Question about 2005 Audi A4
Bought the replacement part but not sure how to install
To replace your motor mount, you need to disconnect your motor mounts, hoist/jack up the engine, and replace the mount itself.----------------------------------------------------------------------------------
Car Key Programmer
Posted on Dec 05, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Audi 2001 Speaker
So, I dealt with this problem on my own. It would have cost me over $350 to change a stinking bose speaker in my A4, instead, it cost my $62.50 and a saturday afternoon.
Here were my symptoms:
On really cold mornings or days, my passenger side front door speaker would crackle, not exactly blown per se, but it was really annoying, making me adjust my balance 100% to the right side. But, when it warmed up a little later in the day, the crackling would go away. I'm guessing this had something to do with expansion and contraction due to heat, or lack thereof.
Here's what I did:
I called around and found out that you can buy replacement speakers from the audi parts shop at your local dealer... they said it would cost $178.00 for one speaker! I understand it's Bose, but come on, it went defective on me. So, just like you said, I checked ebay. I was able to get, not one, but two used replacement speakers for 60.00. But I was concerned about dismantling my door panel. I've been in a lot of cars where the interiors rattles because of custom or even professional installation jobs. I didn't want to lose my wonderfully noise free interior in my car. I figured I need some directions: I checked the internet and found this site: carstereoremoval.com. What do you know? They give you simple step by step instruction on how to remove a door panel on a 2001 A4. It cost me $2.50 through paypal. So total, (besides the torque wrench), 60.00 + 2.50 = 62.50 vs. 350.00. That's a lot of beer money! Hope this helps someone else out.
Be forewarned: To replace the bose speaker you need a T20 torque wrench. I didn't have this and was caught having o drive to home depot without a door panel.
Posted on Aug 26, 2008
Very easy - the car is designed to have these parts as being removable for the timing belt service. Opening the car is called the "service position" and involves taking these parts nearly off the car. Use the link below (it's a link to a DIY procedure for doing the timing belt on the car) - it'll show you what to do in order to remove the front clip of the car and remove the core support and radiator.
Posted on Feb 10, 2009
SOURCE: Audi A4
Not sure if they've changed it but this is what i do for my 99 a4
First remove the screw in the handle pull, it should be next to where your fingers go.
Pull down on the black piece of plastic and remove the screw form the door
Then remove the screws on either end of the door, one near the door jam on top and one near the other side, same place.
Finally pull up then out and the door panel should come out
Hope that helps
Posted on Jun 17, 2009
For Diesel and also for Otto engines on 2004 Audi A4, this rpm sensor (impulse sender - crankshaft) is placed on the bottom left back side of the cylinder block. Please Rate my Response! Thanks!
Posted on Jun 18, 2009
Tips for a great answer:
Dec 08, 2010 | 2003 Audi A4 Cabriolet
on Jan 27, 2016 | Audi Cars & Trucks
on Jan 27, 2016 | Audi Cars & Trucks
Aug 07, 2009 | 2004 Audi A4
Aug 06, 2009 | 2003 Audi A4 Cabriolet
Jul 23, 2009 | 1997 Audi A4
Feb 18, 2009 | 2005 Audi A4
Feb 09, 2009 | 2000 Audi A4
Nov 25, 2015 | 2005 Audi A4
281 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: