Question about 2006 Jeep Commander

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Check for power in and out of starter relay.Check power at starter (large terminal hot at all times, smaller one hot with key in start position.) Make sure battery terminals are clean ON inside where it matters and check connections on the other ends of battery wiring as well. Breaker should have continuity as well. If power is present at starter, likely starter has failed, but do not condemn till everything has been tested. I assume battery and charging system are in good condition?

Posted on Jan 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car won't start on a 2006 Chrysler 300c hemi. Turns over but will not start

hi Eddie.
see if this helps you out.
Why car won start troubleshooting tips
Why does my car sometimes fail to start?

What does it mean when your car cranks but wont start?
A less common cause is a worn starter that draws so many amps while cranking the engine that there's not enough juice left to adequately power the ignition system and fuel injectors. ... If there's a spark when the engine is cranked, it has ignition. The problem is either fuel or compression.

Problem 5: Engine Cranks But won't Start - AutoTap Search for: What does it mean when your car cranks but wont start?
TROUBLESHOOTING A CAR THAT WON'T STARTDid you ever consider those wonderful days when your car won't start? If you left your lights, radio, or some other electrical gizmo on after you parked the car, you know what the trouble is: Your battery is dead. Of course, there are other possible reasons that your car won't start.WON'T-START SYMPTOMSYour car may not start for a number of reasons. The following list outlines the most common circumstances and tells you what action you can take to try to remedy each situation:The car is silent when you turn the key in the ignition. Check the battery terminal cable connections. (See How to Check Your Car Battery.) If they look very corroded, force the point of a screwdriver (with an insulated or wooden handle) between the connector and the terminal post and twist it to lodge it firmly. Then try to start the engine. If it starts, you need to clean or replace your cables.The car makes a clicking noise but won't start. This sound usually means a dead battery. If not, check the wiring to and from the starter for a loose connection.The car cranks over but won't start. Check the fuel supply to your engine. If that's okay, check whether the electrical spark is getting to your spark plugs.The engine starts but dies. If your car has a carburetor, check your carburetor adjustment and your choke to see whether the choke is first closing and then opening. If you have fuel injection, you'll need professional help.The car won't start on rainy days. Check inside the distributor cap for dampness. If you find moisture, get some mechanic's solvent from your friendly service station - they use it to clean car parts - or buy an aerosol can of it at an auto supply store. To evaporate any dampness inside the distributor cap, turn the cap upside down and pour or spray some solvent into it. Swish it around and pour it out. Then dry the cap as best you can with a clean, lint-free rag and replace the cap.

if none of the above is the problem then try this link might help you out more.
Car won start Google Search

Nov 22, 2017 | Chrysler Cars & Trucks

1 Answer

My 2006 dodge 2500 5.7ltr hemi starter just clicks and won't turn over

is it an advance auto starter cause their electrical parts are known for that

Feb 14, 2013 | 2006 Dodge Ram 2500

1 Answer

Hard Starting Issue

Just went through similar deal 06 mega cab 5.7 hemi everybody was tellin me it was the TIPM Total intigrated power module. I changed my fuel pump and been running good since make sure all connections are good going into the tipm

Aug 20, 2012 | Cars & Trucks

2 Answers

Drove car thru water. Car died instantaly. water was knee deep. Pushed car out of water. will not turn over now.???

when you say it won`t turn over do you mean it tries to turn over with the starter or it won`t start.if you mean it won`t turn over then when it dries out a bit(water has drained from electrical components)try it again.if it still wont then its possible it may have sucked up water into the cylinder.pull the plugs and try to turn the motor over.if it does then this is the problem.if you mean it won`t start then let it dry still for water in a component may cause electrical issues when wet.just suggestions.

Apr 28, 2011 | 1997 Saturn SL

2 Answers

I have a 1998 Dodge Grand Caravan. Some time ago, the intermittent part of the wipers stopped working. Then, one power rear window and then the other stopped working (about 4-5 weeks apart). Now, the...

You're accumulating problems over time.They're not related.

The heat/air blower fan problem is a bad blower (variable) resistor n the blower fan control.

The power windows are either fuses blown or regulator motors dead - check your power accessory fuses and go from there to check the regulator motors - try junk yard(s) before paying for as new window regulator.

The intermittent feature of the wipers - check/replace the switch that controls this feature (the most likely cause).

THe problem with ALL your dashboard electrical items failing at once, then coming back to life after a restart is a 12V breaker (not a fuse) in your fuse panel - it looks like a relay, but your maintenance manual (Haynes Manuals - $20 everywhere) will identify it as a breaker - its sticking in the "off" state and needs to be replaced, OR I SUSPECT THAT: moisture gets into the car somewhere and causes the breaker to TRIP to prevent the resultant short from burning up your mini-van in a brightly-lit vehicle fire, and when you turn the van on, the breaker is tripped - you restart the vehicle,(which turns out to be the proper procedure to reset a 12V breaker), and the breaker resets, and you drive off with working dashboard controls.

Oct 08, 2010 | 1998 Dodge Grand Caravan

1 Answer

06 jeep commander wont crank. No interior lights, no headlights, and when I put the key into the start position to crank it nothing happens. No clicking or sounds that make me think it is trying to turn...

Check your battery cables. Remove them and clean the contacts, if the ends are replacements take them apart and clean. Use a wire brush or sand paper. Make sure you remove the negative first and reinstall it last. Also check the battery and fuse links. Your problem is in there some where the battery, cable ends, cables, or a fuse link. If still no start let me know the results and we can go from there if need be.

Sep 20, 2009 | 2006 Jeep Commander

1 Answer

05 grand cherokee with hemi won;t start.

Does it turn over? If not, try disconnecting the battery and reconnecting it. This has worked for my Jeep before.

Jul 06, 2009 | 2005 Jeep Grand Cherokee

1 Answer

06 commander that has full power(all dash lights are on)but just clicks one time when trying to start

Dash lights draw so little that you could nearly run them with a couple of good flashlight batteries...Your starter draws more amps than anything else in the car. Check your battery connections and clean them. check actual battery voltage to make sure you have at min 12v. After making sure you have good power check power at the starter main terminal, starter relay and small wire on the starter (should have 12v when key turned to "start". If you still have a problem after testing post back.

Apr 24, 2009 | 2006 Jeep Commander

Not finding what you are looking for?
2006 Jeep Commander Logo

Related Topics:

317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides