Question about 2008 Dodge Ram 1500 2WD
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
according to the owners amnual the max towing weight for a 1999 ram 1500 quad cab wit automatic transmission is 7600 lb.
with either 5.2 or 5.9 v8. for a reg cab it is 8000 lb.
Posted on Jul 23, 2009
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Nov 04, 2009
I hope describes correctly the detail procedures for replacing 2009 Dodge RAM 1500 Headlight Bulb.
- First, open the hood; Disconnect the negative battery cable;
- Remove the four grille attachment bolts;
- Remove the grille;
- Remove the two headlamp assembly attachment bolts;
- Then reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash shield.
- Access to the bulb retainer can be gained through the wheel liner hole (see picture).
After that reach through the access hole to access the rear lamp retainer and remove headlamp assembly (see below picture).
Disconnect electrical connectors, and replace the bulbs.
Good luck (remember rated this help).
Posted on Nov 26, 2009
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
Posted on Apr 10, 2010
Tips for a great answer:
May 23, 2016 | Dodge Ram 1500 Cars & Trucks
Jan 27, 2016 | 2010 Dodge Ram Pickup 1500
Oct 07, 2015 | Dodge Cars & Trucks
Oct 14, 2014 | 2010 Dodge Ram Pickup 1500
Oct 18, 2013 | 2010 Dodge Ram Pickup 1500
PLEASE RATE THIS REPLY FOR ACCURACY
Mar 24, 2013 | Cars & Trucks
Nov 15, 2010 | 2010 Dodge Ram Pickup 1500
Oct 16, 2010 | 2007 Dodge Ram Truck
Mar 07, 2009 | 1996 Dodge Ram 1500 Club Cab
69 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: