Question about Cars & Trucks
Where is it located in a mercury coagar rx7 1997.and is there any where I can get a diagram
The switch is located under the hood of the vehicle and is attached to the brake master cylinder and wired to the cruise control.
NEC Dash Programmer ECU Flasher
Posted on Dec 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I just got done replacing the O2 sensors in my 99 Cougar due to throwing a P0135 malfunction code. There's 3. Facing the engine there's one in the front coming off of the front header, which is easy to get to. Another more tricky one if between the engine and the fire wall on the rear header pipe. The third is under the vehicle behind the transmission pan on top of the exhaust. In order to replace the O2 sensor near the fire wall you will need to remove the 4 retaining bolts for the ECM module and move it out of the way. Additionally you will need to remove the 2 retaining nuts for a wiring harness that is seated below the ECM module. Pay close attention to the connectors because the front and under vehicle O2 sensors have round connectors the one near the firewall has a squared connector. I was able to replace all 3 by myself in approximately 35 minutes. If your throwing a O2 heater malfunction code it is most likely going to be the sensor near the firewall. make sure that you know someone with a code reader so the code can be cleared. If you're do for an emmissions inspection be sure to put at least 40 miles on the new O2 sensor with different types of driving (e.g. highway, coasting, decellerated turns and rapid acceleration). Gotta love project cars for your kids!!
Posted on Apr 04, 2009
It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.
Posted on Apr 08, 2009
Tips for a great answer:
Oct 15, 2016 | 1994 Mercury Villager
Oct 29, 2015 | Mercury Cars & Trucks
May 29, 2014 | 2005 Mercury Monterey
Nov 27, 2011 | 1991 Mercury Cougar
May 26, 2011 | 1992 Mercury Cougar
Nov 09, 2009 | 1988 Mercury Sable
138 people viewed this question
Usually answered in minutes!