Question about 2006 Chevrolet Impala

Open Question

How do i remove the top dash cover for 2006 chevy impala?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76132 Answers

SOURCE: How do I program my key for my 2006 Chevy Impala?

Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

Posted on May 20, 2009

Ad
  • 7353 Answers

SOURCE: 2006 chevy impala clogged catalytic converter

only if its under 3 yr / 36000 mile warranty. if the engine has been running bad, check eng light on/flashing / rich ect, that needs to be repaired, thats what causes the cat to clog up.

Posted on Oct 21, 2009

dennymulford
  • 1055 Answers

SOURCE: installing door mirror,right side,2006 chevy impala,no heater

yes yo do should be 2 bolts in the arm rest too remove then the rest of the panel just clips on!!!

Posted on Nov 13, 2009

motor1258
  • 6674 Answers

SOURCE: 2006 Chevy Impala reduced engine power

best bet is to stop in at a Pep Boys, Autozone, or similar big autoparts seller, and ask for free trouble code scan, which should pinpoint area causing problem. If not obvious by codes, what is necessary to repair the problem code, get back to us with those codes and we will be glad to assist you further. Better this way, takes away the guess work, and saves you money, as well as getting it right the first time.

Posted on Dec 12, 2009

  • 2 Answers

SOURCE: My 2006 chevy impala dash

This is the Compas reading, In your manual you will see what geographic zone you are in. follow the instructions. enter the zone drive in a circle and the compass will set itself correctly.

Posted on Dec 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2003 chevy impala. When you turn the switch to heat or defrost the air still comes out of the front vents. Winter is coming


some of the dash may need removal to fix that
not a normal service or maintenance job

faulty directional flaps /or switch levers ?

directional flaps either motorized or vacuum actuators

an example 2003 will be close to this set up
How To Replace Chevy Heat Door Actuator Impala 2006 2013
26318874-eqnsd0j5dazk1edooe0d0ozr-3-0.jpg

Oct 19, 2016 | 2003 Chevrolet Impala

1 Answer

How to replace right front fender on a2007 replace fender 2007 chevy impala


There are four bolts and the hood hinge to remove on top. Remove the tire, remove the inner fender cover( seven or eight screws). There are two bolts to remove the fender from the front bumper cover. And one bolt to remove from inside the door( open the door, remove the cloth, the bolt is close to the top). Replace in reverse.

Oct 09, 2014 | 2007 Chevrolet Impala

1 Answer

I have a 2006 chevy impala ls,my dash says this"ENGINE HOT/AC OFF"what should I do?


NEED TO have checked out the engine is running too hot. possibly low in coolant or thermostat sticking.

May 02, 2011 | 2006 Chevrolet Impala

3 Answers

How do you replace a heater core on a 95 impala ss


How to Replace the Heater Corein a Chevy Impala

Replacing your Chevy Impala'sheater core is no easy task. There are several parts you must carefully removeor reposition to disconnect the core from the heating, ventilating and airconditioning (HVAC) module. This module and the core are located behind thecar's floor ducts.

1. Jack up the car and drain the Impala's cooling system.Loosen the water pump's drain bolt and let the coolant drain into a pan. Closethe drain bolt and lower the car afterward. 2. Remove the heater outlet and inlet hose from theheater core (reposition the hose clamps to do so). Take off the right consoleextension panel, body control module and left side extension panel on the frontfloor console 3. Disconnect the leftinstrument center support bracket (pull away the carpet at its bottom to reachthe nuts). Remove the accelerator control pedal from its position in the frontof the dash. 4. Disengage the center floorducts by raising the outlet duct while pushing the ducts down. Rotate theoutlet duct forward in the car and pull down to remove it from the HVAC module. 5. Use a small chisel to removeall the heat stakes from the heater core cover. Loosen the nut behind the fuelline bracket. Remove the dash panel's stud at the heater hoses. 6. Pull the core's cover downenough to reach the HVAC module's locating pins. Slide the cover rearward untilthe drain tube clears the dash front. Remove the cover by sliding it down,rearward, and to the right. You can now remove the core.
Installing the New Core
1. Install the new core into the HVAC module,attaching a new seal onto the drain tube. Attach the core cover from the rightside, sliding it up and forward into position. 2. Align the draintube with the front dash hole and the core cover holes with the HVAC locatingpins. Install the core cover screws, cutting and folding back the soundinsulator near the center screw to ease that screw's installation. 3. Reinstall the dash panel stud at theheater hoses, tightening the nut behind the fuel line bracket. Align the centerfloor duct with the HVAC and push it up while rotating rearward to install it.Put the floor ducts and outlet duct back into the Chevy Impala. 4. Attach theaccelerator control pedal. Pull the carpet back and position the left centersupport bracket, then tighten the bracket nuts. 5. Reconnect theleft side front floor console extension panel and the body control module tothe car. 6. Put on the outlethose and inlet hoses to the core, securing them with their clamps. Refill thecooling system with the proper mixture of water and coolant.
Read more: How to Replace the Heater Core in a Chevy Impala ' eHow.com

