Question about 1995 Toyota 4Runner

Open Question

1992 Toyota 4runner 3.0 V6 leaking water out of front of engine

4runner leaking water out of front of engine around water pump area. Water pump and thermostat have been replaced ????????????????????????????????/

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ninja_freak3
  • 168 Answers

SOURCE: need instructions to installing water pump on 1992 toyota camry.

e-mail e and we will talk about it

Posted on Dec 23, 2008

Ad
  • 2 Answers

SOURCE: toyota estima 2.2 td 1992 van overheating

the impellors in the water pump are prone to corrosion,especially if no or incorrect radiator additives have been used .this will cause water to stay in motor & boil whilst the water in the radiator stays cold because it cannot circulate.try flushing radiator ,installing a new thermostat (which is more than likely not opening )& radiator cap,refil with correct additive,.if the car still over heats then you will need to replace the water pump.bugger!!

Posted on Feb 06, 2009

  • 17 Answers

SOURCE: 4runner will not start seems not to be getting fuel

Yes check the fuel pump there might be something stuck in there. Maybe there is something small in there. Take it out and blow into it to see.  Hope This helps (Please Take The Time To Rate Me)

Posted on Mar 15, 2009

  • 88 Answers

SOURCE: Location of Water Pump and Thermostat

The water pump run right of the pulley, it would be the pully with the hose running off it. then you can follow that hose to the thermostat housing.

Posted on May 20, 2009

  • 11 Answers

SOURCE: coolant leaking

Hello Kasalama :

Is it possible to wash off the engine while protecting the distribuutor and other electronics so we can start with a clean and dry engine ? . * Make sure that your radiator is full and that the Radiator/ Coolant overflow reservoir is at the proper level . * I would put a large piece of cardboard on the floor and along with a bright flash light or shop light use it to guide you where the leak s coming from .

If that is not helpful , I would perform a pressure check on the cooling system . The pressure check can be performed as a diagnostic tool . Put the truck in park and apply the parking brake . Attach the pressure diapham and Start the engine . You will have to manually pump it to a specified pressure as indicated on the gauge/ manometer .

The pressure diaphram usally attaches where the " radiator cap " is . Applying pressure can show leaking hoses, pipes and leaks in the radiator or fittings .

Be mindful that you can also have a leaking Intake manifold Gasket .

I hope that this info has been of help to you .

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1991 Toyota 4runner, leaking water & over heating; so I replaced the radiator, still leaking & over heating; I replaced the thermostat, still leaking; put in a new water pump, now it's...


you really need to locate where the leak is coming from, but other areas to check would be the freeze plugs , hoes, heater core, or headgasket

Jul 10, 2014 | Toyota 4Runner Cars & Trucks

1 Answer

Will it hurt to run a 92 toyota 4runner with out a thermastate in it


Not at all. Just make sure the thermostat civer is sealed so you dont leak coolant. If you are overheating, has the waterpump been changed and the timing belt, since the water pump is timing belt driven.

May 11, 2014 | 1992 Toyota 4Runner

1 Answer

I have replaced the knock sensor, water pump,intake manifold, thermostat, timing belts in my 1992 toyota forerunner v6. its not showing that it's overheating but the water in the radiator and overflow...


system is air locked. find the highest holes in system loosen clamp too let air esape. some systems have air valve in line some were for this. check heater for heat, no heat, no water, bleed heater core holes. you can park on hill with front of engine up. keep in mind if engine is side ways put front of engine on high side of hill. check to see if fan is working good luck

Jan 31, 2018 | 1995 Toyota 4Runner

1 Answer

Water leaking underneath the motor


A little leakage is normal. Also the A/C will drip water, but that comes down from the firewall area.

From the motor, it may indicate a leaky water pump. This will drip from the front of the engine which is the right side as the driver looks. The pump is located under the timing belt cover.

Also check all your large hoses to see if a leak has developed at any joint.

The V6 engine often develops a water leak under the intake manifold which is hard to see. The water appears on top of the transmission. Camrys will often also get a split in the plastic radiator top tank, so look there.

If you are not losing large amounts of water, you have a while to track it down at leisure !

