Question about BMW Z4
The drivers door latch is locked in a position that stops the door closing. I went to the passenger side and just poked the latch with a screwdriver and now that will not close either! Basically, I have 2 doors open and cannot close them either with the key in the drivers door or with the buttons on the key or in the car
If you push on the mechinisim you were fooling around with on the oter door, The bottom bar on the mechinissim push it donwards it should realese it then , Or evan ueing the key end turnig it back end forth should release it,
Posted on Dec 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
pull the outside handle and unlatch the latching assembly by hand by insertins a screwdriver where the striker would normally be if the door were closed - and pry out.
You can adjust the striker by loosening the bolts, and moving it in toward the cabin.
If the door itself is droopy, adjustments are made by the hinge by loosening the bolts and lifting up or down.
Multiple attempts will be necessary to get it just right.
Dont get frustrated if it doesnt fit properly in the 1st or second attempt.
Posted on Jan 16, 2009
SOURCE: door ajar light stays on
go to your local parts store and buy a can of PB BLASTER lubricant then open each door and spray the latch assembley really good then close and open the door 10 to 15 times. do this with each door. the door ajar light switch is located in the door latch assembley and cannot be seen so soak the latch assembleys really good so lube reaches the switch. these switches sometimes get stuck but this usually frees up the switch
Posted on Mar 25, 2009
put a screwdriver in the latch jaws and force it open
Posted on Jun 11, 2009
SOURCE: How to disarm car alarm
Most security systems on vehicles have a small single pole throw type switch located under the dash board area on the drivers side, whatever direction you find the switch set in flip the switch to the opposite side to disarm the alarm, this is called putting the alarm in a passive or valet type mode until you can have the whole system checked by a certified alrm install facility that deals with the type alarm you have in your vehicle.
Posted on May 09, 2010
Tips for a great answer:
Jan 04, 2013 | 2004 Mazda 6 Sport
Jan 01, 2012 | 1988 Chevrolet Corsica
Dec 13, 2010 | 1999 Ford Contour
May 02, 2017 | 1991 Nissan Pickup
Aug 16, 2010 | 1994 Toyota Tercel
Nov 05, 2009 | 1995 Pontiac Sunfire
130 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: