Question about 2000 Toyota Tundra

Open Question

How do you replace light bulbs on heat/ac control knobs on 2000 tundra

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1027 Answers

SOURCE: dash lights

The dash is lit by one or more bulbs located on the edge of that clear plastic. You may be able to get to the lamp holder by reaching up behind the dash. If not there, then the dash will need to come off.

Posted on Jul 10, 2008

Ad
  • 4 Answers

SOURCE: AC panel lights 05 camry

those bulbs cannot be replaced individually, you have to replace the whole ac control panel.

Posted on Oct 09, 2008

  • 1861 Answers

SOURCE: Dash Control Unit Replacement

You can save a LOT of money by fixing it yourself.

All that is wrong with the knob are broken wires from the knob's PC board to the main PC board on the AC control.

All you have to do is remove the AC main control, take it apart, and resolder the broken wires from the PC board with the knob on it, to the main AC pc board. There are 3 wires, any number could be broken.

If you take it apart and solder the broken wires, this WILL fix your issue. Just make sure you put the wires back exactly where they go.

A FIXYA rating (4 blue diamonds) would be most appreciated for my assistance.

Posted on Mar 24, 2009

  • 137 Answers

SOURCE: 2000 Toyota Camry Panel Lights not working

are all your instrument panel lights dim? i know this sounds silly but i had a person the other day who had the dimmer switch turned down. if it's not that there is a fuse for the instrument panel, looks like it should be a 7.5 amp fuse in the passenger compartment fuse box. it's very unlikely that all of those lamps would fail at the same time. hope that helps.

Posted on May 28, 2009

manuelleiva
  • 97 Answers

SOURCE: My instrument panel lights went out and I need the

are you sure that your fuses are all good?because it's highly impossible for all off your dash lights and your heater/a/c light burn out at the same time.and yes it is controlled all together.make sure that your dimmer switch is not turned all the way down cause this will cause them to not work.i believe that the dashboard alone has either 3 or 4 bulbs so im pretty sure it has to be a fuse or your dimmer switch.please try these options first ok. hope this info helps.take care and good luck, manny

Posted on Apr 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Should 2004 Cavalier's climate control knobs & power window buttons light up. ? I'd like to replace the bulb or fuse if its possible


The bulbs in the control head for the heater/ac are nor serviced by GM but I think you can purchase them at radio shack if you can get the head out and apart I am pretty sure you can replace them.

Jan 09, 2016 | Chevrolet Cavalier Cars & Trucks

1 Answer

How do I replace a climate control panel light bulb for a 2000 VW Cabriolet. I've pulled off the fan control knob and do not see a bulb?


the "bulb" is usually built into the switch/knob , i've never seen one that can be replaced without getting a new knob , or the other variation is an LED behind the panel , these are also non replaceable but can be repaired if you can find an auto electrician to carry out the job

Dec 27, 2014 | Volkswagen Cabriolet Cars & Trucks

1 Answer

How do I replace the light in the dash for the heating knob ( vent, defroster, etc)


The tiny incandescent light bulb is behind the knob soldered to the circuit board, you must remove the climate control head unit and take it apart to access the knobs back light bulb on the circuit board. You can buy the replacement bulb at Radio Shack, the part number is 7219 Micro Lamp.

Dec 05, 2011 | 2006 Chevrolet Equinox

1 Answer

2000 tundra tail light bulb. what size


If you go to your local auto store they will look up and sell you the proper bulb.

Nov 18, 2010 | 2000 Toyota Tundra

1 Answer

The ac / heater control wont light on my dash... help


Bulb is bad. Take a pair of pliers, wrapped in a soft cloth and pull the fan speed knob out. It's tight, but will come out. You will be able to see the small bulb in the center of the hole you just removed the knob from. Wrap a needle nose plier in paper towel and gently pull the bulb straight out. Be careful not to break the bulb. New bulb from volkswagen is $3. Gently push the new bulb all the way back in. Re-install the knob.

Jan 31, 2010 | 2000 Volkswagen Beetle

1 Answer

How do I change the bulb that lights the heat/ac controls on my 2004 Jetta


If I remember rightly, on a mark 4 golf, the middle of the three heater control knobs pulls off. The bulb is right in behind it and lights up the whole panel. I would think a Jetta will be the same. give it a try.

Nov 11, 2009 | 2005 Volkswagen Jetta

1 Answer

One of the lights for the heat/ac unit is out


If you pull out that knob assembly that controls the drivers side heat behind it you will see little black clips that hold in the bulbs.But if you dont the bulbs are inside the controller and it will have to be disassemble to change them...

Mar 31, 2009 | 2003 Chevrolet Impala

1 Answer

Light bulbs behind the 3 heater/ac controls


to get to these you need to remove the box above by taking out the rectangular screw cover at the back and take out the one screw. gain access to the edge of the box with a flat tool and gently pull the box clear from its clips. now the 2 retaining screws should be visible that hold the controls in place after removing these you need to pull the controls quite firmly from its clips being careful not to damage the wiring to the back. this multiplug has to be released by pressing a retaing clip on the plug itself. once removed the whole unit needs to be separated into 2 halves being careful of static, by removing the screws on the back.once inside there are grey and white bulbs, white for the illumination and grey for the buttons (heated rear window and a/c etc)

Jan 02, 2009 | 2002 Honda CR-V

1 Answer

AC panel lights 05 camry


those bulbs cannot be replaced individually, you have to replace the whole ac control panel.

Sep 07, 2008 | 2000 Toyota Camry

1 Answer

Dashboard Transmission Light for 2000 Tundra


You will have to pull out the instrument cluster to replace that bulb, but, all that bulb does is tell you that your headlamps are on.

Jul 31, 2008 | 2000 Toyota Tundra

Not finding what you are looking for?
2000 Toyota Tundra Logo

Related Topics:

564 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...