SOURCE: 1996 ford taurus is losing power and rpms when engine gets warm
If it was a dealer, go back & have him scan it for fault codes. Usually cheaper to have it scanned and replace one faulty part, than replace 5 parts before you hit the right one. Autozone & PEP boys apparently will scan for free if you bought it private.
SOURCE: 1996 ford taurus odometer stopped working
the Speedo in your car is electronic, the problem is the tiny motor that moves the needle is most likely defective, there are no parts for the Speedo available to the consumer from Ford, you must remove the Speedo and have it repaired by a authorized Speedo repair shop. here is a link to a good one I know about.
http://dnaspeedometers.com/
SOURCE: 1996 Ford Taurus Making a beeping sound
Mine beeps like that as well if I don't put my seat belt on. The seat belt light comes on for about a minute then shuts off and a few seconds later it starts beeping without any lights coming on. This may not be what your problem is but I was wondering why mine did the same thing and I figured out if I didn't have my seatbelt on that's when it would beep like that. The seat belt light had already shut off and wasn't blinking or anything so I didn't realize that's what it was right away.
SOURCE: where is the oil sending unit on a 1996 ford
On 3.0L OHV engines, the oil pressure sensor is located on the left
side of the engine block above the flywheel. On 3.0L DOHC engines the
sensor is located on the left side of the engine block above the oil
filter. On 3.4L DOHC engines the sensor is screwed into the oil filter
adapter. The oil pressure sensor operates the oil pressure warning lamp.
Fig. 1: Location of the oil pressure sensor-3.0L OHV engines
Fig. 2: Location of the oil pressure sensor-3.0L DOHC engines
Fig. 3. The oil pressure sensor-3.0L OHV engine
Hope help with this (remember rated this help). Good luck.
SOURCE: service engine soon light on 1996 ford taurus
Take the car to Autozone or similar business that offers free scanning of the car's computer. If the computer has no problem codes, then the scanner can turn off the light. If the computer has recognized trouble, then it must be corrected to keep the light turned off. Good luck!
66 views
Usually answered in minutes!
×