or Idle selonoid. A bad battery could also cause your problem.

Feb 07, 2010 | 2005 Nissan Altima

2 Answers

What is throttle control motor relay circuit for nissan altima 2000 . have a code of p1126


This is the electronic control module to keep the idle of the revs correct it also allows the correct amount of fuel to air mixture the car needs to run. some are called EGR some are ICV idle control valve

Jan 19, 2010 | 2000 Nissan Altima

Not finding what you are looking for?
2003 Nissan Altima Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...