Question about 2007 Chevrolet Cobalt Coupe

Open Question

Front speakers don't work on 2009 chevy cobalt

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

awcforever
  • 359 Answers

SOURCE: Front end Chevy cobalt loud squeak?!

If you have the time, take the vehicle to an autoshop of your choice, and ask them to grease all fittings on the front end. My car did the exact same thing, it was the ball joints. You may need a new ball joint, but being a 2009, I highly doubt it unless its been in an accident or something. There are grease fittings on the front, I believe there should be at least 5, maybe more, but the sound you are experiencing is the equivalant to a pogo stick if I'm correct. Hope that helps.

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: Front two speakers just stopped working.

I have an 05 Cobalt that just experienced the same problem. I had my door panels off and my speakers appear to be dead.

If you have a multimeter, you can pull the speaker out and test to see if you get resistance across the two terminals. It should say on the speaker what the resistance should be (most likely 4 ohms). If you get no reading, you most likely will have to replace the speaker.

You could also test for AC voltage on the speaker wires. When the stereo is on, and set to a reasonably loud value, you should get a few volts. If you don't get any reading at the door, it may be either the wiring or the stereo. To determine which it is, you will have to take readings at the stereo output.

Hope this helps.

Posted on May 17, 2009

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

  • 212 Answers

SOURCE: what size speakers are in the front doors of a

6.5 round front 6x9 rear

Posted on May 09, 2010

  • 37 Answers

SOURCE: The front speakers of my Chevrolet Cobalt do not work.

replace speakers or look for loose connection or is the fade adjustment turned to just the rear you would be suprised

Posted on Jul 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the 4 way's flasher located in a 2008 Chevy Cobalt?


The Chevy cobalt does not have a flasher relay, the cobalt turn signals are fully solid state and run through the PCM (powertrain control module) in the car, the sound comes from your speaker in the front left

May 13, 2016 | Cars & Trucks

1 Answer

2009 cobalt 2.2l cam shaft position actuator bank 1


Here's a link James,stroll down and you will see a picture of it at the engine and how to remove. Code P0010 P011 Easy Fix Chevy Cobalt Forum Cobalt Reviews Cobalt SS...

Sep 21, 2015 | 2009 Chevrolet Cobalt

1 Answer

Have a 2009 chevy cobalt. the left turn tail light even though not fused will not blink, and the left indicator light flickers too fast. the right though is working perfectly


Buy a two pack of turn signal bulbs. Change the front and rear left bulbs and try it out. If you're lucky, you're done and got away cheap. If not, start chasing electrons. Not an overly complicated circuit, the signal is quick flashing because you have an inoperative lamp.

Mar 14, 2015 | 2009 Chevrolet Cobalt

1 Answer

Why my front speakers don't work


is this a stock radio? i had a chevy radio that tone of the channels blew out and no front speakers. also check the door speakers to see if the wires aren't corroded from moisture .

Mar 27, 2013 | 2007 Chevrolet Cobalt Coupe

1 Answer

Right front and rear speakers don't work correctly


is it a factory radio? have you had any work done right before this concern your having?

Jan 24, 2013 | 2009 Chevrolet HHR

1 Answer

I replaced my camshaft position sensor in my 2009 chevy cobalt..how do I fix the timing? It's still off.


for starters you should have set your number one piston at top dead center (TDC) before you just changed the sensor, All it need is to be one or two teeth out on the timing chain to run rough, here is a link to a guide on how to solve this problem , I hope it helps:

ww2.justanswer,com/uploads/JHoop/2010-12-22_125719_1.pdf

Sep 05, 2012 | 2009 Chevrolet Cobalt LT1

1 Answer

Howto change a key cylinder for a chevy cobalt


There is a TSB on this issues if your having ignition lock issues.
Service Information
2009 Chevrolet Cobalt | Cobalt, G5 (VIN A) Service Manual | View All Bulletins | Document ID: 2325129

#09-02-35-005: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder) - (Aug 10, 2009)

Subject: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder)

Models: 2008-2009 Cadillac CTS (Built Prior to VIN Breakpoint 90163371)

2005-2009 Chevrolet Cobalt (Built Prior to April 14, 2009)

2006-2009 Chevrolet HHR (Built Prior to April 14, 2009)

2007-2009 Chevrolet Equinox (Built Prior to July 2008)

2005-2006 Pontiac Pursuit (Canada Only)

2006-2009 Pontiac Solstice (Built Prior to April 14, 2009)

2007-2009 Pontiac G5 (Built Prior to April 14, 2009), Torrent (Built Prior to July 2008)

Attention: This bulletin only applies to vehicle equipped with automatic transmission.

Aug 05, 2010 | 2005 Chevrolet Cobalt

1 Answer

Front two speakers just stopped working.


I have an 05 Cobalt that just experienced the same problem. I had my door panels off and my speakers appear to be dead.

If you have a multimeter, you can pull the speaker out and test to see if you get resistance across the two terminals. It should say on the speaker what the resistance should be (most likely 4 ohms). If you get no reading, you most likely will have to replace the speaker.

You could also test for AC voltage on the speaker wires. When the stereo is on, and set to a reasonably loud value, you should get a few volts. If you don't get any reading at the door, it may be either the wiring or the stereo. To determine which it is, you will have to take readings at the stereo output.

Hope this helps.

May 04, 2009 | 2006 Chevrolet Cobalt

2 Answers

Front end Chevy cobalt loud squeak?!


If you have the time, take the vehicle to an autoshop of your choice, and ask them to grease all fittings on the front end. My car did the exact same thing, it was the ball joints. You may need a new ball joint, but being a 2009, I highly doubt it unless its been in an accident or something. There are grease fittings on the front, I believe there should be at least 5, maybe more, but the sound you are experiencing is the equivalant to a pogo stick if I'm correct. Hope that helps.

Mar 13, 2009 | 2009 Chevrolet Cobalt

Not finding what you are looking for?
2007 Chevrolet Cobalt Coupe Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...