Question about 1998 Dodge Ram 1500 4WD

Open Question

How to change out a neutral safety switch on a 1997 Dodge Ram Van 2500 series?

How to change a neutral safety switch on a 1997 Dodge Ram Van-2500 series.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
mrgreenz
  • 962 Answers

SOURCE: hoe to Replace an alternator on a 1996 Dodge Ram Van 2500 3.9L V6

Remove negative battery cable.
Remove the electrical plug and wireing. Mark them.
Loosen the alternator pivot bolt.
Remove the bolt that attaches the alternator to the adjustment arm.
Rotate the alternator to loosen the drive belt and disengage the belt from the pulley. Be careful that any spacers that are used in mounting are kept with their original bolts. This will make correct reinstallation much easier.
While supporting the alternator remove the pivot bolt.
Remove the alternator from the vehicle.
Do the reverse procedure to install new alternator.

Posted on Feb 03, 2009

Ad
chryslertech
  • 115 Answers

SOURCE: Location of NSS(neutral safety switch) on 2002 Dodge Caravan

It is in side the trans on top of the valve body. Why do you think you need to replace it?

Posted on Mar 03, 2009

  • 176 Answers

SOURCE: water pump 1996 dodge ram van 318 2500

Before you remove the serp belt, loosen the clutch fan bolts from the water pump. Other wise you will be fighting with them later. Other wise just drain the coolant and remove the pump. I would suggest a new thermostat since the coolant is drained. Make sure the block surface is cleaned of all gasket material and other dirt before installing your new pump. I usually scrape the area with a putty knife and wipe it down with some brake clean on a rag.

Posted on May 20, 2009

garputo22
  • 127 Answers

SOURCE: need to reset the fuel pump on a 1997 dodge ram van

The only way to reset the system is to disconnect battery cables for 10 minutes and before connecting the cables touch together to completely make sure there is no power left in the system

Posted on Jun 06, 2009

  • 166 Answers

SOURCE: need a spark plug wiring diagram 1997 dodge ram 2500

googel it

Posted on Jun 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van will just turn over and not start. could that be the neutral safety switch?


No your neutral safety switch wont let you tun over the engine, try putting a small amount of gas down the intake, if it starts after that your fuel pump may be bad.

Nov 08, 2013 | 1997 Dodge Caravan

1 Answer

Shift position indicatior light on dash


Your Neutral Safety Switch or PRNDL Switch needs to be adjusted

Apr 12, 2013 | 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

1989 DODGE RAM 250 VAN/changed ****** it wouldn't startthan removed security system still wont start


the security could have had a kill switch, in which case you need to short or bypass, sorry so short and sweet...good luck questions just ask

Mar 30, 2013 | Cars & Trucks

2 Answers

Where is the neutral safety switch at on a 2004 ram 2500 4x4


It is a round threaded plug like switch screwed in to the side of the transmission. It will have a 3 pin wire connector attached to it....It looks like this..

http://www.am-autoparts.com/Dodge/Ram-2500-Truck/NeutralSafetySwitch/AM-19774199/527360.html

Aug 24, 2011 | 2004 Dodge Ram 2500

2 Answers

We have a 1997 Dodge 2500 Ram Van and air conditioner only runs on High setting. We were told the Blower Motor Resistor needs to be changed out. How do we locate where this is and what steps do we take to...


Hi there,

Before you start dismantling your interior dash, you should firstly confirm it is in fact the resistor. Otherwise, you could be making unneccessary work for yourself.

Have your vehicle diagnostics checked (Aircon system) first - this will tell you which circuit is having problems.
Once this is done, we can guide you from there.


Cheers,

May 13, 2011 | 1997 Dodge Ram

1 Answer

1997 dodge ram 2500 backup lights do not work. Changed bulbs but don't work. How do I fix it.


check fuses.then check the reverse lamp switch if it is a manual transmission.jump the 2 terminals on the wiring harness for the back up lamps.if they lit up you know the switch is faulty.

Nov 18, 2010 | 1997 Dodge Ram 2500 Club Cab

1 Answer

Courtesy lights won't come on dodge 2500 ram van 1997


Turn the headlight switch anti clockwise until you hear a click

There is a feature to disable the interior lights when the doors are open for camping. (Turn the switch fully clockwise).

Dec 26, 2008 | 1997 Dodge Ram 2500 Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...