Question about 2007 Buick Park Avenue

Open Question

2001 Buick Park Ave. I'm having problems with the motor stalling when I stop @ a light, put it in park or driving on the freeway.

Posted by on

  • MrAl Jan 18, 2009

    I found that the problem was caused by bad map sensor

  • jason skovly May 11, 2010

    have you tried replacing athe fuel filter yet

×

5 Suggested Answers

  • 8 Answers

SOURCE: 91 buick park ave.

Well, that can be a ton of things. Usually it means: A. its not getting enough air, or any air. B. Its not getting enough gas. It could be a problem with the Mass flow Sensor- which can be cleaned or replaced-, or maybe a bad fuel pump or bad fuel lines or something. Either way the problem sounds like it just can't run because it can't get enough gas.

Posted on Aug 16, 2008

honeymokey
  • 3113 Answers

SOURCE: 1991 buick park ave. security system set off,

Did you try the drivers door lock cylinder?

Posted on Jul 20, 2009

  • 1 Answer

SOURCE: 93 buick park ave Ultra. replacing water pump

Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.

Posted on Aug 08, 2009

Testimonial: "answered the question completely and thoroughly!"

  • 743 Answers

SOURCE: temp sensor for 1991 park ave

It is in front of the radiator, right below the latch on the hood.

Posted on Oct 17, 2009

  • 1 Answer

SOURCE: 1998 Park Avenue: where is the fuse box on a 1998 buick park ave?...

i have a 98 buick park avenue
i got a problem running it. it start but when i hit the break pedal some light comes out the direction signal and it shuts off i check all the fuse

Posted on Aug 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 park ave ultra is hesitatating when I start using the gas as I start an incline mostly but sometimes just randomly an it's getting worse


Engine Stalling Due to Mass Air Flow/Crankshift Position ...

repairpal.com > Problems > Buick > Park Avenue
Buick Park Avenue Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor Failure. This is a verified ... 1997 Buick Park Avenue- 3.8L V6160,000Visitor. Engine stalls ... car runs then stalls and won't start for thirty minutes. Upvote (36).

Buick stuttering Questions & Answers - Fixya

www.fixya.com > Forum > Tags > stuttering
94 Buick Park Avenue that stutters under a light load I have a 94 Buick Park Avenuethat ... Buick Century 97 runs rough and stutters when cold and gas applie Engine runs rough ... I have a 1994 buick lesabre it starts ok but stutters and stalls.

Oct 30, 2015 | Cars & Trucks

1 Answer

Buick Park Ave Lighting/Electrical Problem


the common system problem look like the headlights switch
and cluster back bulbs .... remove front panel cluster and remove headlight switch look for burn wire or connector terminal. test light
fuses all
hope it helps

Mar 22, 2014 | 2001 Buick Park Avenue

1 Answer

2001 buick park ave stalls on first turn of key then starts on second


could be a weak fuel pump or a plugged fuel filter try a new fuel filter first

Oct 03, 2012 | 2001 Buick Park Avenue

2 Answers

My 1993 buick park ave stalls when stopped at red lights


When was last "healthy" tune up? Plugs, wires, ALL filters including FUEL filter? I'd start there, and run a good fuel system cleaner w/next tank full of fuel. In winter, with fluctuating temps, condensation (water) forms in fuel tank and spark plugs don't burn fuel/water efficiently causing stumbling and premature wear on your plugs.

Feb 27, 2011 | 1999 Buick Park Avenue

2 Answers

1991 BUICK PARK AVE. 3800 SERIES


I would seriously have a cat put back on you need that back pressure and have the O2 sensors replaced. Sounds like it may be time for a major tune up

Jul 10, 2009 | 1991 Buick Park Avenue

1 Answer

1993 buick park ave will not change gears


Have your Catalytic Converter checked for free flow, (if it is stopped up with calcification from unspent fuel, then the car will have trouble moving at all). A tell tale sign of oncoming Catalytic Converter problems is the overdrive balking or wanting to hesitate, when the transmission is in overdrive the vehicle is running at its lowest r.p.m. and so like at idle it will stumble or hesitate, or cut the engine altogeter, for the motor has to be able to exhale, to exhaust its combustion gases, in order to run properly, stopped up catalytic converters are a big problem with this car.

Apr 16, 2009 | 1993 Buick Park Avenue

2 Answers

1995 Buick Park Ave. Brake light remains ON and chimes on driving


The problem is the car think the park brake is on (intermittently). I would check the park brake switch, perhaps it's loose, or perhaps the park brake is pushed down to the first "click" spot. Also check the wiring connection to the switch, and the wiring nearby. Good luck!

Dec 13, 2008 | 1995 Buick Park Avenue

2 Answers

Temp sensor for 1991 park ave


I have a 1991 buick century that keeps stalling but starts right back up but know it wont start at all

Jun 19, 2008 | 1991 Buick Park Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...