Question about Nissan Pathfinder

Open Question

Code p1275 on a nissan primera diesel

When driving along i have no power at all.it is the 2.2 dci

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: nissan primera gearbox

how much is the price for nissan primera 2003 gear box

Posted on Jan 14, 2009

rockitman187
  • 2559 Answers

SOURCE: engine 2.2 dci

Yes the bare blocks are the same.

Please rate this solution.

Posted on Jan 16, 2009

  • 31 Answers

SOURCE: wath is Wheel size for nissan primera 2.2 dci

jus look at the wheels you have at the minute and on the outside arch it will say the size if not i think they are 185-65HR13 but i am not 100% so dont fully trust that size that is roughly what they are if not excact :) hope i helped

Posted on Oct 21, 2009

  • 262 Answers

SOURCE: Driving along today and the engine on my Nissan

check your fuel pump it works on and off

Posted on Nov 14, 2009

sandman357
  • 236 Answers

SOURCE: nissan primera is not starting and not sending

does it crank? if so don't try to start it. turn the key to the on position and listen carefully. if you hear a buzz then it's not the gas pump. it could be your regulator or your filter may be clogged. but that depends on the cranking and the pump

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I drive a 2003 Nissan primera S 1.8 petrol, I have low power at high speed. what is might possibly be the problem


Ignition modules have two sections -- one for low rpms, one for high. Could also be clogged air filter, converter, muffler, low fuel pressure, speed sensor.

Jan 15, 2015 | 2003 Nissan Primera

1 Answer

Hi Not the Clocks but the Dash Panel inc Sat Nav etc on my Nissan Primer 2.2 Diesel 03 does not come on. It did, just parked it up & overnight doesnt power up. Can you help. also have a code reader but...


look under dash below steering wheel or plug could be in glove compartment but its under the dash somewhere just look for a plug that looks like an old printer plug should be 2 to 3 inches wide or might be under hood also just have to look for it if ya have owners manual it should show where plug is

Jan 03, 2014 | 2003 Nissan Primera

1 Answer

How to reset service light on nissian primera 54 plate diesel


try turning ignition to accesories and hold down trip meter reset button for ten seconds this works on some makes of cars.

Nov 13, 2013 | Nissan Primera Cars & Trucks

1 Answer

Nissan pathfinder 2004 turbo diesel trouble code p1275


This answer is coutesy of expert ZL Limited

DTC P1275 - Acceleration Position Sensor 1 Circuit Malfunction
The acceleration position (AP) sensor circuit provides a voltage signal relative to acceleration pedal angle. The acceleration pedal angle (AP1) will vary about 13% at idle position to about 87% at wide open throttle (WOT). This code detects a continuous short to ground or high in either the circuit or the sensor.

9_4_2012_8_23_06_pm.gif
Conditions for setting the DTC:
* The Ignition is "ON".
* The acceleration pedal angle is less than 2.5% or more than 97% for 12 counts within 500 test samples (15.6 m sec ).

Action Taken When the DTC Sets:
* The PCM will store condition which were present when the DTC was set as Freeze Frame and in the Failure Records data.

Conditions for Clearing the MIL/DTC:
* The PCM will turn the MIL "OFF" on the third consecutive trip cycle during which the diagnostic has been run and the fault condition is no longer present.
* A history DTC P1275 will clear after 40 consecutive trip cycle during which the warm up cycles have occurred without a fault.
* DTC P1275 can be cleared using the Tech 2 "Clear Info" function or by disconnecting the PCM battery feed.

9_4_2012_8_23_55_pm.gif

Diagnostic Aids
An intermittent may be caused by the following:
* Poor connections.
* Mis routed harness.
* Rubbed through wire insulation.
* Broken wire inside the insulation.

Check for the following conditions:
* Poor connection at PCM-Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection.
* Damaged harness-Inspect the wiring harness for damage. If the harness appears to be OK, observe the APP sensor 1 display on the Tech 2 while moving connectors and wiring harnesses related to the sensor.

A change in the display will indicate the location of the fault. If DTC P1275 cannot be duplicated, the information included in the Failure Records data can be useful in determined vehicle mileage since the DTC was last set.

If it is determined that the DTC occurs intermittently, performing the DTC P1275 Diagnostic Chart may isolate the cause of the fault.

9_4_2012_8_24_46_pm.jpg
Referential sensor location.

Sep 04, 2012 | 2004 Nissan Pathfinder

1 Answer

Nissan Almera DCI 1.5 diesel, Whilst driving engine developed a loud rattle, bit like a machine gun, this noise lasted for about 2 miles then faded away, any idea what caused it ? Please reply to ...


diesel ?? hmmm thinking here as without hearing the noise then its difficult to say ,it could have been diesel knock caused by petrol in the tank ,lack of oil for whatever reason or a bad case of water in the air filter and without more facts i have absolutely no idea

Feb 15, 2011 | Nissan Altima Cars & Trucks

1 Answer

Would like to buy a workshop manual for nissan primera diesel se td


http://www.classic-spares.net/CD%20Info/Nissan_Primera_P12_Workshop_Manual.htm
http://www.heroturko.org/n/nissan-primera-service-manual-p11/
http://www.manual-car.org.ua/en/showthread.php?t=1647&page=1
I'm not sure which model or year you have but one of these sites should be able to help you. Good Luck!

Jan 09, 2011 | Nissan Hardbody Cars & Trucks

1 Answer

How to reset service reminder nissen primera 04


for most maxima's .. hold the trip counter in when you turn on the ignition .. a few models have a little rubber cork that you remove .. that exposes a push button ..

Aug 11, 2010 | 2004 Nissan Maxima

1 Answer

Wath is Wheel size for nissan primera 2.2 dci


jus look at the wheels you have at the minute and on the outside arch it will say the size if not i think they are 185-65HR13 but i am not 100% so dont fully trust that size that is roughly what they are if not excact :) hope i helped

Oct 21, 2009 | Nissan Se R Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...