Question about 2005 Hyundai Accent

Open Question

P2906 code in 2005 Hyundai Accent

If not gas cap, what is likely the cause?? Car runs same but has been bit louder past 3 months...??

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 65 Answers

SOURCE: Hyundai 2001 Accent Code - P0130

I think this is the O2 sensor - It will run fine but you might notice your gas mileage slipping and will not pass emissions.

Posted on Aug 07, 2008

  • 1 Answer

SOURCE: hyundai accent stops running after heats up

I had the exact smae problem and threw aaway a ton of money on bad "guesses" at what was wrong. The actual fix was replacing the crank shaft position sensor for 50 or 60 bucks. Swapped out bad for good and cars has run great every day since.

Posted on Jan 15, 2009

  • 31 Answers

SOURCE: 2005 Hyundai accent overheating, radiator

A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.

Posted on Apr 22, 2009

ghost4548
  • 776 Answers

SOURCE: 2005 HYUNDAI ACCENT ERROR CODE 0340 AFTER TIMING BELT REPLACEMENT

Here's what the shop manual says.

ef0163d.jpg
7a00d7b.jpg

Posted on Jun 28, 2009

omaromid
  • 332 Answers

SOURCE: Can't get gas into my 2002 Hyundai Accent.

The reason the gas station pump shuts off is when the fuel reaches the tip of the gas nozzle, so when you are filling your car and the gas nozzle (gas stations pipe) keeps shutting off it means that the pipe that runs to the gas tank is not open completely, what happens is when you pump the gas in the car the supply pipe from the gas tank opening to the tank fills up quickly and this causes the gas station pipe nozzle to shut off, have some body take down the gas tank and have a look at the gas tank opening and also gas supply pipe that runs from the gas filler opening ( on the car body) to the gas tank. Have a look at it and please don't forget to rate the answer if it was helpful, thanks!

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Hyundai accent and the engine light


get the OBD codes read to point to the component/sensor at issue may just need the codes resetting

Oct 19, 2014 | 2003 Hyundai Accent

1 Answer

2005 hyundai accent won't go in reverse


Sounds like a blockage in the exhaust system. A quick fix at a local garage

Oct 28, 2012 | 2005 Hyundai Accent

1 Answer

I have a code of PO456 Hyundai 2007 Accent


This tends to be a Fuel cap seal, when getting fuel be sure to tighten the gas cap at least three clicks. Any parts store should be able to reset the service engine light, if the light persists, remove your negative battery cable for 30 seconds with the ignition turned to the run position. replace negative battery cable and and the code should be gone. This resets your cars computer. Be aware that this also rests the Drive Learn program, and the car will take 10-15 miles to reset this, it may run a bit rough during those 10-15 miles but should clear up afterwards.

May 11, 2012 | 2007 Hyundai Accent 1.6

1 Answer

I have a 2000 Hyundai Accent, the check engine light came on after getting gas. The car is running fine.


More then likely it's going to be an evap code, check your gas cap make sure it's on right, also go by any auto parts or autozone where they can pull codes for free, and get back with us here at FixYa so we can help you diag. your trouble code.

Jun 29, 2010 | 2000 Hyundai Accent

3 Answers

Error code p1403


p1403 is a problem with the DTML sensor ... thats associated with the charcoal canister ... that is often caused by putting too much gas in the tank (overfilling) ... gas gets into the charcoal canister and contaminates it .. you could also have a bad sensor .. there are two .. one on the throttle body the other on the engine .. sometimes the wiring going to these sensors gets corroded or damaged .. contamination in the canister may clear itself in time if you avoid overfilling ..

Mar 19, 2010 | 2001 Hyundai Accent

2 Answers

Car will not start after refilling the gas tank on a 2003 Hyundai


sounds like you have a bad vent on your gas tank
next time try leaving your gas cap off after you fill and try and start then
if this works just drill a vent hole in the gas cap
or change the tank vent filter

Dec 31, 2009 | 2003 Hyundai Accent

1 Answer

2004 hyundai accent. trouble filling gas tank


I have a 2005 Hyundai Accent, It is not possible to fill the tank if you are letting the petrol pump run at full speed.Trying to fill up quickly it will only build up pressure and cut off. Next time you fill up just pull the petrol pump handle half way, it will take longer to fill but you wont get the blow back. Modern petrol pumps are getting quicker all the time.Hope this helps you.

Mar 23, 2009 | 2005 Hyundai Accent

2 Answers

P0441 EVAP Emission Control System Purge Flow Fault 2001 Accent


It is always best to start simple on a lot of these things. This code indicates that somewhere in the evaporative system you have a leak that has set off the code. The gas cap is the most common culprit and that is where I would start. Buy a new gas cap and put it on. It may and should solve your problem. A lot of gas caps have rubber seals that do wear out over time. If this does not solve your problem simply use a search engine and type in p0441 a wealth of information will pop up. There are other possible causes and solutions but that's where I would start (with the gas cap)

Dec 09, 2008 | 2001 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...