Question about Peugeot Cars & Trucks
Don't know how to change the rubber seal on the door
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
leave ign off with key out 3mins disconnet battery 5 mins reconnett and press lock/ unlock repeatedly until locks cycle through to re sync try this any probs come back to me
Posted on Feb 23, 2009
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
Posted on Sep 04, 2009
if it says the diesel filter, then that is what it means,a fuel filter.normal service requirement on any vehicle and can be done for small dollars at any garage
Posted on Dec 04, 2009
Try pushing against the door while lifting the handle then pull it hard. they stick on the 307 because the latches dont alaign properly, if that does not cure it try locking and unlocking the car's central locking repeatedly, while still trying to open the door.
If that does not fix it then you will need to remove the door card/door trim. It sounds like either the mechanisim has failed or the rod which connects the mechanism has came off, this can be a tricky job as normally you would have the door open to remove the door trim. you may not get the trim all the way off you might have to put your hand on the inside of the door and unlock it, try pulling each rod gently, and feel around where the latch is try and free it.
Like I say theres no easy fix for this fault, it may take you some time to get the door open.
Let me know if you need more info
Posted on Feb 05, 2010
SOURCE: peugeot 307 1.6
peugeot and citreon cars do bite high generaly, it is hydaulic there is no adjustment. but it also depends on how high it is ?? does it slip if you slightly rest your foot on whilst driving?? they do have a problem with the bearings going through the cover as it is the same bearing as a HDI . but you woud notice this as a different problem. ie noise or vibration on pedal. call me for more info .. paul @ the clutch centre..01527 64440 07790438337
Posted on Mar 19, 2010
Tips for a great answer:
Mar 05, 2016 | Peugeot Cars & Trucks
Nov 29, 2014 | 2005 Peugeot 307 HDi
Jun 03, 2014 | 2004 Peugeot 307 1.6
Feb 26, 2014 | Peugeot 307 Cars & Trucks
Dec 07, 2012 | 2002 Peugeot 307
May 07, 2012 | 2004 Peugeot 307 SW
Nov 07, 2011 | 2005 Peugeot 405
Nov 21, 2009 | 2005 Peugeot 405
334 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: