Question about 1998 Chevrolet Blazer
My friend said I should use a factory fuel pump. Airtex? Delphi?
I have seen the airtex become a very reliable pump over the last 10 years i would have little concern using it
Posted on Dec 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1991 chevy s10 blazer
Check the fuse under the dash. Did you replace the inline fuel filter? If not, you could loosen the line going into the filter then turn the key to the on position. The pump should run for about 2 seconds then the relay should kick off. Turn off the key for approx. 5 seconds then cycle key back on and the pump should cycle again. If you get a 2 second burst of fuel each time then the pump is cycling. Install a new fuel filter and check the grounded wire by the tank. Hope this helps. :)
Posted on Nov 03, 2008
yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate
Posted on Dec 08, 2008
Spark......EQUIPMENT NEEDED: 1) fuel pressure Gage....Advanced Auto = $45..... 2) needle nose pliers ( fuse pull )..
There is a fuel pressure access valve located on the fuel injector rail. The access port or "shraider" valve has a black or gray screw on cap. Remove the cap and you will see the valve. CAUTION: The fuel rail is under pressure....before installing the pressure gauge, relieve pressure by starting the engine and removing the fuel pump fuse from the under hood fuse box......
Once the engine quits, turn the key to the off position and safely install the pressure gauge. Put a rag around or under the access valve to catch any drizzling fuel. I always prefer to do this when the engine is cool.
Install the pressure gauge, start the engine, check for leaks and read pressure output at idle, record pressure reading.
Also, it should be checked under load but you will need another person to help.
Once you have shut the vehicle off watch the pressure gauge, it should remain steady and not leak down.
Let me know what the readings are.
Posted on Feb 13, 2009
hi its rob was it running befor u replaced the pump if its petrol take out the spark plugs maken sure not to mess up the timeing give them a clean .if its deizil prime the system o open the injectors
Posted on Apr 26, 2009
Tips for a great answer:
Jan 22, 2016 | Cars & Trucks
Jan 16, 2013 | Cars & Trucks
Feb 09, 2012 | 2001 GMC Jimmy
Feb 02, 2012 | 1999 Chevrolet Blazer
Jan 20, 2012 | Chevrolet Astro Cars & Trucks
Nov 09, 2010 | 1999 Chevrolet Silverado 1500
Jan 21, 2010 | 2001 Chevrolet Blazer
Dec 28, 2009 | 1998 GMC Jimmy
Jul 19, 2009 | 2002 GMC Yukon XL
Jun 27, 2009 | 2000 Chevrolet Blazer
Apr 11, 2017 | 1998 Chevrolet Blazer
258 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: