Question about 1998 Chevrolet Monte Carlo

Open Question

99 monte carlo door wont close the latch wont move

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76630 Answers

SOURCE: 2004 monte carlo sunroof won't close

THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.

Posted on Dec 11, 2008

Ad
blueextc3221
  • 15935 Answers

SOURCE: Driver's side door not latching / closing

pull the outside handle and unlatch the latching assembly by hand by insertins a screwdriver where the striker would normally be if the door were closed - and pry out.

You can adjust the striker by loosening the bolts, and moving it in toward the cabin.

If the door itself is droopy, adjustments are made by the hinge by loosening the bolts and lifting up or down.

Multiple attempts will be necessary to get it just right.

Dont get frustrated if it doesnt fit properly in the 1st or second attempt.
Good Luck!!

Posted on Jan 16, 2009

dealt_soul
  • 296 Answers

SOURCE: 99 cavalier drivers door wont latch without force

If there is no resistence to the latch then it will have to be replaced.

Posted on Feb 15, 2009

  • 436 Answers

SOURCE: 99 chevy monte carlo error code p0446

well this code is related to the fuel venting system. generally it is an error in the gas cap, evap vent valve, purge valve, or just a small leak in the vent line itself. I would suggest a smoke test that checks these systems. Not all garages will do them. you will have to call around. The test usually cost around $50-$60 but it is worth the cost because it prevents you from changing the wrong parts

Posted on Aug 22, 2009

Testimonial: "THANKS "

SOURCE: 2002 monte carlo fuel gauge doesnt work,pump works ok.

It is likely the fuel level sending unit. I had a customer with an 03 Monte Carlo that the pump went out and the fuel gauge hadn't worked in about a year. We replaced the fuel pump module and it took care of both problems. I believe the sending unit is available separately from the complete module.

Posted on Jan 10, 2010

Testimonial: "Works Perfect Now:::Thnks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When it's cold out my doors won't stay closed


lubricate all door latches and hinges (GENEROUSLY) with WD 40, repeatedly open and close doors until latches are working good.
After doors are closing as they should respray all latches and hinges with lithium grease. If this does not work replace latches and have door hinge pins checked.
2009 Hyundai Accent grease and lube all latches
How To Fix Sagging Door Replace Hinge Pin Bushings Monte Carlo Grand Prix

Jan 10, 2016 | 1993 Dodge Dynasty

1 Answer

Having trouble opening the hood on 99 monte carlo


Have someone pull on the release, while you press down on the hood

Once open --do not close it--until you wash down or spray solvent
on all latch parts & then lightly lube moving parts

Under the hood is a round part with a spring

All that has to be cleaned as well & you lube the part under the
spring

Aug 12, 2014 | 1999 Chevrolet Monte Carlo

1 Answer

How do you open the hood of a 99 Chevy Monte Carlo after you pull the inside lever....


When you pull the handle, the hood pops up so you can reach in from the front of your Monte Carlo and release the latch to raise the hood

Jun 10, 2013 | 1999 Chevrolet Monte Carlo

1 Answer

I HAVE A 2000 MONTE CARLO.. HAVING TROUBLE MOVING THE PASSENGER SIDE DOOR LATCH, NEED TO KNO HOW TO FIX THE PROBLEM


You need to knock the latch back to the open position by holding the open handle open and prising the latch outwards if that doesn't work you need to take the door panel off and repair or replace the latch assembles.good luck

Nov 22, 2012 | Cars & Trucks

1 Answer

Driver side door on '95 monte carlo will not latch/shut. I live in central MN, last night was cold, windy, advisories were out ...i dont believe there is anything in way, just seem like door isnt lining up...


TRY SPRAYING SOME WD-40 ON THE LATCH! MN DOES GET EXTREMELY COLD IN THE WINTER! MOISTURE CAN GET IN THE LATCHES, AND CAUSE THEM TO STICK! IT IS RECOMMENDED TO SPRAY A LUBRICANT LIKE WD-40 IN ALL LATCHES (I.E. HOOD, DOORS, AND TRUNK, TO KEEP THEM FREE OF RUST, AND DEBRIS!

Mar 12, 2011 | 1995 Chevrolet Monte Carlo

1 Answer

Drivers side door wont shut. how do you replace the part that latches


Before you go about changing the latch, make sure that the latch is fully open. This can be done by pulling the latch teeth inward towards the drivers seat with a screwdriver, while releasing the door opener handle at the same time. Often these large heavier doors become out of alignment at the hinge side causing the latch to close prematurely. If you are able to accomplish this task, lubricate the entire latch with white spray lithium grease. Keep in mind that the latch has two settings. The first is to catch the door(for safety) and the second is to secure the door. Thank you, Dana

Feb 28, 2010 | 1997 Chevrolet Monte Carlo

1 Answer

Driver side door will not close may be a broken bolt how do i fix this


Seems as though your door latch may have closed without having the door closed.

1. Use a screw driver of any kind to simulate the door latch pin. Stick this into the latch and put a small amount of tension on the latch pulling it to the inside of the car and actuate the door handle.

What you are trying to do is get the latch to move to it open door position. It might help to look at one of the other doors latches with the door open so you can better see this demonstrated and compare with your malfunctioning door.

If this all works out - make sure you take the time to lubricate the door latch assembly to prevent future problems of this sort..

Jan 29, 2010 | 1997 Chevrolet Monte Carlo

1 Answer

My driver side door lock on 1997 Monte Carlo will not engage. Basicaaly can't close door. Help low on money.


There are small springs inside the door latch that can either break of fall off. You need to remove the door panel and repair/replace the latch mechanism

Jan 02, 2010 | 1997 Chevrolet Monte Carlo

1 Answer

Passanger door wont open!


The rod that connect the latch to the handle has become disconnected. the door panel needs to come off. You should see a rod hanging helplessly away from the actual latch mechanism. Using the point that the rod is still attached to as a center point... rotate the rod and look for the plastic connector for the rod to reconnect. This will be a small plastic part with a clip that secures the rod in the anchor point.

Apr 26, 2009 | 1998 Chevrolet Monte Carlo

1 Answer

Hood wont latch down


lubricate the hood latch

Jan 25, 2009 | 1996 Chevrolet Monte Carlo

Not finding what you are looking for?
1998 Chevrolet Monte Carlo Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...