Question about Cars & Trucks

Open Question

Lost instruction manual/leaflet for Wilkinson Cycle computer (wire free)

Unfortunately after letting batteries Run low and left in cold Garage after replacing batteries it has reset itself and I cannot find the Instructions.....any ideas......??

Posted by on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 334 Answers

SOURCE: 2001 Infiniti QX4 low beam bulb replacement instructions

Look directly behind the headlight box if there is a rubber sleave covering the plug take it off. Unplug the wires from the bulb, there may be a saftey clip you will have to pry up to get it off.after you get the plug off the bulb holder should twist counterclockwise then it will pull right off.When you change the bulb just remember to wipe your body oil off the bulb before attaching it back into the headlight box. Then plug it back in and your in business. The high beam has three wires and the low beam has two wires. The bulb will have to be the right one.
God Bless You Greg

Posted on Nov 25, 2008

  • 7 Answers

SOURCE: left rear wheel wobbles

easy remove rear diff cover spin until you see potruding bolt carefully remove large center pin should come out with tire ad either rotor or drum off pull axle straight out use bearing puller remove re-install reinstall all parts with new gear oil dont forget.

Posted on Apr 05, 2009

  • 1190 Answers

SOURCE: 05 vue ac problem, ac not cold at idle, blows cold

Hello, Are the cooling fan(s) coming on with the truck in park and the engine at idle? If the cooling fan(s) are not working A/C will not cool with truck setting still.

Posted on Oct 02, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What could be wrong? Our Gemini gate motor works well for some time, but then all of a sudden just go backwards when it should close the gate. It just revers with each attempt to let it go forward till at...

You could have dirty photo cells or some obstruction that the photocells are picking up that triggers the safety mechanism to reopen the gate so that no one gets hurt.

Extreme weather conditions (heat and cold) can damage the electronics in the photo cells too.

Are the batteries low on the transmitter?

Typically, photo cells are (or should be) wired to the control board so that it will stop the gate or barrier during the closing cycle should there be a problem- and should fully open again- just like on automatic garage door openers; it's the exact same principal.

Feb 28, 2015 | Cars & Trucks

1 Answer

My 2002 Honda odyssey went cold, used my friend cable n started the car. I observed the TCS and Engine lights came on.

after the battery go below 6.0V the computer lose the main memory settings and keep the malfunction for battery low. Just go to any auto parts store and let scan for free and reset the code.Make sure to replace the battery if yours is 4 years old and die on low temperature.

Jan 31, 2015 | 2002 Honda Odyssey

1 Answer

2003 buick regal,starts,runs but dies

Check coolant temp sensor. If bad, it will make computer think the engine is still cold, causing excessive fuel delivery and flooding. These sensors can be removed and tested (see instructions in shop manual)

Dec 17, 2014 | 2003 Buick Regal

1 Answer

I popped a brake line on my 1995 Nissan Pathfinder, unfortunately it's in a VERY expensive parking garage with ceilings so low it can't be towed out. Will the parking brake still work so I ca

Yes parking brake will still work. It is mechanical with a wire going from pedal/handle that when pulled squeezes the brake shoes round the rotor. Just go real slow and you should be alright. Hope this helped you.

Oct 17, 2012 | 1995 Nissan Pathfinder

1 Answer

04 elantra stalls when cold

No codes would point to fuel problem such as low pressure.
Was the car left overnight at the shop so it would be a cold start for the mechanic ?

Jul 01, 2012 | 2004 Hyundai Elantra

1 Answer

After having to replace my battery in my 2004 Chevrolet Trailblazer, my ac will not blow out the vents. It only blows out the floor and defrost vents. It also only blows out these areas whether its ac or...

You need to perform a hard computer reset. which you basically did when you removed the batter, but this time, disconnect the battery and let it run down, move the a/c switches into the off position, then reconnect the battery after about 10 minutes. turn the key to the on position but do not start the engine. leave it like this for two minutes, you will hear the a/c cycling. after the two minutes are up, start the vehicle and let it run a while, (30 seconds) then turn on the a/c to the cold temp and low fan speed setting, it should cycle and come out the vents. if not you have the common fault code that will have to be reworked by gm. but most times this is the easy cheap and free fix.

Aug 08, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

I have a 2006 Chevy Suburban. The first battery had 25000 miles on it and the vehicle would just die. We'd have to jump start it. I replaced the battery and that one has 30000 miles on it ans is having the...

Do you have an aftermarket alarm or stereo installed in the car? Often times incorrectly wired aftermarket electronics will have too high a residual current draw and will prematurely drain a battery. Unfortunately, sometimes correctly wired in aftermarket electronics will also do this.

Also, if you simply don't drive the car much and only take short trips when you do drive it will prematurely drain a battery. Actually, it's not so much that it prematurely drains the battery, but rather the battery doesn't have enough time to recharge itself after the starting load.

If the car is stock and is regularly driven, then it is likely a wiring issue somewhere or an interior light is being left on. Some cars have lights in the engine bay that are supposed to shut on when you pop the hood. In short, any sort of residual draw on the electrical system can, over time, kill a battery prematurely.

Also, if you live in a cold climate this will also effect the starting power of the battery. CCA on a battery means Cold Cranking Amps. The more CCA a battery has the more starting power it has when cold. If you don't drive the car much a deep cycle battery MAY potentially also help.

Jul 04, 2010 | Cars & Trucks

1 Answer

The abs light came on and air conditioner started blowing hot. After work the batt was dead. Jumped it and guages were dead for about 30 sec. About 10 miles later abs light went off and air got cold again....

It sounds like the engine is running on battery power only.The engine of today`s technology needs the alternator to have enough ignition to run on,lights and computer,etc,will be affected by low voltage,and amps.The alternator is not charging,look for a charging fuse to see if it is blown.If the fuse is fine,replace the alternator,and have the battery recharged on a slow 2 amp charge so it will recover it`s loss of deep cycle amps.This will prolong battery life and alternator.If I can help let me know.Let me know the out come.

Aug 29, 2009 | 2004 Ford F350

1 Answer

96 sable wagon keyless entry

Try re-programing the system.
These are the instructions from the service manual.

. Turn ignition from OFF to RUN 5 times within 10 seconds, with the 5th time ending
in RUN. Door locks will cycle to confirm programming mode.

2. Within 20 seconds press any button on first keyless remote. Door locks will cycle
to confirm programming.

3. Within 20 seconds, press any button on second keyless remote. Door locks will
cycle again to confirm programming.

4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

Mar 02, 2009 | 1996 Mercury Sable

1 Answer

1995 Cherokee heating (A/C) issue

sounds like you have a wire that has lost or burned off its cover and is grounding out the vehicle and has soon as its power is cut the wire breaks free from the bare metal and thats why you can immediatly start the vehicle

Dec 30, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides