Question about Cars & Trucks
The crank position sensor is behind the harmonic balancer and cam position sensor is just under the power steering pump
Posted on Dec 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.
Posted on Jan 21, 2009
bring the piston no 1 on the top position check the cam shaft si moving freelyon the outer side of the shaft there are 2 gear with 14mm bolts and 1 extra whole, put a long bolt in the empty space and try to turnthe engine the bolt will go further in the space than the timming is set put the chain on that should do
Posted on Feb 08, 2009
CRANKSHAFT SENSOR - Under hood, center, front engine area, rear of crankshaft pulley, mounted in timing cover assembly.
CAMSHAFT SENSOR - Under hood, passenger side, upper engine area, mounted on engine in front of camshaft.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
Posted on Apr 08, 2009
The knock sensor is on the back side of the engine near the trans. It is round, with a 1 wire connector. You will have to get it from underneath. Good Luck.
Posted on May 06, 2009
Tips for a great answer:
Apr 12, 2017 | 1998 Chevrolet Malibu
Dec 06, 2015 | Cars & Trucks
Jun 02, 2014 | 1997 Chevrolet Malibu
A camshaft position sensor,or cylinder identification sensor is used to determin the engine cycle position the information is used to provide individual cylinder ignition and injection cotrol.Many engine mangement systems use an inductive type of sensor that is located near the camshaft;when the camshaft rotates a single signal is passed to the ECU to indicate a reference point in the engine cycle
May 03, 2011 | 2003 Chevrolet Malibu
Dec 22, 2010 | 1999 Chevrolet K1500
May 24, 2010 | 1998 Chevrolet Malibu
Dec 20, 2009 | 2001 Chevrolet Malibu
Jul 02, 2009 | 1998 Chevrolet Malibu
Jan 27, 2009 | 2003 Chevrolet Malibu
266 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: