Question about 2001 Toyota Camry

Open Question

2001 toyota camry signal light is not working

Already put new bulb but still not working

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: 1998 toyota camry interior dome light replacement

Look closely at the cover. You will see a small slot. Insert a small flat blade screwdriver, and pry it off. Very easy..

Posted on Nov 10, 2008

Ad
localwonder
  • 6784 Answers

SOURCE: 2000 toyota camry turn signals not working. Fuses

Hi, i recommend testing the switch and flasher module. i will post the testing procedures for both devices. replace the device that is faulty.

To test turn signal switches, use a 12-volt test light to probe for voltage into and out of the switch. The ignition switch must be in the RUN position for the circuit to operate. If voltage is present on the input side of the switch but not on the output side, the switch is faulty.

FLASHER TEST PROCEDURE---

  • A test light can be used to determine which flasher is used for the turn signals and which is used for the hazard warning light.
  • An easier way is to turn on both the directionals and the hazards. This activates both flasher units.
  • By removing one of the flashers, the affected circuit no longer flashes.
  • Therefore, that flash unit controls that particular circuit.
  • If the turn signals fail to operate and the fuse is good, the flasher has probably failed.
  • Occasionally, the flasher does not flash as fast as it once did, or it flashes faster. This is also cause for replacement.
  • If it flashes too slowly or not at all, check for a burned-out bulb first.
the flasher is located in the Front seating area, driver side, driver side of steering column, mounted in corner behind instrument panel

If the turn signals operate properly in one direction but do not flash in the other, the problem is not in the flasher unit. A burned-out lamp filament will not cause enough current to flow to heat the bimetallic strip sufficiently to cause it to open. Thus the lights do not flash. Locate the faulty bulb and replace it.

Posted on May 19, 2009

  • 1 Answer

SOURCE: 2001 Camry code po440,po441,po446 after engine

2001 camry code po440,po441,po446
what kind of problem and how can be solved
sam

Posted on Jun 30, 2009

  • 1861 Answers

SOURCE: 2003 Toyota Camry - Both Brake lights not working

Lok in the trunk on the left side, behind the carpet for a small plastic box with a bunch of wires going to it. Look to see if there is brake light powe coming in with the pedal depressed. If so, and no power is coming out, you need to order and replace the "taillamp failure sensor".

Posted on Jul 16, 2009

  • 1986 Answers

SOURCE: How to change a third brake light bulb for 1993 Toyota Camry?

open the trunk and look up along the top of the bumper and you should see two screws / nuts that secure the light assembly.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do the brake lights and blinker use the same bulb on a 2004 Camry


if the signal light is not separate(different colour) from the brake lights then they are different bulbs. if they use the same bulb then it will not work either on brake or signal.

Aug 23, 2014 | 2004 Toyota Camry

3 Answers

How many bulbs on my 2001 camry dashboard?


I believe there are 6 general illumination bulbs plus 1 for each paticular warning/signal/trans signals-about 16 or so total

May 25, 2014 | 2001 Toyota Camry

1 Answer

98 toyota camry blinker lights not flashing?


if they are coming on and not blinking sounds like the turn signal switch might be bad.

Dec 20, 2012 | 1998 Toyota Camry

2 Answers

How do I get to the front headlight to change it


Re: Replace headlight bulb

  1. INSTALLATION GUIDE:
  2. BMW E38 99-01 HID TYPE 7 Series 1PC Halo Amber Projector Headlights
  3. Parts Identification:
  4. Projector Headlight
  5. Halo & L.E.D.
  6. Bottom of the Headlight:
  7. Ballast Bracket, Halo Wires(red/black)
  8. Turn Signal Adaptor
  9. TOOLS REQUIRE
  10. 10mm - 8mm socket
  11. Philip Screwdriver
  12. Crimper/Pliers
  13. For more information about how to install your vehicle, come visit our youtube page on
  14. http://www.youtube.com/spyderauto
  15. Remove the facotry headlight from the BMW. First remove the front panel cover below the headlight to access the bottom screw of the headlight housing. There is also two screws on the top of the housing.
  16. Once you have remove the headlight, turn the headlight around and remove the bracket that holds the Ballast. Then remove the ballast using a philip screwdriver.
  17. Unplug the wire from the ballast, and then remove the Xenon Plug from the housing. Put the Ballast aside.
  18. Carefully remove the D2S Xenon Bulb from the factory housing. Once you have remove the bulb, transfer the bulb to the Spyder headlights.
  19. Remove the bracket from the Spyder Headlight, and then install the ballast on the housing like the original. Once you have put the ballast on, put the bracket back on.
  20. Remove the Panel Cover bracket from the original headlight to the new Spyder Headlights as shown here.
  21. STEP:
  22. Install the Spyder turn signal socket if the orignal does not fit, unplug the factory plug from the harness and plug the new one on.
  23. Install the Spyder Headlight back on to the vehicle. Plug the Harness back on, the halo/L.E.D. Wires is connect to the Parking lights. These wires are optional to your vehicle, you do not have to wire them together.
  24. Factory Xenon Headlight
  25. Spyder Projector Headlight using Factory Xenon Lights
  26. STEP:
BMW e46 HID Headlight Replace
get-front-headlight-change-afy5cnsznmokzumyhdcbeseq-5-0.jpg

get-front-headlight-change-afy5cnsznmokzumyhdcbeseq-5-2.jpg

Nov 22, 2012 | Cars & Trucks

1 Answer

Tail lights work but not brake lights 93 toyota camry


The brake light side of the bulbs is powered by the brake switch and travels thru the turn signal switch.
If the third brake light works, I would guess the problem is in the turn signal switch.

Jul 02, 2012 | 1993 Toyota Camry

1 Answer

Why taillights will not work when I turn my lights on. However they work when I brake so i know it is not the light bulbs. Also my turn signals do not work even though my hazards do.


Tail lights and brake lights are two seperate things . There are different bulbs for each. When you put your lights on does the front parK lights com on ? Usually the are on the same circuit as the tail lights. Check for fuse first.

Oct 22, 2010 | 2001 Toyota Camry Solara

1 Answer

Need help for 2001 Toyota Carmy brake lights- The brake light bulbs were replaced a couple of times in less than a month, but the brake lights still don't work. I was told by others that it could be a...


Do the rear running lights work, and turn signals??? Look under the dash behind the brake pedal there is a senor and wires, make sure they are plugged in. When you push the brake pedal it hits the sensor and turns the brake lights on. Check that. Sometimes your feet can hit the wires when getting in and out of car..

Oct 07, 2017 | 2001 Toyota Camry

3 Answers

2002 Toyota Camry with the P1135 DTC coming up.


2002 CAMRY MY ENGINE LIGHT CAME ON - THE DEALERSHIP SAID IT WAS A PO171,P1130,P1135 DO I HAVE TO GET IT FIX. 448.00 IT WILL COST

Aug 17, 2009 | 2001 Toyota Camry

1 Answer

2001 Toyota Avalon - Rear signals


Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

Aug 02, 2009 | 2001 Toyota Avalon

1 Answer

In my 1991 toyota camry v6 engine the rear lights don't work; I put on new light bulbs and still won't work. what's the problem?


check the Fuse Box, and also the Ground Wire, in Raer, if Bulbs are new that should solve problem? if not check for a broken wire with a Volt Meter,

Jun 03, 2009 | 1991 Toyota Camry

Not finding what you are looking for?
2001 Toyota Camry Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...