Question about 2002 Mitsubishi Montero Sport

1 Answer

I have suction where i put oil in, when i remove the cap the car trys to stall what do I do? 2002 montero sport limited

The car is ideling up and down and a little oil started leaking, when I remove the cap where you put in oil the car trys to die, what is the problem please help

Posted by on

1 Answer

You don't add oil with the car running

You broke the vacuum for the crankcase evacuation
(PCV System)

If you have idle problems then they have to be diagnosed

Posted on Dec 06, 2012

  • mike woods Dec 06, 2012

    I didnt try to add oil we were selling the car and he noticed a little oil and he removed the cap while it was running and it tried to die it is suppose to do that? or is there a repair needed now?

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rockitman187
  • 2559 Answers

SOURCE: asistance to change the thermostat in a 2002 mitsubishi montero limited

Follow the top radiator hose down to the water outlet. The thermostat is inside the water outlet,Just remove the bolts,replace thermostat,replace gasket,bolt back in place.

Posted on May 28, 2009

jingB
  • 19 Answers

SOURCE: Mitsu Montero Sport '02 engine stalls but not when air cond is on.

hi there. the reason that the engine idles good when the air-con is engaged is that ussually all vehicles nowadays have a vacumm advance mechanism. this is triggered mainly by a electric solenoid valve which is also attached parallel to the source supplying power to compressor. a small vacumm hose with a diameter like a common pencil or ballpen case. its made of rubber and it runs from the alternator vacumm pump then to the solenoid valve and to the vacumm advancer unit attached to the injection pump throttle. this system raises the idle a tad higher.

if your montero runs completely normal and you experience no other problems with your engine except for your present problem, then the solution is just raising the idle a little higher. if your montero is equiped with a RPM guage on the dash, try adjusting the idle to around 800 rpms. it would be healthier for your car if the idle raises a bit when you engage the air-con because this would compensate for the added load on your engine.

hope this helps.

Posted on May 31, 2009

  • 1 Answer

SOURCE: radio code for 1998 mitsubishi montero sport

2742 try this code

Posted on Jun 07, 2009

  • 1 Answer

SOURCE: Mitsubishi Montero Sports will not start...

I HAD THE SAME PROBLEM. I TOOK THE AIR FILTER HOSE OFF THE CARBARATOR AND ADDED CARBARATOR CLEANER. PUT IT BACK ON, AND WORKED. TRY THAT.

Posted on Jun 29, 2009

  • 115 Answers

SOURCE: Alternater trouble Mitsubishi Montero Sport 2003

ck the alternator cable from alternator to battery...also ck maxi fuse...

Posted on Jul 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace rod bearings 2002 montero sport 3.5


If they are in good condition, why replace them? Replace them with the same exact size you remove from them. You do not have to go 20 over or 30 over unless you have the engine or crankshaft turned at a shop where they remove a small amount of metal to make the surfaces nice. If that happens, you would need to compensate for that metal removal by installing an over sized bearing. But the shop would also be required to inform you on what size if that happened.

I use a prerun grease that is black. really doesn't matter as long as it is thick enough to stay until your ready to start the motor. Don't forget to prefill your new oil filter with new oil. This will decrease the time that oil fills the filter and save milliseconds that could cause damage to new parts. Also, go to the auto store and buy a bottle of zinc additive for the first breakin period of the engine bearings. Zinc is a very needed substance in the oil for new engines. It will help protect your engine during break in period. I use the lucas brand and pour it in with the new oil. I also use Castrol oil because it keeps engine parts clean and I have used it all my life, (my preference only) Stick with the 30wt oils because they seem to have the better additives needed, but use the zinc on first 500 miles. Take your time with what your doing, any mistake will mean disaster in a very short time. I know by experience it doesn't take more then 25mph to seize an engine. Clean your passages also. Anything stuck in a passage will crash a motor faster then you can shut it off. Watch you oil pressure and be sure it comes up quickly when first starting. All that hard work your doing, you better check yourself over and over for mistakes.

May 22, 2014 | 2002 Mitsubishi Montero Sport

1 Answer

T came on and the engine stalled out. There was some bottom end noises and i had it towed home 300 miles. I took of oil pan and the oil suction screen was 90% clogged. At the time it overheated there was...


Oh my gawd, lol. Clean the screen and probably replace head gasket. Have head checked for flatness when removed because these Mitsubishi engines love to warp the heads when baked. Might as well pull the engine and work on it that way. Just go through and look for problems.



90% clogged? with what? I would think the filter would of caught the crap instead of the screen. Did you have the car at a mechanic lately, where they possibly could of done something to provoke that clog? . I have never heard one of them screens clogged up like that, EVER!

May 07, 2014 | 2002 Mitsubishi Montero Sport

1 Answer

MONTERO SPORT INTERMITTENT STALL


Check the IAC valve. my 01 montero did the same finally it didnt stay on unless on idle. small part but expensive.

May 26, 2010 | 2002 Mitsubishi Montero Sport

1 Answer

What is the best kind of oil to use in a 2002 Montero Sport?


I would recommend 10w30,but the main thing is to keep changing you oil every 3000 miles and keeping up with the oil level

Apr 14, 2010 | 2002 Mitsubishi Montero Sport

1 Answer

I have a 98 Montero Sport with low rpm engine stalls...


spark plug cable is lose or one spark plug is faulty.

Jan 24, 2010 | 1998 Mitsubishi Montero Sport

2 Answers

Mitsubishi Montero Sport 2002 Idle problem


the engine compensates for the load try turning up the idle screw also check the ignition system you might just need new wires and or cap rotor or your coil is bad also plugs

May 31, 2009 | 2002 Mitsubishi Montero Sport

1 Answer

Asistance to change the thermostat in a 2002 mitsubishi montero limited


Follow the top radiator hose down to the water outlet. The thermostat is inside the water outlet,Just remove the bolts,replace thermostat,replace gasket,bolt back in place.

May 28, 2009 | 2002 Mitsubishi Montero

3 Answers

Lifter sound in the morning


check your oil for low level or you probably
need valve adjustment

Apr 04, 2009 | 1998 Mitsubishi Montero Sport

4 Answers

Montero sport stalls at stops after battery change.


remove the cable again. Then when you start it allow it to idle for 20 mins in park.

Dec 27, 2008 | 1999 Mitsubishi Montero Sport

Not finding what you are looking for?
Cars & Trucks Logo

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...