Question about 2007 Buick LaCrosse CXL Sedan

Open Question

Location of 2006 buick lacrosse evap purge solenoid

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1168 Answers

SOURCE: locate canister purge solenoid for 2000 Buick

The evaporative canister purge valve is found between the upper intake manifold and the rear valve cover.

Posted on Nov 01, 2009

Ad
Molson02536
  • 3854 Answers

SOURCE: programing instructions for buick 2006 lacrossekeyless remote fob

Transmitter ProgrammingImportant: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.

  1. Install a scan tool.
  2. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.
  3. Press the START soft key on the scan tool. Important: The scan tool must stay connected until all of the transmitters are programmed.
  4. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed.
  5. Repeat the previous step in order to program up to 4 transmitters.
  6. Remove the scan tool.
  7. Operate the transmitter functions in order to verify correct system operation.
Good luck

Posted on Dec 13, 2009

  • 3 Answers

SOURCE: 2006 buick lacrosse how to replace headlight low

The bright light fitting is the same as the dim so take it apart fist to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you a little more space.

Posted on Apr 03, 2010

  • 3 Answers

SOURCE: change headlight 2006 Buick LaCrosse

The bright light fitting is the same as the dim so take it apart fist to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you more space.

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the canister purge valve located on a 2005 Buick LaCrosse CXS with a 3.6 L


Remove the plastic cover off top of engine . purge valve solenoid under it.

Evaporative Emission (EVAP) Canister Purge Solenoid Valve
Top rear of the engine, on the intake manifold, near the fuel injectors. If you don't know what it looks like google part to see a picture .

Dec 31, 2016 | 2005 Buick LaCrosse

1 Answer

Where is the location of the Vapor Canister Purge Solenoid on a 2006 Buick Rendevous


Here is a link for locating/replacing the canister purge solenoid on a 2006 Chevy Impala. I couldn't find a video for your Buick, but I suspect it may be located in the same area - near the fuel filler neck. How To Install Evaporative Emissions Canister Purge Solenoid 2006 12 Chevy...

Jan 11, 2016 | 2006 Buick Rendezvous

1 Answer

Location for 2006 buick rainier EVAP purge solenoid


You should have an EVAP leak test done . It could be a leaking purge valve , you could need a new gas cap as well or it could be the fuel filler neck . or assorted hoses or the fuel tank pressure sensor . If the check engine light is lit there will be a code .
DTC P0442: Evaporative Emissions (EVAP) System Small Leak Detected or
DTC P0455: Evaporative Emission (EVAP) System Large Leak
DTC P0446: Evaporative Emissions (EVAP) Vent System Performance
You have to jack up the vehicle , the purge valve is attached to the engine behind the A/C compressor .

Dec 01, 2015 | 2006 Buick Rainier

1 Answer

How to fix 05 buick rendevous po443 code?


p0443 is a EVAP code. The EVAP system deal with the vapor of your fuel tank. The definition of P0443 is EVAP purge valve circuit malfunction. The purge valve solenoid is locate on a support on the motor. There is 2 plastic hoses, one from the fuel tank and the other going to the trottle body. The most commun cause is a broken wire at the purge valve solenoid connector. The second most commun cause is the purge valve solenoid itself.

Sep 05, 2014 | Cars & Trucks

1 Answer

Where is the location of purge valve on 2006 buick lacross


Canister Purge Solenoid Valve is part of the EVAP system. The component is mounted to the intake manifold. This is on the 3.6 liter engine.
1e4cad15-bd7b-42f1-982a-7d274cb22c56.jpg

May 01, 2014 | 2002 Jeep Grand Cherokee

1 Answer

What is a p0496 error on a 2006 buick lacrosse cxs


The P0496 DTC code is a generic code which applies to all vehicle makes. A quick search on the 'net shows that this code seems to be more common with GM (Chevy, Pontiac, etc.) vehicles. In Acura, Honda, Hyundai, Kia, and Mazda vehicles, this code is described "EVAP system high purge flow" which is the same thing.
try use maxiscan us703 to clear the fault code.

Jul 01, 2012 | 2006 Buick LaCrosse CXS

Not finding what you are looking for?
2007 Buick LaCrosse CXL Sedan Logo

Related Topics:

1,198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...