Question about 2005 Dodge Magnum SE

Open Question

How to fix my 2005 dodge magnum when it's misfiring and i have already did a tune up

I've changed the plugs but not the wires and the oil and it was saying the first cylinder war misfiring and i changed that

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 512 Answers

SOURCE: Cylinder Layout V8 5.9 L Magnum Dodge

drivers side plugs from front of engine to rear are cylinder numbers 1...3...5...7
passenger side front to rear 2...4...6...8..
fiing order 1..8..4..3..6..5..7..2..

Posted on Sep 26, 2008

Ad
  • 34 Answers

SOURCE: misfire on #6 and #8 cylinder 1996 Dodge Ram 1500

Check the spark plug wiring . There are several places where the wires cross each other. These wire cross points MUST be at right angles to each other. Or you will have a misfiring problem.

Posted on Jul 07, 2009

  • 84 Answers

SOURCE: can you drive a car with a third cylinder misfire?

yeah ive had to do it

Posted on Oct 04, 2009

emissionwiz
  • 76848 Answers

SOURCE: Misfire cylinder 5 2000 dodge dakota

when u press the gas pedal to go this opens the throttle valve, the idle speed of your engine is computer controlled, this is done by the ISC (idle speed control) airbypass valve, these parts get full of gunk and then get a stalling problem at or near idle, clean them by doing the following, if u don't understand the instructions seek help from your friend.
, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Posted on Nov 23, 2009

wracefans24
  • 1985 Answers

SOURCE: i have a 2005 dodge magnum, an the iol light

try replacing the oil sending unit first,
it tells the gauge on your dash how much pressure you have,if your light comes on it means you don't have oil pressure,so change the sending unit to see if this takes care of it,

Posted on Dec 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 dodge magnum R/T keeps reading random misfire


if it's a shudder feel during shifts it's most likely the torque converter and/or a flash update

Mar 02, 2015 | 2005 Dodge Magnum RT

1 Answer

2000 dodge durango


Same cylinder all the time? What brand of spark plug did you put in? Have you cleaned injector connection? If spark plug and wires are known good, injector and connection would be next. Did you erase code after other work done?

Jun 10, 2013 | Dodge Durango Cars & Trucks

1 Answer

Hey Todd I have a 2005 5.7 dodge magnum and it won't change gears as i speed up while driving also speedometer stopped working


EASY ONE.... Your VSS (Vehicle SPEED SENSOR) stopped working and it is this Sensor that gives the PCM/ECM the information to change gears. Once you change your VSS, and get it working, the Transmission will start working again...

I am Assuming that the Transmission stopped working at the same time the Speedometer did? Is that right?

If it is, then this is a easy fix. 1 bolt and one Wire Connector and DONE....

Apr 04, 2013 | 2006 Dodge Magnum

1 Answer

Dodge Neon Won't Stop Misfiring


Check the timing belt for excessive wear.

Feb 14, 2013 | 1996 Dodge Neon

1 Answer

1992 f150 is misfiring when it is idelling.


I had this same thing happen under the same circumstances with a 1993 GMC Sonoma truck. I'm sure you've probably already checked this, but those new wires will sometimes pop off or loosen after a day or two when first installed. That's what happened with one of my new wires, and all that had to be done was to snap it back on securely. Misfire problem gone. Good luck with yours!

Nov 19, 2012 | Cars & Trucks

1 Answer

How can I fix the P2302 code problem in my 2005 dodge magnum 2.7 liter


I have the SAME exact problem and my maggy is a sitting duck. let me know if you find a solution

Nov 11, 2012 | 2005 Dodge Magnum SE

2 Answers

Hooked up computer to dodge ram 1500 4.7 liter magnum code came up p300 p301 what does this mean


P0300 is the random misfire code. P0301 is the misfire code for Cylinder #1. When was your last tune up? non platinum spark plugs should be replaced around 30-60k along with the wires. With platinum plugs that extends out to 100k. I would try a tune up first plugs and wires. Reasonably cheap fix that is a prevenitive maintenace item anyways. If you have just recently had a tune up or it does not solve your problem you most likely have a bad coil pack on cylinder#1.

Hope This Helps.

Zeppelinx12

Mar 16, 2011 | 2004 Dodge Ram 1500

2 Answers

After my 2005 dodge magnum sits (lets say overnight) it runs rough and produce white smoke. After several minutes the smoking and rough idling stops. What causes this and what price range to get it fixed


White smoke is a sign of water/condensation (due to the coolant additive)......worst case scenario, you have a head gasket leak (minor at this stage), or you simply need a tune up......as white smoke on cold start up could be normal...has it just started happening, or have you only just started noticing it ???

When was the last time it has been serviced (plugs, oil etc)

Oct 12, 2010 | 2005 Dodge Magnum

1 Answer

I have a 2005 dodge magnum, an the iol light started comin on wen i am parked, wats causing that, i already had oil changed.


try replacing the oil sending unit first,
it tells the gauge on your dash how much pressure you have,if your light comes on it means you don't have oil pressure,so change the sending unit to see if this takes care of it,

Dec 30, 2009 | 2005 Dodge Magnum

1 Answer

2005 magnum does not want to shift sometimes.


Change plugs and wires to start with.

Aug 23, 2009 | 2006 Dodge Magnum

Not finding what you are looking for?
2005 Dodge Magnum SE Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...