Question about Nissan Cars & Trucks

Open Question

Remove rear door panel on a 2007 nissan xterra

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 250 Answers

SOURCE: How to remove drivers door panel on a 2007 Nissan Tiida hatchback

The door handle has a c clip behinde it that you can not see.Goto a auto parts store and thay will have a cheep tool to help you.(you need a special tool for this. The WINDOW CRANK handle has a 'c-clip' behind it. The door opening handle trim is held in by either a screw behind a plastic flap that will pop out(behind the lever)or it is held in at four points by plastic tabs (two on top and two on the bottom)that can be undone carefully with a screwdriver or the like. When this plastic trim is removed the door panel should come off.
Be aware that there are plastic clips (back side of the panel) on the perimeter of the panel that hold it in as well.
the tweeter panel just pops out look on the bottom of the door for screws and around the door handle and you will have to pop your window and door lock controls out and the reflector on the door pops out and there is two screws there then al you have is the clips behind the door they make tools for it but a flat tip screwdriver will be fine just get the tip close to the clip and pull it out .
1. Remove window crank (it has a kind of 'bent wire' c-clamp, which holds it onto the window crank shaft). 

2. Pry upwards the top plastic cover to the arm rest (this is a plastic coated foam rubber piece, on which you rest your arm). 

3. Remover the two now visible screws which fasten the arm rest onto the door. 

4. Remove the one screw fastening the inside door handle. 

5. With a blunt tool, gently hit the inside door handle in a forward direction (towards the door hinge). This will release the door handle from the door. 

6. Pry between the door panel and the door, to unsnap the snaps holding the door panel in place. 

7. Finally, lift door panel out and up to remove it from door. 

Posted on Feb 09, 2009

Ad
  • 295 Answers

SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora

The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.

Good luck

Posted on Mar 21, 2009

  • 1986 Answers

SOURCE: Remove right rear door panel 2003 Buick LaSabre

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: door panel removal for 2002 9-5 on driver rear

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the rear door panels on a 2007 Nissan Altima.


Good day Peter.

You can find some pointers here
Inside Rear Door Panel Removal or here
How to remove door panels Nissan Forums Nissan Forum
To the Nissan Forum materials, I can add that auto parts stores and eBay are both good places to get kits of tools for popping auto panels. They make it easier to get them off without gouging up the paint or the panel with a screwdriver, and with less breakage of the pins.

Good Luck!
D

Nov 23, 2015 | 2007 Nissan Altima 2.5

1 Answer

2008 nissan xterra how to take off rear door panel with door not opened ?


You will have to go in from the opposite side of course. You are going to have to remove lower seat cushion so panel has room to come off. Look for a video on YouTube on how to remove panel.

Oct 19, 2015 | Nissan Cars & Trucks

1 Answer

How to removed drivers side door panel on 2008 xterra


There's usually always screw hidden in door handle, then remove any other screws in panel,remove any trim then panel pops off around edges. Their is a special tool for this. Harbor Freight or Auto Zone.

Nov 15, 2012 | 2008 Nissan Xterra S

1 Answer

Replace stop light lens on nissan xterra 2005


remove the inner trim panels , or access the light from the inside of the vehicle . thru storage doors in the back of the vehicle, look for wingnuts made of plastic and unscrew them. some cases require you to take spare tires out of those storage units on the inside of the vehicle.
its also possible that if you raise the rear door, and look on the inside , righ by the light, sometimes there are retaining screws + THAT NEED TO BE REMOVED

Jul 31, 2010 | 2005 Nissan Xterra

1 Answer

My 2007 Nissan Xterra doors locked on their own


Most likely you've got a timed lock programed into your menu parameters. You will have to go to your main vehicle instrumental menu and clear that option. This may have been inadvertantly done by one of the other operators of the vehicle.

Mar 05, 2010 | 2007 Nissan Xterra Off Road

1 Answer

How to change the rear tire on a 2007 nissen


if you look by the rear hatch lock at the bumper,there is a cutout for the tool for the winch lever to fit into.the 2005 to 2009 are all the same.

Nov 05, 2009 | 2007 Nissan Xterra Off Road

2 Answers

Replacing passenger side mirror


no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.

May 28, 2009 | 2003 Nissan Xterra

2 Answers

Where is the jack located on a 2007 xterra?


the Jack should be located in one of the side panels in the rear hatch area or tucked under the storage under the carpet in the rear. If it is not in either of them places then check under the back seats or behind the seats, if you check your Owners manual and go to index and go to Spare and go to the page it should show you where it is located.

May 11, 2009 | 2007 Nissan Xterra Off Road

1 Answer

Rear door panel on Nissan xterra 2005


Ask the dealer to look at TSB's
NTB05-042a, NTB06-037c with special attention to NTB05-117


are they factory rims or hubcaps ?

Robert

Feb 26, 2009 | 2005 Nissan Xterra

1 Answer

Left power mirror replacement


There is a Technical Service Bulletin on the power mirror actuator for replacement. If your mirror just stopped operating, I would take it back to the dealer and they will fix at no charge due to the TSB.

For removing the door panel


  1. Remove window crank handle or power window switch assembly (if equipped).
    • Disconnect harness connectors.
  1. Remove pull handle escutcheon.
  2. Remove pull handle cover and remove screw.
  3. Lift armrest upward to release clips and remove armrest.
    • Remove front door finisher screws behind armrest.
  1. Release clips and remove front door finisher.
    • Disconnect lock cable and handle cable from inside door handle assembly.
38356f4.jpg

Feb 11, 2009 | 2007 Nissan Xterra Off Road

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...