Question about 1997 Lincoln Town Car
I dont know where the supenson air pump is located.
For exact location of pump,its relay and controlling parts diagram,i suggest you to click the link below:----- ---------- These details will help. Thanks.
These details will help.
Posted on Dec 05, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If you will look to the front of your car, you will see three pulleys going up -down the power steering pump is in the middle, below that is your ac compressor and above that is a pulley leading into your engine, I am assuming it is the crank shaft. It is very difficult to replace yourself, you will probabily have to jack your engine up into a favorable angle.
Posted on Nov 12, 2008
SOURCE: How to replace the thermostat
The thermostat is in the front of the engin inbetween the radiator and engin. Follow top radiator hoze thats connected to the metal pipes by the altenator on passengerside down the hoze will go down into the front of the engin and between radiator, then will stop at a 3 way connector where it splits into 2 more hozes. if u get under neith the car and look up at that connecctor there is 2 bolts remove those bolts and the thermostat is in there. U may need to pry it out a little with a flat head screw driver. then clean the rim and inside where the thermostat was and get gasket sealer and spread it on like butter all over where gasket was and where anything will touch when bolted back together. then sit the new gasket in the top part first then place the long skinny shaft of the thermostat in first into the upper part of the connector (where u took it out) then put the bottom part and top part back together (make sure everything is dry b4 its put in and together) then put the 2 bolts back in the housing and ur all done. Just make sure u check ur coolant cause u lost some in this process. Let the car run for a while and cheak for leaks the refill coolant again after it has taken some into the engin. check coolant levels for a few days after this and for leaks aswell.
Posted on Feb 17, 2009
The air pump is located in front of the radiator reservoir on the passenger's side - with the power steering
reservoir between the two.
The air ride is turned on in the truck. The panel in located on the opposite side from the gas tank input (inside the trunk) behind a door. It should be marked on the door.
Make sure the air ride is enabled. turn the ignition key on, You don't need to start the vehicle. After about 5 seconds the air compressor should engage. You don't always hear it when it's running well. Since the engine is off, you should be able to hear any leaks in the air system.
Hole/crack is air spring
Hole or broken air line or coupling
Failed air compressor
The rear suspension should use the same air system. If the pump is 'out' then the rear will also fail to adjust, But since it is on a separate air-line and valve system, it will continue to operate when the front has air leaks. And vise versa.
Two suspension systems - Front/Rear
Four air springs - One for each wheel
Another possible problem:
Your front wheels have a censor to indicate the height of the vehicle from the ground (basically). If this come unclipped, your system will think It's too high and will not add air to bring it to normal height. This usually happens on ONE side causing the vehicle to 'lean' or seem to. One side will have the wheel up in the wheel well, and the other will be a bit more gap between the wheel and the wheel well, but may seem to be 'low' too. On the side which is lowest, turn the wheel that direction and look on the front of the suspension arm for the sensor. it should be attached top and bottom.
If the clips have failed, there are no replacements available from the dealer, and replacement of the sensor is required.
Posted on Mar 17, 2009
SOURCE: cabin air filter, location
It's located on the engine compartment firewall, passenger-side. Open
the hood, stand by the right front wheel and you'll see the fasteners
to remove forward of the wipers. Fasteners are removed by pushing the
center in, then pulling them out. To replace. pull the center out,
replace it, then push it flush to lock.
Good luck and hope this helps.
Posted on Dec 14, 2009
Tips for a great answer:
Jun 04, 2015 | Cars & Trucks
Mar 26, 2014 | 1997 Lincoln Town Car
Aug 24, 2012 | 1997 Lincoln Town Car
Jul 12, 2012 | 1997 Chrysler Sebring
Nov 13, 2010 | 1996 Lincoln Town Car
Apr 01, 2010 | 1997 Lincoln Town Car
Dec 02, 2009 | 1997 Lincoln Town Car
Jul 09, 2009 | 1996 Lincoln Town Car
96 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: