Question about 1998 Audi A6

Open Question

The ABS Pump started to leak on my 1998 How can I tell what is the correct model number to buy?

The ABS Pump started to leak on my 1998 A6 and apparently there models that could fit the car depending on EDL and traction control. How can I tell what my car is equipped with? I don't have any of the original paper work

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: traction control light and abs light

ok your problem is that your brakes are under force you shold get new brake pads ok

Posted on Jul 14, 2008

Ad
  • 599 Answers

SOURCE: abs light and traction control light cant figure out why?

clean ringer at wheel end..be sure you did not disturb alignment of sensor (VSS) which tells 'puter wheel speed for ABS and traction control

Posted on Oct 29, 2008

  • 345 Answers

SOURCE: Air Con failure Audi A6

if its a climatronic head unit and there is a fault the head unit sometimes flashes to tell you there is a fault,diagnostic equipment should be able to pin point your problem

Posted on Nov 16, 2008

metalbluedog
  • 3 Answers

SOURCE: audi a6 on board computer reading faults

you have a thermal fault i the abs modulator <ecu bolted onto pump> the rev counter fails because this signal fails to get from 13.8 volts to zero it only manages to get to about 3 volts this is very common on bosch 5 series mine had pt code bosch 0273004285 and is notorious but easil removed and sent to bba here in uk or others in usa you will have to remove wheel then washer bottle then modulator but car stiill drives when removed the esp needs signal from abs and fails at same time also loss of tacho signal puts il light on i tried to find second hand one biut they didnt work have sent mine for repair<you need a microscope to do it> will post when it comes back ps easily confirmed by spraying abs pump.modulator with freex=zer spray did it to mine and fault dissappears untill warm again nb even when cold i bet if you brake hard a couple of times it will fail please let me know if your pt number is same as mine and if this heelps it drove me nuts

Posted on Feb 26, 2009

  • 1 Answer

SOURCE: ABS Warning Light

you need a abs modul replacement.....had the same problem........you will need to go to the dealership and be prepared to spend $800

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Audi A6 2.8 Quattro with a damaged auto transmission. Car has been sitting for about 8 months without starting it. Today I bought a new battery and started the engine. I was careful to...


The engine could be damage. I have seen when the engine let's go break suddenly it smoking a lot. Do the following check oil level and condition, check coolant level and condition,

Jun 06, 2017 | 1998 Audi A6

1 Answer

I have an AUDI A6 2.4 2003 model. I need a left front ABS ring. Is it possible to buy this seperate instead of the whole drive shaft which is what I have to do in South Africa and it is quite expensive? It...


Its not usually possible to buy the ring seperate.you may be able to buy an outer c.v joint which has the abs ring on it,rather than a complete driveshaft.

Jun 01, 2011 | 2003 Audi A6

2 Answers

Audi A6 quattro 1999 the ABS light is on and the Red Brake light is Blinking what does this mean usually.


That indicates that the ABS controller is having issues. The ABS controller is the metal box along the driver's side of the engine, just in front of the coolant overflow tank. The controller is the black box on top of it with the harness attached. You can buy a new one (expensive) or send yours to www.modulemaster.com for a warrantied rebuild. They have a great reputation on the Audi forums I frequent, and you can drive the car while it's gone (you just won't have functioning ABS while it's gone).

Jul 06, 2010 | 1999 Audi A6

1 Answer

Have just renewed two front brake noses that were damaged,abs l


ABS System must be obligatory bleeded also using a diagnostic scantool like VAS, VAG-COM, Bosch KTS, ... connected to the Data Link Connector (DLC) of the car. In the ABS Electronic Control Unit (ECU) menu, select the ABS bleeding option, then follow instructions on the screen !!!

May 10, 2010 | 1998 Audi A6

1 Answer

I need abs pump for my audi a6 1998 s reg but don't know the number of the pump how to find that,


get the chassis no from the windscreen/dash area and call your local skoda/seat/vw/audi dealer for the part no...easy.

Apr 27, 2010 | 1999 Audi A6

2 Answers

I want to buy an Audi A6 and have two options: i- 2001 Audi A6 with 92,000 miles on it or ii- 1999 Audi A6 with 66,000 miles on it.. Which one would you recommend?


With the year difference only being two years apart I would go with the lower mileage vehicle.But remember that just because it's lower mileage doesn't mean it's in better shape mechanically.A quick trip to your trusted auto mechanic and a small charge of $25 per car can get you a prepurchase inspection, which will tell you any problems the vehicle might have, aka oil/fluid leaks, etc.I hope I could help.....get back to me with any questions

Dec 21, 2009 | 1999 Audi A6

3 Answers

Abs light and traction control light


Hi ,
Take it back and tell them to code it properly! F.O.C.

Jul 11, 2009 | 2002 Audi A4

2 Answers

Break light and anti-brake comes on sometimes on My 1999 Audi A6


This is common in the audi cars. It may be that your ABS module is failing or the the connector to the ABS pump located in the engine compartment on the drivers side, with black metal lines going into it. Their is a large black connector that sometimes needs to be unplugged and cleaned and plugged back in

Mar 15, 2009 | 1999 Audi A6

2 Answers

ABS Warning Light


A problem in the ABS, you'll have to see a shop for that because they should have the proper scan tool to check the ABS (generic's can't cut it with the in depth modules).

Jan 12, 2009 | 1998 Audi A6

3 Answers

Audi Fuel Pump


is it fitted correctly? If it is not fitted correctly it will do this. Have you checked the relay?

May 23, 2008 | 1998 Audi A6

Not finding what you are looking for?
1998 Audi A6 Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...