Question about Honda Accord
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check the prones inside the connector that you plug into the brake light module. You may have to squeeze, wiggle, tilt each one to see which one is not connecting all that good. I know it may sound confusing. I tried to explain the best of I could.
Posted on Apr 29, 2009
Of course you can make this repair! I'm wondering about the faulty bulb that shorted out all the brake lights...not sure if that's what happened. Your brake light switch is located on the brake pedal, up above where your foot goes. It has a plug in connector which you unplug, then loosen the locknut where it attaches to the pedal.Put in the new switch, lock nut 1st, then plug it in. Note that the locknut is the adjustment point that determines when your brake lights go on. Adjust the locknut so that the brake lights go on when the pedal is depressed within 1/2 an inch (13mm)of pushing down on it. If the switch is adjusted without enough play (say 1/8 inch or less), brake lights may flicker on and off when you go over a bump.If over 1/2 inch, brake lights might go on only if great force on pedal is used (or not at all, yikes!).For good diagrams of parts check out South Bay Honda (hondapartscheap)web site. You enter the year, model, engine, and you can scroll thru tons of parts. If you have any more questions, do not hesitate to post it for me. countrycurt0
Posted on Aug 08, 2008
THREW THE TRUNK RIGHT UNDER WHERE THE LIGHT IS MOUNTED THERE SHOULD BE 2 WIRES GRAB AND TURN THE PLUG AT THE END OF THE WIRE THE PLUG WITH THE BULB SHOULD POP OUT
Posted on Mar 30, 2009
Check the computer in the tail light assembly. There is alittle computer which controls the break lights. One computer for each side.
Posted on May 25, 2009
I just had to do this, and it isn't all that easy or quick. First, gently work the gray, carpet like cover loose from the area around the tail light ,(this may give you a little trouble). Once you have done this, you will see three silver nuts. These must be unscrewed. The lower left nut must be accessed through a hole next to where the trunk lid fits. (The screws are permanently attached to the lens housing so will not drop into obscurity when the nuts are removed). After removing the nuts, GENTLY work the lens housing away from the car. You may need a screw driver to unseat the housing, but just be gentle.
You will find three bulbs inside the lens. The brake light bulb is on the lower right side. Simply pull the old bulb out and insert the new one.
Just reverse these directions to reassemble the housing.
Posted on Jun 03, 2009
Tips for a great answer:
Oct 17, 2011 | 1990 Honda Accord
Aug 29, 2011 | 1990 Honda Accord
Jul 15, 2011 | 2000 Honda Accord
May 18, 2010 | 1990 Honda Accord
Nov 14, 2009 | 1993 Honda Accord
Mar 08, 2009 | 1992 Honda Accord
Sep 10, 2008 | 1990 Honda Accord
Jul 27, 2008 | 1994 Honda Accord
113 people viewed this question
Usually answered in minutes!