Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
from Yahoo answers
The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the motor and the alternator. You need not take the bracket off to remove the alternator. Two bolts hold the alternator to the bracket. One bolt is on the front top of the alternator and one bolt is located on the bottom front of the alternator. The bottom front bolt is attached to the tension adjustment for the alternator. Loosen the tension screw then remove the bolt going through the tension adjustment. After you loosen the top, front bolt, the alternator should be loose enough to move side to side. Remove the top, front bolt. Now you must disconnect the alternator from the power supply. Behind the alternator is a screw with a wire attached via nut. Remove this wire. Nextly there is a series of wires with a plug on the end. It is plugged into the side of the alternator. Uplug this item. You can also access both of these from the passenger side front tire well. Something to consider is that remanufactured alternators in Rodeo's as well as the Honda Passport (which has the same engine as the Rodeo) do not work and the problem(s) associated with a bad alternator,ie; not charging, no fan blower, battery light and brake light on, still exsist after replacing alternator with reman. Use a factory original alternator if possible. It will cost a little more than a reman but will most likely save you a lot of time and headache!
Hope this helps you out!!
Posted on Sep 29, 2008
SOURCE: 1997 Isuzu Rodeo Belt removal
You need to loosen the alternator so the belts become slack. Look for bolts on top and bottom that attach the alternator to a bracket or the engine block. Loosen them and the alternator will move. Since the belts hook to other accessories, you may need to loosen them too. To get them back and the proper tension, you'll need a large screwdriver or pry bar to put tension on them as you tighten the bolts. I suggest you get a Haynes guide for this model that will have photos showing how this is done.
Posted on Jan 11, 2009
all windows controlled from the drivers door...if you have someone in the family with BIG fists have them stand beside the drivers door panel and putting the **** against the door, SLAM their fist into the door panel right under the switches. Take a can of WD-40 and spray ALOT directly around the switches in the door using the little red hose WD40 gives you. GM's are known for carbon-tracking their door mechanisms...build up over the years...sometime banging the door knocks the buildup loose allowing the circuit to work.
Posted on Jun 14, 2009
Tips for a great answer:
Mar 26, 2016 | Isuzu Cars & Trucks
Dec 04, 2012 | 2002 Isuzu Rodeo
Mar 02, 2012 | 1997 Isuzu Rodeo
Dec 14, 2010 | 1994 Isuzu Rodeo
Nov 12, 2010 | 1998 Isuzu Rodeo
Sep 08, 2010 | 1997 Isuzu Rodeo
Apr 25, 2009 | 1997 Isuzu Rodeo
Jan 11, 2009 | 2002 Isuzu Rodeo
Sep 29, 2008 | 1996 Isuzu Rodeo
Jun 28, 2008 | 1997 Isuzu Rodeo
91 people viewed this question
Usually answered in minutes!