Question about 2005 Buick Rendezvous

Open Question

How do I replace the light in steering wheel radio control on my 2005 Buick Rendezvous

LED light is out on radio steering wheel control.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Replace Cruise Control Switch in Steering Wheel

I am describing the procedure for the "On/Off" switch, I did not try the one you mention. Buy the switch anywhere ( about $15 ), then use a sharp tool ( small knife, screwdriver, anything ) to gently pry the old one from its socket. It is not glued or screwed in or anything, just squeezed tightly in the socket. Once the switch is out, pull the cable, connect it to the new one, insert back in the socket and press gently. No force necessary, it comes out easily.

Posted on Jul 14, 2008

  • 1 Answer

SOURCE: 2003 Buick Rendezvous ignition problem

seems crazy but it worked for us!!! try hammer and Wd 40 - tap lighty

Posted on Nov 30, 2008

  • 7 Answers

SOURCE: Steering wheel lamps do not work (radio controls, temp, cruise)

The lights on the steering wheel are in the switches. To fix the lights, the whole switch needs to be replaced. Same thing goes for the Tempature Controls and radio. Overall, I think it would be very expensive to replace all of the switches to get the lights working. I have the same vehicle, and almost all of the lights are out.

I think the lights behind the gage controls are replaceable, although you still have to rip out most of the dash to get to them.

I have the auto-sense wipers, so I was leaving the wipers on all the time, and the would only work when needed. The bad part I finally found out about this was that while the wiper switch is on (even though they were not wiping), it caused all of the dash lights, switch lights and rear parking light to be on. I think this alone significantly cut down on the life of the bulb.

For now, I am just living without the lights. The temperature control is very expensive (just the part alone).

You can usually find the best price for these things at http://www.rockauto.com

Posted on Feb 22, 2009

  • 436 Answers

SOURCE: Buick Rendezvous 2002 need codes?

the BCM needs to be programmed to operate the computer. a GM techII is now required to calibrate BCM to airbag, stereo, keyless entry, and control pcm data. This is required to make it all work. a gm service should have it done within an hour or less just call and ask them how much it would be to program new BCM. it might cost @$75 to $125 but it is needed, to allow the BCM to work properly.

Posted on Sep 11, 2009

Testimonial: "ok...i bought the bcm on line (used)...but the gays in the dealer says i have to buy a new one..because the used cannot be to reflashed...or recoded."

  • 401 Answers

SOURCE: How do I replace the lights, radio controls on steering wheel.

there is no bulb you need to replace the switch in the steering wheel

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buick rendezvous 2002 from wheels, have 2 codes PO446 PO453


code p 0446 refers to evaporative emission (EVAP) system---vent control---circuit malfunction===causes --wiring---EVAP canister purge valve ---ECM
replace the purge valve
code p 0453 refers to EVAP pressure sensor --high input ===causes --wiring short to positive --EVAP pressure sensor ---ECM
replace the sensor

Nov 02, 2015 | 2005 Buick Rendezvous

1 Answer

Cruise control on 03 buick rendezvous won't engage, no light, replaced cruise control module?


Your best bet is to check what is happening by looking at cruise control data in the PCM and BCM. You will need a high end scan tool to do this. It could be as simple as a bad switch in the steering wheel or a brake switch that is bad or out of adjustment..

Aug 07, 2012 | 2006 Buick Rendezvous

1 Answer

My 2005 buick rendezous makes a whinning noise when turning the steering wheel


CHECK THE POWER STEERING FLUID.iF THE FLUID IS NOT LOW CHECK THE BELT. IF IT IS TIGHT THEN THE OWER SREERING PUMP IS FAILING

Feb 21, 2012 | 2005 Buick Rendezvous

1 Answer

How do you remove the remote radio controls from the steering wheel in a 2005 LeSabre?


First disconnect negative battery cable.
Then go behind steering wheel, there will be about 4 screws to remove, then the steering wheel can easily be pulled apart with no worries. Then unscrew unplug and pop out your controls.

Nov 30, 2009 | 2005 Buick LeSabre

1 Answer

How do I replace the lights, radio controls on steering wheel.


there is no bulb you need to replace the switch in the steering wheel

Nov 06, 2009 | 2001 Buick LeSabre

3 Answers

In my 2005 V6 Buick Rendezvous, the power steering has gradually gotten worse over past weeks. If I rev up the engine it steers fine. Going at higher speeds it is fine, but at low speeds I can barely turn...


6 weeks is less than 90 days so you should have a warranty for a different pump.

Remember to use the correct fluid for the car. If you have rack and pinion steering it can be a different problem besides the pump.

Get a front end alignment so they can check the balljoints which contribute to your problem.

Sep 25, 2009 | 2005 Buick Rendezvous

2 Answers

I need to replace the light bulbs for the steering


the switches in the steering wheel do not have bulbs, the switches have LED which lights up.
so if the lights in the switches are not working you'll need to replace the switches.

Jul 08, 2009 | 2005 Cadillac Escalade Esv

1 Answer

2005 gmc truck steering wheel radio control lights


If this is the lights for the switches in the steering wheel, these are LED's. The switches are made in such a way that it is prudent to replace the switch rather than try to take it apart and replace the LED. The switches are relatively inexpensive and are very easy to replace. While the LED's are rather inexpensive, the time that it would take to get the switch apart, replace the LED and then attempt to put it all back together is not worth the twenty to thirty bucks for a new switch.

I have replaced three of the four that are in my steering wheel. The hardest part to the whole thing is making the wiring connection in the back of the switch for the two large ones on the center crossbar. My fingers aren't quite slim enough to make the connection easily. I found using a pair of hemostats or some type of thin clamp with a handle works very well.

Oct 17, 2008 | 2005 GMC Sierra

Not finding what you are looking for?
2005 Buick Rendezvous Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...