Question about 2000 Dodge Durango

1 Answer

1999 dodge durango second gear winds out before shifting into third

It does it mostly when cold and will change when taking foot off the gas.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Cheek filter in transmission.

Posted on Dec 06, 2012

  • kjnk2 Dec 06, 2012

    I know there are a few different things to try; changing the filter was one, but also read that i could try the output sensor.or the throttle position sensor.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
rockitman187
  • 2559 Answers

SOURCE: 1999 Dodge Ram 1500 2WD won't shift properly

Sounds like the speed sensor on the rear axle.

Posted on Jan 20, 2009

  • 3 Answers

SOURCE: 1999 Dodge Durango not shifting

get your check engine light scanned it could tell you what is going on it might be the shift solenoid

Posted on Jan 26, 2009

  • 217 Answers

SOURCE: getting rear gears out of the difential case 1999 dodge durango

  1. Raise and support vehicle. Ensure that the transmission is in neutral.
  2. Remove wheel and tire assembly.
  3. Remove brake drum. Refer toBrakes, for proper procedure.
  4. Clean all foreign material from housing cover area.
  5. Loosen housing cover bolts. Drain lubricant from the housing and axle shaft tubes. Remove housing cover.
  6. Rotate differential case so that pinion mate gear shaft lock screw is accessible. Remove lock screw and pinion mate gear shaft from differential case
  7. Push axle shaft inward and remove axle shaft C - clip lock from the axle shaft
  8. Remove axle shaft. Use care to prevent damage to axle shaft bearing and seal, which will remain in axle shaft tube.
  9. Inspect axle shaft seal for leakage or damage.
  10. Inspect roller bearing contact surface on axle shaft for signs of brinelling, galling and pitting. If any of these conditions exist, the axle shaft and/or bearing and seal must be replaced

Posted on Feb 11, 2009

  • 1 Answer

SOURCE: all the sudden my 1999 dodge durango wont shift into reverse?

My 1999 Durango stalls when it’s cold and I shift into reverse. Once the motor is warm reverse works fine.

Posted on Apr 17, 2009

  • 1 Answer

SOURCE: Transmission won't shift from 1st to 2nd gear on it's own

Have someone scan the transmission for bad shift sensors.

Posted on Apr 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can't shift 2002 Durango into gear.


repair the selector system first then ask what to do

Oct 14, 2017 | 2002 Dodge Durango

1 Answer

1999 Dodge Durango, bucking at launch and loud whine.


all dodges have a bilt in code check, on my 94 caravan, i have to rev up the idle to approx 2300,for 10 seconds, turn off all accessories, put foot on brake in regular idle, put shift lever in all gears, go back to park, turn key on and off 3 times the third time leave in start position and watch the check engine light, it will flash in series, first will be 1 flash followed by two quick flashes, this tells you your computer is working(not a problem code) then watch for other flashes and write them down, the last code should be a 55, meaning 5 quick flashes followed by 5 quick flashes of check engine light, at least you can diagnose some problems this way, best to purchase manual from autozone, there is a section on this process, or take to your local autozone and have it done free

Sep 18, 2012 | 1999 Dodge Durango

1 Answer

Our 1998 chevy cavalier z24 slams into gear from neutral to drive and second gear to third gear. when it's in park and i put my foot on the gas the rpms don't increas steadily...it increases and decreases...


You need to take it to the shop to be repaired this is not going to be an easy fix. It is probably going to have something with shift solenoids or fluid pressure. Have the tranny serviced by replacing the filter and flushing out the system.

Sep 23, 2009 | 1999 Chevrolet Cavalier

1 Answer

Runs first gear to max rpms before shifting.


You probably have a bad governor pressure sensor and solenoid.The pressure sensor is what normally goes bad ,but from vast experience,i replace both of them together and change fluid and filter.

Aug 09, 2009 | 1999 Dodge Durango

2 Answers

All the sudden my 1999 dodge durango wont shift into reverse?


YES SOUNDS LIKE IT IS THE SOLENOID NOT SHIFTING INTO REVERSE OR TRANSMISSION CONTROL MODULE NOT SENDING SIGNAL TO VALVE BODY SOLENOID

Apr 06, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...