Question about Chevrolet Blazer

Open Question


Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: need to find the backup beeper or reverse light

You can purchase a reverse bulb that that has an audible signal only when the reverse lights come on. Check some parts stores. I have one in my 1995 F350, It works Great.

Posted on Apr 20, 2009

  • 53 Answers

SOURCE: 2001 cavalier 5spd trans looking for the location

You have to jack up the vehicle and get to the switch from underneath. The B/U lamp switch is located on the transaxle and has a connector going to it with two wires... a light green and a pink colored one.


Posted on Oct 30, 2009

  • 389 Answers

SOURCE: back up light switch

Have someone shift it in and out of reverse while you follow the linkage. Usually there is a button on the side of the transmission that when it goes into reverse in hits that button which lights up you reverse tail light. But have to tried to change the bulb first and check the fuse. the switch you seek really never goes out. Not in my life time have I heard of one going bad. If you were out four wheeling then maybe you could have bumped it loose and knocked the wire off but your car does not seem like the type to go mud dobbing!!! I hope this helped, The Raz

Posted on Apr 17, 2010

Testimonial: "thanks for the help!!!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Location of back up light switch for 2002 jeep liberty

The switch is on the outside of the transmission case. See a photo of it below. It may have a short lead on it or the harness plugs directly in.

Sep 21, 2016 | 2002 Jeep Liberty

1 Answer

I have 89 Chevy s10 automatic 4x4 4.3Lt. Want to convert to manual trans I have a 97 s10 4x4 4.3Lt. Manual trans will it fit in my 89 s10 4x4

They will bolt up. You may want to get the wiring plugs off the 97 t case as they will be different from yours. Or use your old t case

May 24, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

Where is location the fuel pump relay in my chevy s10 1996

Start by resetting the INERTIA SWITCH. The location of the inertia switch will be found in your OWNER'S MANUAL. If you do not have your Owner's Manual, check online.

Sep 06, 2014 | Cars & Trucks

1 Answer

Where is the back-up light switch physically located? Is there a diagram available that shows the location? My Haines manual does not show it.

Hello jack isuzu
If you have a manual trans. with a 3.2 it's on top of the trans. if you have a 2.2 it's on the right side of the trans. My diagram does not show a seperate switch for the backup lights on an automatic
transmission, it may be part of the trans. gear position switch on the left side of the transmission.
Look for a red+yellow wire from the rear of the truck to the transmission, this wire runs from the
backup lights and you should be able to follow it back to the switch. Hope this is helpful.

Apr 27, 2011 | 1999 Isuzu Rodeo

1 Answer

Were is the backup light switch on a 1997 s10 blazer

it is incorporated in the trans. range switch, it is located behind the shift arm that the shift cable hooks to on the pass. side of the trans

Mar 09, 2011 | 1997 Chevrolet Blazer

1 Answer

Back up lights not working Where is switch to turn

Switch is on the transmission. Exact location depends on whether you have automatic or manual transmission. I have pasted pictures for each case below. Just look around the transmission for these parts. OK?

automatic trans:

manual trans:


Dec 06, 2010 | 1989 Nissan Pathfinder

1 Answer

I have a 1997 s10 4x4, and my memory wire is missing, i need to know what fuse, or wire i can run the wire to so i wont have to keep reseting my radio?

1997 Chevrolet S10 Pickup Truck Car Radio Stereo Audio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Jan 14, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

92 ford explorer back-up lights will not work. Just changed manual transmission.may have left something unplugged.Tested the bulbs and they are fine.Possible fuse or relay but I do not have the owners...

itch Operation:Photo of back up light switch, located on trans. sorry, not sure exactly where on tranny, but it probably isn't plugged in as u suspect. Photo on autozone website. 00610_backup_light_switch.jpg

Apr 15, 2009 | 1997 Ford Explorer AWD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

548 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides