Question about 1998 Buick LeSabre
I found the first one bolt but i can't locate the second one so can someone plz help
Remove the plate, then remove all the screws on the silver plate that is behind the license plate itself. There should be 4 other screws to remove. Once you have done this, open your trunk and partially remove the carpet behind the trunk etc--------------------------------------------------------------------------
Car Key Programmer
Posted on Dec 05, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove the battery terminals and clean them real well and tighten them back on the posts. If you have a bad connection here, you will get the problem you described. When you are done, go ahead and put your starter back in. While you are down there, check the voltage on the thick wire supplying battery voltage to the starter make sure it is 12V. Try to start the car and get back to me.
Posted on Jan 20, 2010
Your fuse box is located behind the right side of the dash,to the right of the glove box.Here is a diagram to better expalin.If you need anything else,let me know. Thanks,Chuck.
Posted on Mar 10, 2010
Testimonial: "thank you chuck very much worked great now if you can help me with my radio. posted you are great"
not exactly sure but using info below you can find it.
Remember the flow for the a/c system is :
1. From the compressor a high pressure (HP) gas goes to the condenser in front of the radiator.
2. From the condenser a HP liquid goes to an expansion device (orifice tube or expansion valve)
3. From expansion device the low pressure gas enters the firewall to the evaporator.
4. From evaporator the low pressure liquid/gas mixture goes through the dryer back to the compressor suction.
There will be about a 1" nut on the low pressure line between the firewall and the compressor. Remove nut and on the male side use a pair of kneedle nose pliers and remove orifice tube. Note orientation of tube.
Replace tube, reassemble, evacuate air from system, recharge with freon.
Posted on May 29, 2010
Tips for a great answer:
Sep 28, 2014 | 1998 Buick LeSabre
Jul 17, 2012 | 1994 Buick LeSabre
Apr 02, 2012 | 1998 Buick LeSabre
Mar 15, 2010 | 2000 Buick LeSabre
Mar 11, 2010 | 1992 Buick LeSabre
Mar 06, 2010 | 1992 Buick LeSabre
Sep 08, 2009 | 1997 Buick LeSabre
Apr 05, 2017 | 1998 Buick LeSabre
49 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: