a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
First... Read your owners manual - page 226 - Turn the ingnition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF position. Good luck and keep me posted.
engine oil pressure may be low remove oil pressure sending unit and install a pressure gauge check for pressure while warm if pressure is ok replace oil pressure sending unit oil pressure at idle should be between 5-15 psi at min
Hello daebbers: My name is Roger and I will be glad to help you. I assume by the way your question is written you have no objectionable engine noise. I would suspect a bad oil pressure sending unit. To check the switch will require a mechanical oil presser test. You can buy a kit at any parts store. With a cold engine. Remove the oil switch from the block. Install the mechanical gauge. after all connections are tight start the engine. Note where the pressure is at. Observe the pressure through engine warm up. As the oil and engine warm up the oil pressure will drop. According to All Data information the oil pressure at curb idle is 6 psi. This would be a min. oil pressure. If the oil pressure is higher then that is great also. Any thing less you have a internal oil leak. This would likely be a bearing issue.
PLease rate the quality of your answer. This way we know the answer you received was helpful.Should you need further help please just ask. Thank You for using Fix Ya. Roger
have the engine oil pressure checked with a mechanical guage, if it is about 15 PSI hot replace the sending unit for the guage, u will need to buy a special deep oil pressure sending unit socket for this job, they are made by KD and Lisle tools, they can be bought at NAPA.
If the engine is not making any knocking type noises, check the oil pressure sending unit. If it is leaking oil then it needs to be replaced along with removing the rubber plug from the connector and cleaning the terminals. If the oil light still comes on then the oil pressure is definately low and could cause engine failure.
you might try and change the pcv valve, my car hand a similar problem in the summer and i never changed it. the pressure blew my cam seal and i was leaking oil like crazy. i dont know if it will fix it but they are cheap. i would give it a try.
My friend that alarm is telling you u have low oil pressure, do you want to destroy the new engine?? Find out if the eng really has low oil pressure, it may just be a defective oil press sending unit causing the alarm, have the press checked with a mechanical guage or just replace the sender and see if that cures the issue, the alarm is part of the Body Control Module and can't be disconnected.