Question about Nissan Sentra
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
did you receive the Nissan Service and Maintenance Guide, when you purchased your vehicle? if not go to www.nissanusa.com/pdf/techpubs/2006/2006_N_SMG.pdf
to get the 2006 manual it should be the same, or go to www.nissanusa.com use the "for owners" tab top right and you can download your specfic mileage service
Posted on Mar 30, 2009
Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
Install or connect the following:
Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable
Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.
Posted on Jul 31, 2009
do you mean P0171??
If so, then it means your MAF sensor may be dirty and needs to either be cleaned or replaced.
It could also mean there's a vacuum leak downstream of the MAF sensor
Posted on Oct 13, 2009
Testimonial: "Confirmed what I suspected. Thanks, Lesjude"
Swirl Control Valve
Swirl control valve consists of actuator and valve. The valve is
installed in the intake manifold, and the actuator is connected to the
rear end of the valve shaft.
The swirl control valve uses a step motor which has four winding
phases. It operates according to the output pulse signal of the ECM.
Two windings are turned ON and OFF in sequence. Each time an
ON pulse is issued, the valve opens or closes. When no change in
the control position is needed, the ECM does not issue the pulse signal.
A certain voltage signal is issued so that the valve remains at
that particular opening.
Posted on Dec 01, 2009
I would check that spark plug, and have that coil checked or replaced. Also check for any vacuum hose leaks in the area of the cylinder.
Posted on May 12, 2010
Tips for a great answer:
Apr 19, 2016 | Nissan Cars & Trucks
Feb 01, 2014 | 2005 Nissan Sentra
May 03, 2013 | Cars & Trucks
Feb 25, 2013 | 2005 Nissan Sentra
Feb 06, 2013 | 2005 Nissan Murano
Dec 19, 2012 | 2005 Nissan Sentra
May 20, 2011 | 2006 Nissan Armada
May 20, 2010 | 2005 Nissan Sentra
Jul 01, 2009 | 2003 Nissan Murano
37 people viewed this question
Usually answered in minutes!