Question about 2009 Chrysler Sebring

Open Question

05 pt cruiser p0334 - 2009 Chrysler Sebring

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3600 Answers

SOURCE: 05 pt cruiser touring turbo code po 302

you have a carbon build up problem try running lucas gas treatment in the car with a full tank of mid grade gas if this does not cure it leave another post and I will give you then next step to fix it, or you can go to http://www.alldatadiy.com and buy a subscription and read all of the recalls and coustmer trouble problems to help locate the problem.

Posted on Jun 17, 2009

  • 6982 Answers

SOURCE: water dripping right front of 05 pt cruiser

If it's water, not coolant, it's likely some residual sloshing around in the bottom of the heater box. If antifreeze, you need to look and find the source.

Posted on Jul 22, 2009

  • 615 Answers

SOURCE: '05 PT Cruiser O2 sensor problems.

I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

Posted on Mar 28, 2010

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

  • 1915 Answers

SOURCE: 05 pt cruiser turbo.oil is

It is getting into your exhaust manifold-the return line is either restricted or blocked, or the oil seal inside the turbo housing is either leaking or blown, usually due to excessive crankcase pressure.Try disconnecting the oil feed and return lines first, clean them out, and try it again-if it is still there, the turbo will have to come out and it will have to be gone over for blown seals.

Posted on Aug 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ECM located?


How To Change The PCM On A Chrysler PT Cruiser ...

? 14:05
https://www.youtube.com/watch?v=fLN48sAKpiE
Jul 24, 2014 - Uploaded by The Hapless Housewife
How To Change The PCM On A Chrysler PT Cruiser ... things wrong with my car now, but had I replaced the PCM (aka) ECM a long time ago, ...

Chrysler PT Cruiser Engine Computer Module ECM PCM ...

www.ebay.com > ... > Engine Computers

eBay
$169.00 - ‎In stock
Chrysler PT CRUISER Engine Computer Module ECM PCM ECU - "Plug & Play" in eBay Motors, Parts & Accessories, Car & Truck Parts ' eBay.

Chrysler PT Cruiser Engine Computer



Dec 30, 2015 | 2002 Chrysler PT Cruiser

1 Answer

Timing alignment marks


Timming for 2.4 avenger

Jan 14, 2014 | 2009 Chrysler PT Cruiser

1 Answer

I put a 2005 motor in a 2001 pt cruiser and put all the 01 sensors on the 05 motor except for the crankshaft senor it is the 05. I am not getting fire at the coil pak


your crank sensor IS what fires the coil pack
mixing the two years sounds like the problem
check wire harnes see if the 01 powers the 05 the same termail
01 senor and pack may have to go back
good luck!

Mar 01, 2012 | 2004 Chrysler PT Cruiser

1 Answer

Replacing 2004 PT Cruiser Turbo battery


there is a metal bar holding the battery on my 05 pt cruiser, how doi remove it

Jan 20, 2012 | 2004 Chrysler PT Cruiser

1 Answer

Driving down hwy and 05 pt cruiser dies and wont start back up was acting fine just before


Could be many things, but chaeck the coil(s) and ignition controller first.

Jul 21, 2010 | 2001 Chrysler PT Cruiser

1 Answer

'05 PT Cruiser O2 sensor problems.


I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

Mar 28, 2010 | 2005 Chrysler PT Cruiser

1 Answer

When tun on the a/c to my 05 pt cruiser it doesnt


This is because the engine does not accelerate and the RPM falls below the minimum the PCM is in charge of sending a signal for the engine to increase the RPM.Thanks

Feb 27, 2010 | 2005 Chrysler PT Cruiser

1 Answer

05 pt cruiser conv. r windows not working after batt died


I have a 2004 Chrysler PT Cruiser Convertiable. Both windows on the driverside will not go down when you open the door. I have replaced the window switch and that is not the problem.

Oct 06, 2009 | Chrysler PT Cruiser Cars & Trucks

1 Answer

05 pt cruiser touring turbo code po 302


you have a carbon build up problem try running lucas gas treatment in the car with a full tank of mid grade gas if this does not cure it leave another post and I will give you then next step to fix it, or you can go to http://www.alldatadiy.com and buy a subscription and read all of the recalls and coustmer trouble problems to help locate the problem.

Jun 17, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2009 Chrysler Sebring Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...