Question about 2004 Chrysler Pacifica

Open Question

How to correctly install thermostat in 2004 pacifica

It continues yo leak

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 496 Answers

SOURCE: how does the thermostat fit properly in the housing

selectachapter.gif

Pacifica, 2003-2005
Removal & Installation

Print Here is how to do it,if it does'nt fit right make sure you have the right thermostat.


3.5L Engine


CAUTION Never remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system.
  3. Disconnect radiator upper hose from thermostat housing.
  4. Remove thermostat housing bolts.
  5. Remove housing, thermostat, and gasket.

    0996b43f80204be2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
    View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine

  6. Clean gasket sealing surfaces.

To install:
  1. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
  2. Install thermostat and housing to the intake manifold. Tighten the bolts to 105 inch lbs. (12 Nm).
  3. Connect radiator hoses and install hose clamp.
  4. Refill cooling system.
  5. Connect negative cable to remote jumper terminal

Posted on May 02, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

If a water pump in a 2004 chrysler pacifica with 3.5l is leaking would it run out right below the crank pulley


This is common water pump failure on the pacifica, the bearings start to leak.
Since it is ran off the timing belt it is very common for the coolant to eat away at the timing belt, once that belt breaks your engine is destroyed.
This is not a repair that is OK to put off, replace the water pump timing belt and tensioner

Sep 20, 2014 | 2004 Chrysler Pacifica

1 Answer

Pacifica has a gas smell inside car


On a 2004 Chrysler Pacifica, I found a plastic line connecting the fuel line coming from the tank to the fuel rail. This line was leaking . Because it was located very close to the HVAC system, that explained the gas smell inside the car.

Jan 28, 2013 | 2004 Chrysler Pacifica

1 Answer

How does the thermostat fit properly in the housing


selectachapter.gif

Pacifica, 2003-2005
Removal & Installation

Print Here is how to do it,if it does'nt fit right make sure you have the right thermostat.


3.5L Engine


CAUTION Never remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system.
  3. Disconnect radiator upper hose from thermostat housing.
  4. Remove thermostat housing bolts.
  5. Remove housing, thermostat, and gasket.

    0996b43f80204be2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
    View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine

  6. Clean gasket sealing surfaces.

To install:
  1. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
  2. Install thermostat and housing to the intake manifold. Tighten the bolts to 105 inch lbs. (12 Nm).
  3. Connect radiator hoses and install hose clamp.
  4. Refill cooling system.
  5. Connect negative cable to remote jumper terminal

May 02, 2012 | 2004 Chrysler Pacifica

1 Answer

I have 2004 pacifica. Heater not work, only cold air comes out. Inside windshield were frosted and I found water on bottom of inside of air filter on passenger side seat. Please, tell me how to fix it.


Heater core may be shot, not letting the coolant flow through correctly causing a leak, how's the engine temp? If it stays too high could be a water pump issue

Dec 12, 2011 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica and my blower is blowing only cold air. The heat does not work.


Tenia, the most likely cause is that you are low on engine coolant. The coolant from the engine also runs through your heater coil. Check the coolant level when the engine is cool. There is a line in the coolant resevoir that says 'Cold Max'. Add the premixed coolant until you reach that line.

If that works, I would monitor the coolant level over the next few days. If it drops again, you likely have a coolant leak somewhere.

Dec 05, 2011 | 2004 Chrysler Pacifica

2 Answers

How do i check the thermostat on a 2004 pacifica


Start the engine (cold start) until 'warm'. Turn off the engine and check the hoses. If one hose is cold then the coolant is not circulating. You may have a bad thermostat. If your radiator fan turns on and off it is also a sign of the thermostat. Otherwise check for leaks it may be a bad water pump.

May 16, 2011 | 2004 Chrysler Pacifica

1 Answer

Chrysler pacifica 2004 overheat water boiling, y change the thermostat still same, what next step?


you may want to flush the system.........If you have an air lock in the sistem would also cause this problem.........I would also change the temp sensor.Hope this helps.

Sep 04, 2010 | 2004 Chrysler Pacifica

2 Answers

2004 pacifica radiator overheats every couple


A fan is on or off not slow do any fans in your house run slow because they are old?Your thermostat fan or temp sensor is bad

Jun 27, 2010 | 2004 Chrysler Pacifica

1 Answer

Chrysler pacifica 2004 windshield


Did you find the solution, git 1945? I am having the same problem. It leaks down into my front passenger floor board.

Jun 21, 2008 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...