Question about Cars & Trucks

1 Answer

Cheve tahoe 2004

How to locate the oil sendind unit and change it

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Most oil sending units on chevrolets are close tothe oil filter and usually has 1 or 2 wires.

Posted on Dec 05, 2012

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 124 Answers

SOURCE: oil pressure light keeps coming on 2004 pt

Go to the following website for directions on removing and installing the Oil Pressure Sender:

Hope you find what you are your looking for! Good Luck!
If you have any more problems let me know.

Thank you for using Fix Ya!

Don't forget to rate the overall satisfaction of this answer!

Posted on Jan 31, 2009

  • 126 Answers

SOURCE: Where is the oil sending unit located on a 2003 Chevy Tahoe 5.3 engine

its in the block behind intake manifold .

Posted on May 05, 2009

  • 75822 Answers

SOURCE: where is the oil pressure sending unit located on a 99 tahoe

at rear of engine, you need a special socket to remove it and it is very hard to get at.

Posted on Jun 12, 2009

  • 41 Answers

SOURCE: were is the heat actuator located

both are on passenger side of instrument panel drivers side actuator on bottom of heater case passenger on top of heater case

Posted on Nov 29, 2009

  • 75822 Answers

SOURCE: location of oil filter 2004 chevy tahoe

bottom rear of the engine near the bell housing of the transmission

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replacing oil sendind unit on 1988 plymouth colt E 1.5 where is it located on the engine ?

It should be on the engine block close to the oil filter. It will have one wire plugged into it. Use Teflon past on the threads of the new unit and do not over tighten.

Jun 02, 2017 | Plymouth Colt Cars & Trucks

2 Answers

Change oil sending unit 04 tahoe

It is located on rear of engine back by the distributor use to be. see attached pic

Mar 15, 2015 | 2004 Chevrolet Tahoe

2 Answers

How to clear the change oil message in the information center on a 2004 Tahoe

Reset the oil life monitor when the oil has been changed, use the following procedure.
1. Turn the ignition key to the RUN position.
2. Fully push and release the accelerator pedal 3 times within 5 seconds.
3. If the Change Oil Soon light flashes, the system is resetting.
4. Start the vehicle.
5. The oil life will change to 100%.
6. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.

Nov 27, 2011 | 2004 Chevrolet Tahoe

1 Answer

Where is the oil pressure sending unit located at on a 2004 chevey taho 6.1 litter v8?

Ok on a 2004 6.0 oil pressure switch is located on the back of the engine behind the intake more the driver side right next to the crank sensor, if you reach your hand behind the intake from the driver side it right in front of the transmission. It's a tight squeeze good luck

May 23, 2011 | 2004 Chevrolet Tahoe

1 Answer

My gas hand is bouncing up and down on my 1996 chevy tahoe

The sending in tank is deffective. The sendind unit has a arm on it with a float when gas is lowered or filled it pushes the float up or down a magnetic strip sends the info to the gas gauge on instrument panel. If the unit is defective it gives false readings. Hope this helps!

Mar 19, 2011 | 1996 Chevrolet Tahoe

1 Answer

Where are the oil drain plug and oil filter located on my 2003 tahoe so that I may change my own oil? any special instructions?

Here is a step by step video on changing the oil and filter on your Chevy Tahoe. It starts with a lot of safety information, but will quickly get into the process.

Jan 21, 2010 | 2003 Chevrolet Tahoe

1 Answer

How do i change the transimisson fluid in a 2004

There should a plug underneath the gearbox about halfway along it. Itshould be about 17mm and remove that and the oil will flow out and get rid of the metal shavings on the plug as it is magnetic.


Aug 25, 2009 | 2004 Chevrolet Aveo

1 Answer

Oil pressure gauge at 80

your oil sending unit is bad, replace the sending unit and should fix it, the unit shorts out and maxes out the gauge, hope to help you,

Jul 08, 2009 | 2004 Chevrolet Tahoe

1 Answer

Transmission wont shift out of park

Try checking the brake light sending unit. Are your brake lights even working. Many newer vehincles will not shift out of park unless the brake pedal is depressed. However, a faulty sendind unit located on the pedal itself can keep you from moving anywhere. Just check to see if your brake lights are working to know if the sending unit is working.

Apr 30, 2009 | 2004 Mercedes-Benz Mercedes Benz S Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides