Question about 1996 Jeep Grand Cherokee
The other day my remote unlock stopped working, no doors except the drivers door would lock electrically, no windows except the drivers window would go down electrically, and the interior lights will not go off as if there is a door open. Any recommendations?
If door switches are ok, check the courtesy light relay located just under the front passenger side(above the fuse box)
Posted on Jan 24, 2009
The button that pushed in when you close the door could be bad its literally like a $10 part and plugs in and is only held in with one screw. My interior lights used to flash on and off and i replaced that and now good as new, but you would need to figure out which door is doing it by pushing the button in manually
Posted on Jan 18, 2009
Tips for a great answer:
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
Feb 11, 2013 | 1996 Jeep Grand Cherokee
Nov 28, 2012 | 1999 Jeep Grand Cherokee
Mar 11, 2011 | 1996 Jeep Grand Cherokee
Dec 12, 2009 | 2001 Jeep Grand Cherokee
Sep 11, 2009 | 1999 Jeep Cherokee
Apr 08, 2009 | 2000 Jeep Grand Cherokee
Jan 20, 2009 | 1995 Jeep Grand Cherokee
Oct 24, 2008 | 1997 Jeep Grand Cherokee
494 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: