Question about Cars & Trucks

Open Question

How do you disable tyre pressure sensor display on megane mk2

Sensors have been removed but still show astyre pressure failure on dash

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: fault code 0562.oil level sensor

You have two sensors that could cause the light to go on. The oil pressure sensor and oil level sensor. Both are easily replaced by someone relatively OK with cars (DIY). You would want to spend the $100 or so and have the dealership do a full diognostic to verify if its truly the sensor and which one. In my case, same problem, and it has been verified that it was the oil level sensor.

Posted on Aug 30, 2008

Ad
alicantecoli
  • 22219 Answers

SOURCE: 202 cat error

where the rubber pipe joins manifold on engine their is a plastic fitting that the pipe fits onto ,if you look carefully you will see where the jubille clip and flantened it a bit ,thats your reading no doubt .if it runs ok ignore the fault codes,as a matter of fact iam surprissed you have evan managed to read it as its all encrypted software and it will show different codes to what it will show on a renault machine

Posted on Nov 25, 2008

alicantecoli
  • 22219 Answers

SOURCE: Tyre pressure sensor

its a renault ,what else do you expect ??renault electrics are a dealewr only job encrypted software

Posted on Jan 23, 2009

csmock132
  • 4669 Answers

SOURCE: oil pressure gauge is showing max pressure. Figure that sensor is bad???

I agree with you, replace the oil pressure sending unit.

Posted on May 07, 2009

  • 1 Answer

SOURCE: RESET TYRE PRESSURE SENSOR ON LAGUNA COMPUTER

I had a new sensor fitted recently at a tyre centre, but after driving home one of the rear tyres disappeared off the display! I had them reset the whole system only to find it happened again soon afterwards. Just looked at the fuse panel (right hand side on UK cars, at end of dashboard), no 'reset' switch. However, I did pull out a few fuses to see if that worked. By pure luck, there is a fuse with a strange name (can't remember it now) that is like disconnecting the battery completely (it's a 10A fuse located 3rd down from the top). Plug it back in and hey presto, no more flat tyre warning light, and centre screen shows all 4 tyres correctly. Genius!!

Posted on Jun 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Has anyone replaced the cd/radio head unit on a 2006 Mk2 Renault Megane and been able to retain the steering wheel controls and in-dash display using a non Renault radio? Pretoria/Centurion-S.A. area.


I have a 2004 Mk2 Scenic and when I bought it 18 months ago it was fitted with a non-Renault unit and that worked from the control stalks and showed up on the dash. I removed it and fitted the original unit back in as the previous owner wanted to keep the one that was fitted. I can't remember the make other than it was an expensive one. It was a straight un-plug the fitted unit and plug in the old one. No new wiring needed, so I am guessing that as long as you use the fitted plugs then the controls should still work. I hope that is of some help.

Jan 11, 2016 | 2006 Renault Megane 2.0

1 Answer

Im looking for a tyre pressure sensor for my renault laguna 2033 plate but not sure what im looking for or how to fit one thank you


1. The tyre has to be removed to fit the tyre valve/ sensor unit to the wheel. . Tyre dealers will do this for you when you supply the sensor.

2. Any renault dealer parts department can sell you a new sensor.

3. The new sensor has to be programmed to the car's tyre pressure monitoring system (TPMS).

3. Here is a list of information about the Renault Laguna tyre pressure sensors to assist you. The 2nd link below shows a picture of the tyre valve/sensor unit that fits to your wheel.

http://www.petercoopercarrepairs.co.uk/renault_laguna_mkii.htm

Renault Laguna Megane Tyre Pressure Sensor World Car Parts Store

Jan 07, 2016 | Renault Cars & Trucks

1 Answer

2000 toyota corolla could you please tell me what the symbol on the top left hand side of dash looking like a tyre section with arrows in it means. thanks Noel


Sounds like you have tire pressure sensors installed in the vehicle and one of the tires is low on pressure or the sensor is malfunctioning. This will also be displayed if you have the spare or a rim that doesn't have the sensor installed on it since the rims used on vehicles with this technology are special rims and the spares are usually not equipped with the sensor to save money.

Apr 20, 2011 | Toyota Corolla Cars & Trucks

1 Answer

When I start my 2002 laguna privilege it says tyre pressure sensor not functioning i have tried taking the fuse out it was ok for 5 mins and then started doing it again and only has 3 wheels showing on the...


The problem is with the tire pressure monitoring system as this one is that they are not lifetime built I believe that the battery installed on the sensor has died and must be replaced with a new sensor and therefore a procedure that needs to be carried out when replacing the sensor, certain calibration and so on, Also you can't just swap tyres around because each tyre is programmed to a certain position which if done well just give a wrong indication of the tire pressure on your dashboard.

Apr 03, 2010 | 2003 Renault 181

2 Answers

Air pressure sensor


It sounds ike one of your wheel sensors is faulty. These are part of the valve on the wheel rim where you add air to inflate. The only way to replace this is to remove the tyre. Your best bet is to take it back to your local main dealer as they are fully equipped to deal with such issues.

Apr 13, 2009 | 2003 Hummer H2

2 Answers

Tyre pressure sensor


its a renault ,what else do you expect ??renault electrics are a dealewr only job encrypted software

Jan 19, 2009 | 2006 Renault Le Car

1 Answer

I have a CLK200 Convertable with tyre pressure warning on


The light is coming on because ither your tires need to be checked for an under inflated tire, or your pressure sensor inside your tire is bad. Any major tire shop should have a reader to tell if you have a faulty sensor. Your tire pressure that the factory reccomends should be located on your driver's door or door frame on a sticker tag.

Dec 14, 2008 | 2000 Mercedes-Benz CLK

1 Answer

Sensor tyre for presure


When a Failure comes on in certain types of sensors it may just mean the sensor is at fault it may not mean Tyre pressure but check it anyway

Aug 11, 2008 | 2003 Saab 9-3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...