Question about Honda CR-V

Open Question

How to remove a 2003 Honda CRV driver side kick panel

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 64 Answers

SOURCE: removing inside door panel from drivers side of 1999 honda civic

two philips screw on the handle ( the one u use to shut the door), one on the far right handside in the middle, one in the other handle ( the one u use to open the door with), after u removed all the screws, put a flat screwdriver at the bottom of the panel and pull it off.

Posted on Feb 18, 2009

  • 333 Answers

SOURCE: Replace Timing Chain for 2003 Honda CRV?

Rule of thumb this is a timeing belt and it should be changed every 75,000 mile as a general practice. I hope this helps, dont forget to rate my answer, thanks

Posted on Feb 20, 2009

  • 691 Answers

SOURCE: My 2003 Honda CRV ...drivers side door does not

you may need to replace the door locking actuator, they do tend to go bad over times. does the driver side door lock automatic when using the lock button on the driver side. if you can lock and unlock the driver side door with a switch, my guess would not be the locking actuator, it might be in the remote locking module.

Posted on Sep 30, 2009

Testimonial: "Thanks for the help. everything relates back to the actuator.."

  • 1 Answer

SOURCE: Honda crv 2003 2.0 litre auto

I had that problem on my 2004 crv, I was told it because the crv is not shifting into gear (overdrive). Cost me over $200 to fix it.

Posted on Jan 30, 2010

  • 162 Answers

SOURCE: 2003 honda civic how to remove door panel

Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.

Pop out the door handle, and unplug the power lock plug,

Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.

next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)

Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)

Unplug power window connector (big green plug)

Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Honda CRV driver side mirror glass jiggles a lot while driving.


Need to remove glass and apply glue to back side,the old glue has let go causing it to vibrate.

Aug 04, 2015 | Honda Cars & Trucks

1 Answer

Instrument panel on 2003 Honda CRV starts flashing when headlights are on


Have had a similar experience with my 2000 Ford Windstar. The extra load added by turning on the headlights affects the instrumentation power feed. The illumination flickers and the gages go crazy. Your 2003 CRV may have its original battery which is near death. It took me four batteries to stabilize things and I still get the flickers at night sometimes

Apr 13, 2013 | 2003 Honda CR-V

1 Answer

2003 Honda CRV "Door Lock Control" -- where is it located ?


Electronic Chassis Control Module remote door lock module located in the drivers door. Black about the size of a pack of cigarettes.

Feb 15, 2012 | Honda Cars & Trucks

1 Answer

Taillights


Have you checked the fuse for the tail lights which should be located on the side of the dash behind an access panel on either the drivers side or passengers side. If you open the door you should see the panel.

Jul 13, 2010 | 2003 Honda CR-V

1 Answer

Removing a 03 crv headlight assembly


After much research, and little info on "how-to", I replaced both stock 9006 low-beam bulbs on my 2004 Accord. Despite much info on removing fenderwell splash shields, I was able to open the hood, and reach the passenger side harness, remove plug, twist and remove bulb and reinstall- no problem. Driver's side required removing the battery, but same procedure. No problems, no cuts or bruises. Owners manual is unclear, Hayes 2003-05 Honda Accord repair manual is wrong, and the dealer charges $29.95 per bulb installed. Took me 10 minutes. Tried to save the radio settings with a 9V battery in the power plug (memory-saver) but that didn't work."

Good luck.

Oct 16, 2009 | 2003 Honda Pilot

1 Answer

My 2003 Honda CRV ...drivers side door does not lock with fob. All other doors lock. When I lock the drivers side door with the key, it won't unlock with the fob.


you may need to replace the door locking actuator, they do tend to go bad over times. does the driver side door lock automatic when using the lock button on the driver side. if you can lock and unlock the driver side door with a switch, my guess would not be the locking actuator, it might be in the remote locking module.

Sep 30, 2009 | 2003 Honda Civic

2 Answers

I have a 1995 Honda CRV - japanese import. I


A fuse box will be in one of the following places depending on car and model:

  • Part of the lower dash (near knees) (driver or passenger)
  • On the side of the dash where the dash meets the door (driver or passenger)
  • The kick panel right beside the door (driver or passenger)
  • Part of the main console near your feet (driver or passenger)

Aug 26, 2009 | Honda CR-V Cars & Trucks

1 Answer

My 2003 honda crv right front lock is not working and needs to be replaced, How do I remove the current lock?


remove the door panel and the lock should have a screw or pin holding it in from the back side. The door panel removes with mostly snaps and a few screws...If you have to use a lot of force, there is something you're missing...broke a few plastic parts in my day. I'd go buy the part first and look at it to determine what you will be looking for after getting door panel off...good luck!

Aug 21, 2009 | 2003 Honda CR-V

1 Answer

2003 honda crv. how do i remove light bulb cover


you have to go under the bumper and and look behind then look for the back of the lightbalb connection. if you see that. pull on it carefully. if rusted, spray some wd forty on it but make sure you dont get the wires with the wd forty

Aug 04, 2009 | 2003 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...