Question about 2002 Chevrolet Impala

Open Question

Were is the ecm located 2002 chevy impala - 2002 Chevrolet Impala

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2002 chevy impala o2 location?

it is locared on the driver side on top of the transmision

Posted on Feb 27, 2009

  • 1596 Answers

SOURCE: can't find oil sending unit on my 3.4L 2002 chevy impala

Location for OIL PRESSURE SENSOR'S are, on Engine BLOCK At 90 degree angle BEHIND OIL FILTER , And One Just Above the Starter Poking out Same Direction as OIL FILTER, I would Suggest that you Replace Both at the same time, this IS NOT MANDATORY, But I have found it to be a time-saver and Sometimes it IS Necessary to replace them Both. I Speak from 30 years to date of Experience turning them Wrenches LoL.
I hope this is Of GOOD HELP to You, And Please dont forget to RATE US on Our Answers. Good Luck ! ,RejakWilson

Posted on Apr 07, 2009

  • 4 Answers

SOURCE: 2002 Chevy Impala Blower resistor location

It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike

Posted on Apr 20, 2009

hondakilla
  • 129 Answers

SOURCE: ECM Location

For one i dont need your vin its a z24 which means it has a 2.4l engine it does not have an ECM it has a PCM powertrain control module, which is located for your car in the right rear corner topside of your engine bay, in 1995-2001 it is located inside the right front fender. I hope this info helps...

Posted on May 02, 2009

  • 3 Answers

SOURCE: turn signals on my 2002 chevy impala stop working

The relay switch is a plug-in located inside the dash near the tach about 2 O'Clock You will need to open the dash panel to replace it and your turn signals will work.

Posted on Dec 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the 02 chevy impala 3.8L o2 sensor locations, I only see three. the top bank one sensor 1 is stripped out, how do i get that one out?


you can apply pressure to the sensor while undoing it to force it out or you will have to cut out the thread area and get an O2 sensor bung hole replacement at an auto supply store and weld into place and install a new O2 sensor. bank 1 sensor 1 is located in the front pipe off the manifold that has cylinder #1 on and bank 2 sensor 1 is on the side that cylinder #2 is on like sensor 1. sensor 3 is the one just before the cat.

Sep 17, 2014 | 2002 Chevrolet Impala

1 Answer

Have a 2002 chevy impala with a 3.4L V6 that needs an oxygen sensor. Is there any way to tell which one and where are they located??


Have it scanned from any parts place for free and also ask them for a print out of the location.

Oct 12, 2011 | 2002 Chevrolet Impala

1 Answer

Where is the egr valve located in my 2002 chevy impala 3.4


the EGR valve is located at the rear of the upper intake manifold, on the driver's side. It is electrically controlled and has a black plastic looking cylindrical cap with a wire connector at the top.

Feb 11, 2011 | 2002 Chevrolet Impala

1 Answer

Where is the ecu located on a 2002 chevy impala


In front of the air filter box under the hood.

Sep 11, 2010 | 2002 Chevrolet Impala

1 Answer

Where is the low pressure port located on a 2002 chevy impala?


My 200 impala with 3.8L.... the low port is located on the firewall need the red transmission dipstick.
see picture at: http://s2.photobucket.com/albums/y48/ZeeVert/2002%20Impala/ac%20condensor/?action=view&current=P1190272.jpg

May 21, 2010 | 2002 Chevrolet Impala

1 Answer

Whee is the passlock located on a 2002 chevy impala


it is integral to the body control module

Nov 10, 2009 | 2002 Chevrolet Impala

1 Answer

2002 Chevy Impala Sensor # 3


You didn't give the engine size, so I'll give what my manual shows.
The 3.4L engine----- 2nd one in from the left, in back of the engine.
The 3.8L engine------2nd one in from the left, in front of the engine.

Mar 12, 2009 | 2002 Chevrolet Impala

1 Answer

2002 chevy impala o2 location?


it is locared on the driver side on top of the transmision

Feb 26, 2009 | 2002 Chevrolet Impala

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...