Nov 10, 2010 | 1996 Chevrolet Impala SS

2 Answers

The dash panel on my car keeps telling me to tighten my gas cap,


Assuming you mean the gas cap being replaced, this can also be the result of a vacuum leak. Look around on the engine and see if there are any vacuum hoses related to the fuel system. If your engine has a plastic cover it is under that. Remove the cover. Most are held down by the oil fill tube which generally unscrews, sometimes reverse threaded.

Apr 01, 2010 | 2006 Chevrolet Impala

2 Answers

Engine power is reduced keeps showing on the dash screen, as does service traction control. the car is running rough and has no power when this occurs.


how do you fix the "reduced engine power" light on the dash bard of a 07 Chevy Impala LTZ and "Service Traction Control"?

Feb 12, 2010 | 2006 Chevrolet Impala

2 Answers

Chevy impala 06 radio just qont turn on


Probably radio if fuses are not blown,see owners manual for fuse locations.should be 2,those model gm radios are natorious for internal failure. If radio is problem do keywork search for LKQ or Greenleaf,both supply low mileage parts including radios with good warranty,will ship anywhere.Insurance companies use them.

Jun 18, 2009 | 2006 Chevrolet Impala

1 Answer

Heater core


HI. This is not an easy job but, im sure you will be able to accomplish this with a little guidance. I have put together a guide for you to follow. Its a step by step guide and, it will help you with this replacement of your heater core.


REMOVING THE OLD CORE--

#
Step 1

Jack up the car and drain the Impala's cooling system. Loosen the water pump's drain bolt and let the coolant drain into a pan. Close the drain bolt and lower the car afterward.
#
Step 2

Remove the heater outlet and inlet hose from the heater core (reposition the hose clamps to do so). Take off the right console extension panel, body control module and left side extension panel on the front floor console
#
Step 3

Disconnect the left instrument center support bracket (pull away the carpet at its bottom to reach the nuts). Remove the accelerator control pedal from its position in the front of the dash.
#
Step 4

Disengage the center floor ducts by raising the outlet duct while pushing the ducts down. Rotate the outlet duct forward in the car and pull down to remove it from the HVAC module.
#
Step 5

Use a small chisel to remove all the heat stakes from the heater core cover. Loosen the nut behind the fuel line bracket. Remove the dash panel's stud at the heater hoses.
#
Step 6

Pull the core's cover down enough to reach the HVAC module's locating pins. Slide the cover rearward until the drain tube clears the dash front. Remove the cover by sliding it down, rearward, and to the right. You can now remove the core.
Installing the New Core


INSTALLING THE NEW CORE---

#
Step 1

Install the new core into the HVAC module, attaching a new seal onto the drain tube. Attach the core cover from the right side, sliding it up and forward into position.
#
Step 2

Align the drain tube with the front dash hole and the core cover holes with the HVAC locating pins. Install the core cover screws, cutting and folding back the sound insulator near the center screw to ease that screw's installation.
#
Step 3

Reinstall the dash panel stud at the heater hoses, tightening the nut behind the fuel line bracket. Align the center floor duct with the HVAC and push it up while rotating rearward to install it. Put the floor ducts and outlet duct back into the Chevy Impala.
#
Step 4

Attach the accelerator control pedal. Pull the carpet back and position the left center support bracket, then tighten the bracket nuts.
#
Step 5

Reconnect the left side front floor console extension panel and the body control module to the car.
#
Step 6

Put on the outlet hose and inlet hoses to the core, securing them with their clamps. Refill the cooling system with the proper mixture of water and coolant.


Inspect the foam seal for the core on the lower HVAC case. Replace it with adhesive black foam tape if damaged.

Please rate and have a good day:)

May 06, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
2006 Chevrolet Impala Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...