Question about 1994 Dodge Intrepid

1 Answer

1994 dodge intrepid has no spark unless temp is above 40 degrees

Changed crank sensor
changed battery

Posted by on

  • Anonymous Mar 16, 2014

    2003 dodge diesel wont start at temps less than 30 degrees unless you plug it in



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Check the connector at the coil pack/module. Four wire connector that supplies the coil pack with power and signal from crankshaft sensor.

Posted on Feb 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

4 Answers

Dodge intrepid 1997 not getting spark i changed computer and still wont start

Check the wiring that runs near the coil. There are a few thin wires in the group that become frail..move them around while someone is turning the key. You may be surprised.

Mar 20, 2010 | 1997 Dodge Intrepid

1 Answer

My sons 94 intrepid w 3.5 is dumping fuel in exhaust. we replaced map sensor no luck. what else could do this?

have the coolant temp sensor checked, if it is faulty the computer will think it is -40 when starting and running and add more fuel acording to the ambient temperature.

Jan 25, 2010 | 1994 Dodge Intrepid

1 Answer

Where is the crank sensor on a 1993 dodge intrepid 3.3?

The crank position sensor on a 1993-1997 intrepid is located on the passenger side of the transmission bell housing ( top ) breeze to change and usally fixes the cold starting issue with these automobiles ( usally ) for $40 or less it is worth a try!!!!!

Oct 26, 2009 | 1994 Dodge Intrepid

1 Answer

I have a 1994 dodge intrepid with the 3.3 motor and it make the crank sensor go bad after about 10 miles of driving then it quits. if you put a new crank sensor in it will start back up and run for about...

Check your Ground connetions from the battery to frame and frame to battery also check your battery to see if the cables are clean and you have no resistance, There should not be more than .2 ohms resistance on any ground. As well check the chargeing output of the altanator. is it less than 13.5 volts or above 14.5 volts? if so then you need to see if the battery has a shorted cell, and test battery voltage. These are all things that you can do yourself for free. then we can go to the next step. You can also go to this web site and get the repair manual online and look this up and see if there is a recall on this problem. One last thing it also could be a crank bearing going out. Did you set the correct air gap on it? Let me know if you need more help and thanks for using Fix-ya, if this helped please rate.

Aug 24, 2009 | 1994 Dodge Intrepid

2 Answers

1994 dodge intrepid has no spark

did you check the distrubuter cap?

Jan 12, 2009 | 1994 Dodge Intrepid

2 Answers

How do u know if a crank sensor is bad on a 1994 dodge intrepid?

Check to see if you have any rpms on your tachometer in the car during engine crank. If you do sensor is probably fine but if your needle doesn't move at all sensor is bad. Your problem might be the same as mine at the coil pack/module connector. Four wire connector that was not getting a good connection. I got very lucky to have found this.

Jan 08, 2009 | 1994 Dodge Intrepid

2 Answers

My 1994 dodge intrepid only starts when it is above 40 degrees

I had a very similar problem as most did on this stalling out, no start, and no spark on my 1994 Dodge Intrepid 3.3L V6. I was told to watch my Tachometer in the car to see if it moved at all while cranking the engine over. It did not move. So that told me the crankshaft sensor was not picking up any signal what so ever. I changed it. The engine immediately started. So I left the engine run for approx. 25 minutes then the engine died. I had again lost spark but had minor RPM on the tachometer during engine crank. I dug thru all the wiring harnesses and found that when I moved the connector to the Coil pack/Module the engine would start. I got the problem narrowed down to the connector but have not replaced it yet. I put a little slack in the harness the wires run in so the harness is not pulling on the connector. This has seemed to solve the problem for me. At least for now.

Jan 08, 2009 | 1994 Dodge Intrepid

2 Answers

Tempature dropped car wont start

Check the voltage on your battery with a voltmeter should be at least 12 volts without any power hooked up to it.

Pull a spark plug wire off of the coil, have someone crank the starter and hold the plug wire very close to the coil (same place you pulled the wire from) to see if there is a spark. Be careful and stay away from the engine will it is cranking

Charge the battery.

Check altenator belt and connections.

warm the car or battery (can you get the car in your garage?)

Dec 25, 2008 | 1994 Dodge Intrepid

Not finding what you are looking for?
1994 Dodge Intrepid Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides