Question about Nissan Cars & Trucks

Open Question

Nissan navara key fob - Nissan Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Gypsybaron
  • 80 Answers

SOURCE: driver door won't lock with key fob

Check the locking solenoid / actuator in the door behind the panel, could be burned out or loose wire. It should take about 20-30 minutes to open, fix it and close the door panel if there's no major problem. Autozone might be able to help out with a solenoid.

Posted on May 17, 2009

alicantecoli
  • 22095 Answers

SOURCE: 2002 Nissan Navara will not start after changing battery

dealer only to reset factory immobiliser

Posted on Jun 20, 2009

  • 4793 Answers

SOURCE: How do you program a key fob / transmitter for a 2009 Altima?

all keys/car have to be programmed at the same time.using nissan diagnostic machine.you could try a quickfit centre (if they have correct machine)

Posted on Feb 17, 2010

chris bean
  • 61 Answers

SOURCE: nissan navara 2006 blown hole no1 piston 16000kms

do you have a hole in the piston or gasket? If in the piston it is most likely from coolant or water. If water, could be a cracked head, or being sucked in through the intake and building up in the 6th cyl. I have a lexus that had a hole in the side of the motor and noon could figure out why. I pulled the head and found water... Put new block in and egr codes came up. Pulled EGR and found it was sucking in water, due to an exhaust leak that was allowing condensation to build and would not blow out once in the egr tube. If you face the same problem (hole in block) I am going to say too much compression. Could be from head gasket not being torqued properly and leaking cooland, cracked head, or wrong spark plugs-and worst case scenario which I have yet to witness, bad spark plug gap. Not likely on your car, i would think.

Posted on Mar 29, 2010

  • 1 Answer

SOURCE: 2007 Nissan Navara Service ligth reset.

You will need to send the navara workshop it needs to be hooked up to a special computer to be reset.

Posted on Mar 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan navara 2002 twin cab diesel zd30 malfunction light comes on randomly


NISSAN NAVARA questions and answers

www.roadtestreports.co.uk/vans/nissan/navara/qanda/
Results 1 - 40 of 322 - Ask and answer questions on a variety of NISSAN NAVARAmodels. Help and advice ... Have a Navarra Rally Raid 2004 double cab pick up. ... Navara V6 2011 - loss of power & engine management light on. .... ZD30 I have changed the diesel filters after noticing that it's jerking when I'm on full throttle.

Nissan Patrol GR Y61 ZD30 starting problem - YouTube

? 1:23
https://www.youtube.com/watch?v=JxHKfYDCgFQ
Jan 16, 2013 - Uploaded by sspyropoul
After replacing the diesel filter seals and water trap i had no problem .But you ... They still glow for like 15 ...Missing: twin ‎cab ‎randomly

Nissan D22 Navara receives YD25 2.5-litre diesel

www.themotorreport.com.au/.../nissan-re-power-their-d22-navara-range
Jan 31, 2008 - Nissan's popular Navara D22 workhorse range has been ... On top of the 4x4 DX single cab's equipment, the dual cab ST-R adds .... the yd25 engine have a overheating problem, so how comes nissan is ... I believe it is a ZD30 engine. .... with no problems except a cracked injector line (pretty random fault).

Jan 13, 2016 | Nissan Cars & Trucks

1 Answer

I want to copy the old keys information to new blank key for my Nissan Nissan navara outlaw 2006, which tool and where i can get it ?


Hi you need a main dealer or an Autolock Technition the required equipment will cost big bucks. Regards Jim...

May 05, 2015 | 2006 Nissan Navara 2.5

1 Answer

After replacing the battery on the 2006 navara the remote key does


you need to re-pair the key fob to the car turn ignition to 2 and press the fob the doors should lock. press again and it should un lock it is then paired to the car again.

Jan 17, 2014 | Nissan Cars & Trucks

1 Answer

My nissan navara 2054 model will not start got in it one day would'nt start


turn the key to acc with your radeo off and with door open and listen for the fuel pump in the gas tank. it will buzz. if not check all your fuses relays and if there good it could be your fuel pump

Mar 17, 2012 | 2005 Nissan Pickup Navara

1 Answer

Just bought a 2003 Nissan Navara 2nd hand. Has central locking but no remotes were handed with it, how can i find out if this vehicle has remote central locking or not


The remote should be built into the key. If not the remote central locking would be after-market. After-market remote central locking is part of an anti theft device so the fob you get with the key's has two function's it opens the door and disables the imobliser. If it had a fob and it was'nt with the key's then the ignition would'nt work so the car would'nt start. So it dosent have remote locking. Before giving up check the dash and suround's for a small either green or red light which looks like it was installed after-market if their is one then it still may have remote locking but was disabled for some reason but although it is there unless you really need it don't bother with it because you will need to get it rewired then get a fob which will need to be programed. Hope this help's Cheer's

Sep 12, 2009 | 2003 Nissan Frontier Crew Cab

2 Answers

2007 Nissan Navara Service ligth reset.


You will need to send the navara workshop it needs to be hooked up to a special computer to be reset.

Jun 09, 2009 | 2005 Nissan Pathfinder

1 Answer

Cental locking making 'clunking noise'


might just want door trim taking off and everything given a good squirt of engine oil.No wd 40 or spray stuff it dries out too quick

Feb 28, 2009 | Nissan Pickup Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...