Feb 07, 2012 | 1994 Toyota Camry

1 Answer

WHERE IS THE WATER PUMP LOCATED ON A 1992 TOYOTA PICKUP


are u sure it's the water pump? If u have water coming from under the fan it sounds more like your radiator

Nov 19, 2011 | 1992 Toyota Camry V6

1 Answer

1992 Toyota 4Runner, overheats, radiator,upper and lower hoses and thermostat new. Water pump has about 10,000 miles. upper hose heats up, lower hose stays cold. Heater blows only cold air. Help


Thanks for choosing FixYa and welcome to the site. Have you checked to see if it is a coolant sensor? Have you checked to make sure the fans are coming on? Are you leaking coolant anywhere? Checked the cap?

Apr 10, 2011 | 1992 Toyota 4Runner

1 Answer

Overheating with no heat coming out of the vents. A leak directly under the thermostat. Replaced the thermostat and still have the problem. Engine oil looks normal so its not a crack head. What is the...


the water pump is usually under the thermostat, sounds like a bad water pump, but the first thing i would be sure of is that none of the hoses are leaking

Jan 12, 2011 | 1991 Toyota 4Runner

2 Answers

My 1999 Alero must have a leak somewhere because the thermostat gauge rises every few days. I put coolant in it at least 1 a week. I had a new water pump and thermostat put on it, but it is still...


CHECK AROUND WATER PUMP AREA.AND THERMOSTAT HOUSING FOR LEAKS.THE MECHANIC WHO PUT THE WATER PUMP ON MAY FORGOT TO PUT SEALANT ON BOTH SIDES OF THE WATER PUMP GASKET CAUSING LEAKS.LOOK AROUND THERMOSTAT HOUSING FOR LEAKING.IF THERMOSTAT SEAL WAS DAMAGE DURING INSTALLATION IT WILL CAUSE LEAKING.IF ALL LOOKS GOOD CHECK FOR COOLANT LEAKS AROUND RADIATOR .CHECK RADIATOR TOP AND BOTTOM HOSES FOR LEAKS AND CHECK HEATER PIPES AND HEATER CORES HOSES FOR LEAKS.IF ALL HOSES GOOD.CHECK FOR LEAKING CORE PLUGS.

Sep 26, 2010 | 1999 Oldsmobile Alero

2 Answers

WHAT IS THE COST OF REPAIR ON A HEAD GASKET FOR A 2003 toyota 4runner v6 . it is not blown yet but every oil change i have to fill the coolant reservoir so every 3000 miles


Hello, and welcome to FixYa. Please allow me to assist you.

More often than not, head gasket failures will result in an immediate overheat condition, and you will see billowing clouds of white smoke coming from the tailpipe.

To answer your question, the time to replace both head gaskets is about 10-12 hrs, at your local labour rate. My service department would charge 900 dollars labour. Then, figure about an additional 3-400 dollars in a gasket set, oil, filter, coolant and any machine-shop work that would be needed to true the cylinder head mating surfaces.

Before you do any of that...

Personally, I would suggest that you inspect the water pump on your vehicle. This is where you are most likely going to find you leak. 4Runner V-6s are known for the impeller shaft seal on the water pump to leak. To see/inspect the water pump, you will have to remove all of the plastic covers that are fitted to the front of the engine. Once they are all removed, you will see the water pump in the center of the cylinder block. If you see any evidence of pink or white crusty materials on or under the pump, you have found your problem...and, it is MUCH cheaper to change the pump, as opposed to doing the head gaskets.

I hope this helps you out.

Thanks for choosing FixYa for assistance today.

Apr 21, 2010 | 2003 Toyota 4Runner

1 Answer

I have a 04 VW Beetle with a 2.0. Just replaced the thermostat. Now it is leaking coolant badly. I have checked and seems to be comming from the middle of the engine. I have checked both the thermostat and...


If it is not coming out of any hose connection, and it is in the middle front area...it is most likely the water pump. You may be able to get a look at the pump, which is run by the timing belt. The pump mounts behind its rear cover unfortunately. Some water pumps have a small hole that you can check for water leaking out to indicate it is bad. If not, you will have to remove the timing belt rear cover to check the water pump gasket area for water leaks.
A head gasket is not likely unless you find water in your oil.
Good Luck!

Feb 24, 2010 | 2004 Volkswagen New Beetle Convertible

Not finding what you are looking for?
1995 Toyota 4Runner Logo

Related Topics:

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...