Question about 2004 Dodge Ram 1500

Open Question

Where the blower motor resistor on 2001 dodge ram van

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jturcotte
  • 7750 Answers

SOURCE: I have a 2006 Dodge Ram diesel. Can you tell me

It's right next to the blower, above the passenger's feet. See pic below.


jturcotte_37.jpg

  1. Disconnect and isolate the negative battery cable.
  2. Reach under the instrument panel near the blower motor and disconnect the wire harness connector from the blower motor resistor.
  3. Remove the two screws that secure the blower motor resistor to the HVAC housing.
  4. Remove the blower motor resistor from the HVAC housing.

Posted on Nov 30, 2010

  • 1 Answer

SOURCE: locating heater blower motor resistor

the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.

Posted on Feb 01, 2009

SOURCE: 1999 Dodge Ram 1500 Fan Motor Resistor Location

I've never seen a vehicle w/o a blower resistor. You don't need to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be under the passenger dash or under the hood, depending on where the blower motor is.

Posted on May 06, 2009

greg_margo
  • 1959 Answers

SOURCE: firing order for dodge 2001 ram van 1500,

Here you go:
5.2L and 5.9L engines Firing order: 1–8–4–3–6–5–7–2 Distributor rotation: Clockwise

Diagram link below:

http://www.chiltonlibrary.com/content/images/7924/images/79243g14.gif

Best of luck!
Greg

Posted on Jun 14, 2009

  • 186 Answers

SOURCE: Where is the blower motor located in a 1999 dodge

It is behind the passenger side of the dash. when you look under the dash you will see it. you may have to remove a kick panel

Posted on Aug 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace heater resistor 1998 dodge grandcaravan 3,8


Click HERE for instructions with detailed photos on replacing the blower motor resistor in 1996-2001 Dodge and Chrysler mini vans.

Nov 16, 2011 | 1998 Dodge Caravan

1 Answer

Low and medium speed fan for ac does not come on, while high speed fan works. 2000 1500 dodge van, had new condensor unit under dash replaced recently.


Blower motor resistor needs replacing. Follow wires from blower motor to connector, which should be the resistor. Usually in duct work, held in by 2 small screws.

Jul 25, 2011 | 2000 Dodge Ram 1500 Truck

2 Answers

We have a 1997 Dodge 2500 Ram Van and air conditioner only runs on High setting. We were told the Blower Motor Resistor needs to be changed out. How do we locate where this is and what steps do we take to...


Hi there,

Before you start dismantling your interior dash, you should firstly confirm it is in fact the resistor. Otherwise, you could be making unneccessary work for yourself.

Have your vehicle diagnostics checked (Aircon system) first - this will tell you which circuit is having problems.
Once this is done, we can guide you from there.


Cheers,

May 13, 2011 | 1997 Dodge Ram

1 Answer

Blower motor resistor overheats and fried connector to blower motor on 2001 Grand Caravan. Replaced resistor once new one fried connection. Saw review online that the resistor diode may be the culprit....


You should be replacing the blower motor with the resistors. If your buying the parts from the dealer an experienced parts person will insist you replace both at the same time. The blower motor is usually what burns out the resistors.

Jun 05, 2010 | 2001 Dodge Grand Caravan

1 Answer

My 98 dodge ram van 1500 blower only works on 1,2,and 4 not three and i just replace the blower motor resistor cause it was only working on 4 now im confused some help please


CHECK YOUR SWITCH IF YOUR BALLAST RESISTOR IS WORKING OK (MAKE SURE !!!COULD HAVE A BAD ONE ANYWAY) THE SWITCH IS AT FAULT

Mar 02, 2010 | 1999 Dodge Ram

1 Answer

My 2001 ram van ac only blows on high i replace the resistor and it work fine for a few days now is doing it again


well your blower motar is probabley pulling to many amps threw the resistor and causing the resistor to burn up . but first try uupluging it and pluging it back in yoiu may have weak pin in the conector. cauesing a bad conection wich can realy ramp up the amperage.

Mar 02, 2010 | 2001 Dodge Ram Maxi

1 Answer

Location of the rear blower motor resistor on a 2003 dodge ram 1500 van. The symptoms I have is the fan motor switch does not work in the low and middle positions.


The blower motor resistor gets very hot, so it is always located in a position where the blower can keep it cool. Inside the box with the blower but accessed from the outside, usually with two screws holding it in.

Jul 06, 2009 | Dodge Ram 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

361 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...