Question about 1997 Nissan Quest
The starter drive is going in it, You will have to get a different starter for it,
Posted on Dec 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Go to Auto Zone, get a Haynes manual on this vehicle. It will tell you where it's at and also help you with future problems.
Posted on Jan 07, 2009
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
Posted on May 09, 2010
SOURCE: 1997 Nissan Quest wont start
If you tried jumping it and it still doesn't start, then it's not your battery. There may be a problem with the solenoid/starter. Try tapping the starter a few times with a metal object (tire wrench or something), but not too hard. Then try starting it again.
Posted on Oct 30, 2010
My guess would be a switch (park interlock, brake interlock, etc.), a main fuse (located under the hood), or a starter solenoid. One easy check is to turn the key to start and simultaneously wiggle the shifter or pull it in to the Neutral position.
Posted on Apr 23, 2011
Hello and welcome to FixYa!
When a/c is operated, it gives a great load to the engine. Under stress the water pump may not work properly. If that's the case the water pump must be replaced to prevent the overflowing of coolant plus it will give you better coolant circulation.
One cause of overflowing too is when you overfill the reservoir. If the coolant on the reserve is above the maximum level it may overflow for the coolant has no place to breath. Try to fill the reserve on the max level and observe how it goes.
If the problem still fails, I suggest that you go for the water pump replacement for I believe it's worn out.
Hope this helps and thank you for using FixYa! Have a good one!
Posted on Aug 25, 2011
Tips for a great answer:
Apr 05, 2017 | 1997 Nissan Quest
Oct 30, 2012 | 1997 Nissan Quest
Apr 23, 2011 | 1997 Nissan Quest
Mar 02, 2011 | 1997 Nissan Quest
Jul 26, 2010 | 2004 Nissan Quest
Jun 22, 2010 | 1997 Nissan Quest
May 09, 2009 | 1997 Nissan Quest
Jan 07, 2009 | 1997 Nissan Quest
112 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: